砾岩储层精细描述中标准测井资料的应用

克拉玛依油田七区的标准测井资料是指使用标准电极系视电阻率测井、自然电位测井和井径测井,以相同的1:500深度比例尺及相同的横向比例进行测井作业所取得的资料.这种资料本来并不具备定量解释储层孔隙度和含油饱和度的能力,但这种资料占该区测井资料总量的比率高达34%.利用标准电极系视电阻率资料和岩心分析资料建立了视电阻率-岩性图版,利用自然电位减小系数α和岩心孔隙度分析资料φ建立了α-φ图版,根据综合测井资料求出标准测井视电阻率校正系数,进而确定了饱和度计算方程的参数.与相应的综合测井资料计算结果相对比,用该方法得到的孔隙度平均绝对误差及相对误差分别为1.85%和11.88%;含油饱和度平均绝对误差及相对误差分别为9.08%和24.75%.将该方法有选择地应用到该区砾岩储层精细描述研究中,弥补了缺乏综合测井资料无法进行测井储层评价及参数研究的缺陷.     

Judgment: The Foundation of Professional Success.

Lists of core competencies or critical capabilities are popular and plentiful. This article makes the case that a single core competency or critical capability accounts for professional success: the exercise of judgment. Judgment is the critical determinant of the quality of professional decisions, actions, and evaluations. Practical models of judgment are presented. The elements and dynamics of judgment are detailed. Individual, group, and organization implications are explored. Coaching and consulting interventions are explained. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

蜂窝移动通信系统核心网络的演进与全IP核心网络

分析了现有移动通信网络存在的问题，阐述了第2代移动通信核心网向第3代移动通信核心网演进的必然性：讨论了第2代移动通信核心网向第3代移动通信核心网演进所采用的演进策略，介绍了两种可供选择的全IP核心网络的参考结构。     

汽车发动机电机铁芯用钢(ADW2)的研制开发

鞍钢研制开发的汽车发动机启动电机用钢是针对汽车电机铁芯用钢（定、转子）而开发的电机钢类产品。介绍了该产品的研制过程及规格、特点。通过批量试制及装机试验，产品巳满足用户的使用要求。     

低速爆轰管对黑火药的点传火性能研究

文章采用中心点火管结构的实验装置研究了黑火药的点传火性能。用低速爆轰 (L VD)中心点火管来点燃黑火药时 ,1# ～ 3# 大粒黑药的传火速度为 70 0 m· s-1～ 80 0 m· s-1数量级 ,燃烧波宽度在 3.1ms～ 3.5 ms,最大压力峰值 :1# 为 36 .4 MPa,2 # 为 2 4 .0 MPa,3# 为 38.0 MPa。用普通中心点火管点燃黑火药时 ,2 # 、3# 和钝化 2 # 大粒黑的传火速度分别为 6 1.2 m· s-1、6 8.2 m·s-1和 4 0 .1m· s-1,最大燃烧波宽度分别为 9.2 ms、6 .3ms和 9.5 ms。燃烧波表明 ,L VD中心传火管与普通中心传火管相比较 ,在传火管的不同位置处 ,前者的 P- t曲线一致性远高于后者。     

Two dimensional deformation characteristics of bloom CC with liquid core reduction

A two-dimensional model was applied to simulate the liquid core reduction(LCR) technology of bloom CC using ANSYS software.The deformation characteristics of bloom under different liquid fraction and reducing amount are obtained.The results indicate that the main deformation condition of bloom shell is compressive strain,mainly undertaken by the liquid core,which increases with the enhancement of reducing amount.Solidified shell takes minor deformation.The longitudinal section of bloom appears sunken and the narrow side bulges,which grow serious when the liquid fractionincreases.     

砂岩油藏注水井深部酸化技术

吐哈油田长期注水开发后,注入水外源性伤害和地层内源性伤害不断在地层深部累积,采用常规酸化措施效果不理想。为此,通过长岩心污染模拟实验,研究了深部污染的污染特征及酸化解堵机理,通过解堵液缓速和工艺过程的综合应用实现深部解堵。应用AcidGuide专家系统对单井进行全面的污染诊断分析,并进行了参数优化设计,形成了适应吐哈油田深部酸化解堵的技术体系,现场应用取得良好效果,为类似低渗透油藏水井增注措施提供参考。     

高温高压下多种气体在储层岩心中吸附等温线的测定

利用自行研制的XF1型高温高压气体吸脱附测试仪,结合一台色谱分析仪(HP6890),一套抽真空系统,分别测定了N₂、CH₄、C₂H₆、C₃H₈、nC₄及其混合气体在三个岩心中的吸脱附等温线共计42条(单组分30条,累计测试点516个;混合气12条,累计测试点203个),以及吸附平衡后混合气的自由气相组成、吸附相组成和各组分的吸附等温线各48条(累计测试点431个).测试的温度为50.5℃.实验结果表明:①储层岩心介质对烃类气体的吸附现象是客观存在的,不容忽视;②仅就测试所得的数据来看,如果忽略其它因素,可以初步估计,不考虑吸附的砂岩储层气藏的计算储量将比考虑吸附少5%以上;③岩心-气体吸附体系的吸附能力除受压力影响外,更受到储层介质、岩石成分、结构和物性性质的影响,除此之外,还受到多组分气体中重烃组分数目、摩尔含量等的影响;④多组分气体组分相对吸附量能有效地表征多组分气体中各组分气体的竞争吸附能力大小,依据这个指标可将五元多组分气体体系中各组分气体按其竞争吸附能力由强到弱排序为nC₄>C₃H₈>C₂H₆>CH₄>N₂.     

A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

论基于技术资本的核心创新能力

首先界定技术资本的概念，然后以“核心能力特征参量罗盘”作为指导，全面展开论述企业核心创新能力相应4方面的投资策略，最后，运用一个案例具体展示基于技术资本核心创新能力的提升经验。