一种基于抽取LMS的距离旁瓣抑制方法

在噪声雷达中，传统相关处理方法的距离旁瓣受到时宽带宽积的限制，在有限相关处理时间内得到的距离旁瓣较高，会造成微弱目标被强目标、杂波旁瓣淹没的现象。提出一种基于抽取最小均方（Least Mean Square,LMS）滤波的噪声雷达旁瓣抑制方法，将LMS滤波器的系数作为距离压缩结果，从而获取较低的距离旁瓣。对该方法的性能进行了理论分析，并通过数字仿真验证了算法的有效性和理论分析的正确性。     

基于平均飞行航迹的CCO减噪效用研究

近年来，通过优化飞行程序降低机场飞机噪声影响成为机场环境保护的重要研究方向。文章首先建立了基于飞机“噪声-功率-距离”数据的噪声计算模型，介绍了平均飞行航迹以及连续爬升运行(Continuous Climb Opera-tion, CCO)离场程序的相关理论，最后以大型国际机场为实例，使用飞机平均飞行航迹进行噪声预测，运用综合噪声模型计算出噪声影响面积并绘制噪声影响等值线图，比较了CCO离场相对常规的标准仪表离场(Standard Instru-ment Departure, SID)的降噪效果。结果表明，CCO离场程序可有效降低机场噪声影响，在高噪声级影响区域的降噪效果更佳。     

Adaptive investigation of the optical properties of polymer fibers from mixing noisy phase shifting microinterferograms using deep learning algorithms

In this article, an adaptive denoising method is suggested to accurate investigate the optical and structural features of polymeric fibers from noisy phase shifting microinterferograms. The mixed class of noise that may produce in the phase-shifting interferometric techniques is established. To our knowledge, this is an early study considered the mixing noises that may occur in microinterferograms. The suggested method utilized the convolution neural networks to detect the noise class and then denoising, it according to its class. Four convolution neural networks (Googlenet, VGG-19, Alexnet, and Alexnet–SVM) are refined to perform the automatic classification process for the noise class in the established data set. The network with the highest validation and testing accuracy of these networks is considered to apply the suggested method on realistic noisy microinterferograms for polymeric fibers, polypropylene and antimicrobial polyethylene terephthalate)/titanium dioxide, recoded using interference microscope. Also, the suggested method is applied on noisy microinterferograms include crazing and nanocomposite material. The demodulated phase maps and the three-dimensional birefringence profiles are calculated for tested fibers according to the suggested method. The obtained results are compared with the published data for these fibers and found to be in good agreements.     

火花放电原子发射光谱类型标准化校正方式的探讨

在国内,火花放电原子发射光谱分析广泛使用类型标准化进行方法校正。在国外,标准和文献中鲜见使用此方法的相关论述。类型标准化主要采用平移校正和转动校正两种方式,哪种方式更加合理也鲜见报道。国外设备类型标准化的默认设置优先采用转动校正方式,相关国内标准对最优校正方式的规定尚不明确,此默认设置的合理性有待探讨。实验选用低合金钢20CrNi2Mo、R407标准样品和不锈钢317L、0Cr18Ni9标准样品,引用国内相关标准,以正确度临界差为评判依据,模拟类型标准化样品和待测样品“十分接近”和“接近”两种情况下平移校正和转动校正的数据正确度。经数据统计分析,平移校正分析结果均满足要求,转动校正结果在“接近”情况下部分元素不满足要求。结合相关国家标准中元素含量范围和精密度数据进行分析,通过计算允许最大偏倚量并制作曲线图方式展开分析,得出如下结论:在满足文中类型标准化控制要点前提下,分析设置更适合于采用平移校正方式。     

基于Matlab的量子激光雷达稳频通信模拟系统设计

传统通信模拟系统设计较为复杂,导致模拟过程消耗能量较大,不能准确模拟稳频通信质量。因此,提出基于Matlab的量子激光雷达稳频通信模拟系统。由于振荡器是雷达形成初始信号源的基础,通过分析振荡电路与相位噪声,获得相位噪声函数与通信频率存在的关系;为确保通信过程的稳定,将准确性与稳定性作为信号质量的评价指标,并采用锁频环稳频技术计算频率偏移程度,根据PID控制算法控制频率,量子激光雷达稳频通信;利用Matlab确定激光器、探测器等硬件组成结构,通过时序与数字阵列的设置完成模拟系统设计。仿真结果表明所提系统结构简便、性能稳定,能够真实模拟出稳频通信的信号质量。     

应用于光遗传学的集成式注入型生物光电极器件的研究进展

光遗传学是一门涉及神经科学、光学、半导体光电子学及生物医学的交叉科学.把光作为一种遗传学的研究工具,可为神经科学研究提供更高效、精准的神经调控手段,也为临床精神疾病的研究和治疗提供了新的思路.集成式注入型生物光电极是一种集刺激神经元的光源与采集生物电信号的微电极于一体的多功能生物微探针,在利用活体生物进行的光遗传学研究中有着重要的应用.文章回顾了光遗传学的历史,对集成式注入型生物光电极器件的分类和发展进行了分析,详细比较了不同类型光电极器件在结构和性能上的差异,从电学特性、噪声信号、生物兼容性及可靠性等方面进行评价.最后,对光电极器件的未来发展进行了初步的探讨.     

Compositional design,structure stability,and microwave dielectric properties in Ca3MgBGe3O12 (B = Zr,Sn) garnet ceramics with tetravalent cations on B-site

Two garnet-structured Ca₃MgBGe₃O₁₂ (B = Zr, Sn) ceramics with tetravalent cations at B-site were prepared by conventional solid state reaction. The crystal structure, microstructure evolution, and microwave dielectric performance were investigated using X-ray powder diffraction, Rietveld refinement, scanning electron microscopy, Raman spectroscopy, and infrared spectroscopy techniques. Dense Ca₃MgZrGe₃O₁₂ and Ca₃MgSnGe₃O₁₂ ceramics were obtained at sintering temperatures of 1420 and 1400 °C, respectively. The dielectric constant, unloaded quality factor, and temperature coefficient of resonance frequency of Ca₃MgZrGe₃O₁₂ were 10.80 ± 0.2; 79,600 ± 1000 GHz (f = 12.61 GHz); and ?66.8 ± 1 ppm/°C, respectively, and the corresponding values for Ca₃MgSnGe₃O₁₂ were 9.68 ± 0.2; 83,400 ± 1000 GHz (f = 14.19 GHz); and ?57.9 ± 1 ppm/°C, respectively. The dielectric performances of the two ceramics were compared by analyzing the ionic polarizability, packing fraction, and bond valence. The intrinsic dielectric properties were predicted by fitting the infrared reflectivity spectra.     

基于归一化水体指数及其阈值自适应算法的水体遥感反演效果分析

归一化水体指数（NDWI）是水体遥感反演的一种重要指标，其阈值及修正直接影响反演结果的精度。基于Landsat-8与GF-1光学多光谱影像，使用归一化水体指数法阈值0（TH₀）、最大类间方差法（OTSU）自适应阈值（TH_otsu）与均值漂移聚类算法（Mean-Shift）自适应阈值（TH_MS）分别对典型正常水体、云雾覆盖水体、富营养化水体、高含泥沙水体进行水体遥感提取与效果分析，结果表明：正常水体以TH₀为阈值提取精度最高，THMS提取精度次之，TH_otsu提取精度最差；而云雾覆盖水体、富营养化水体以及含泥沙水体使用THMS提取精度最高，尤其少量云雾覆盖下的水体，TH_MS具有更明显的优势，TH₀提取精度次之，TH_otsu提取精度最差；对于不同的阈值，Land?sat-8比GF-1总体表现出更高的水体提取精度。Mean-Shift算法应用于NDWI阈值修正与水体遥感反演具有快速、水质适应性强、效果稳定的优势，对尤其是复杂条件下的水体信息遥感反演具有较好的提取效果。     

基于LP与小波包的复杂机电系统监测序列混沌降噪方法

针对流程工业生产系统监测数据存在强噪声和混沌性的特点,提出了一种局部投影方法(Local Projection Method)与小波包方法相结合的信号降噪方法。该方法先利用局部投影方法从动力学系统嵌入流形的角度进行多次迭代降噪,并根据关联维数来判定迭代终止;再利用小波包方法从频率的角度进行降噪,抑制高频噪声的干扰,取得了较好的降噪效果。用Lorenz时间序列进行仿真验证,对仿真时间序列加入不同程度的噪声,对比分析小波包、局部投影与该方法降噪后的相空间、SNR值和最大Lyapunov指数,证明了该方法对于中高强度噪声具有更好的降噪效果。并将该方法用于某压缩机组的实际监测数据降噪,评估三种方法的降噪效果,进一步验证了该方法的优越性。     

Stochastic stabilization and destabilization of nonlinear and time‐varying hybrid systems by noise

The aim of this article is to design a suitable strength function g(t,x,r(t)) such that the Wiener noise g(t,x(t),r(t))dw(t) either stabilizes or destabilizes a given nonlinear and time‐varying hybrid system . To this end, the basic properties, including the existence and uniqueness of the local and global solutions and the nonzero property of solutions of the nonlinear and time‐varying hybrid stochastic systems, are first investigated as the theoretical basis of the article. Second, two theorems and the corresponding corollaries on the stability and instability of the hybrid stochastic systems are established. Third, the design method for the noise strength g(t,x,r(t)) is then proposed based on the established theorems. We also point out that the Markov jump r(t) may have a stabilizing (respectively, destabilizing) effect when we design the noise strength g(t,x,r(t)) so that the introduced noise g(t,x(t),r(t))dw(t) stabilizes (respectively, destabilizes) the corresponding hybrid system. Finally, we illustrate our method using two examples. Compared with the existing literature, our method is suitable for a wider class of nonlinear and time‐varying systems with weaker conditions than quasi‐linear systems.