Removing data and using metafounders alleviates biases for all traits in Lacaune dairy sheep predictions

Bias in dairy genetic evaluations, when it exists, has to be understood and properly addressed. The origin of biases is not always clear. We analyzed 40 yr of records from the Lacaune dairy sheep breeding program to evaluate the extent of bias, assess possible corrections, and emit hypotheses on its origin. The data set included 7 traits (milk yield, fat and protein contents, somatic cell score, teat angle, udder cleft, and udder depth) with records from 600,000 to 5 million depending on the trait, ～1,900,000 animals, and ～5,900 genotyped elite artificial insemination rams. For the ～8% animals with missing sire, we fit 25 unknown parent groups. We used the linear regression method to compare “partial” and “whole” predictions of young rams before and after progeny testing, with 7 cut-off points, and we obtained estimates of their bias, (over)dispersion, and accuracy in early proofs. We tried (1) several scenarios as follows: multiple or single trait, the “official” (routine) evaluation, which is a mixture of both single and multiple trait, and “deletion” of data before 1990; and (2) several models as follows: BLUP and single-step genomic (SSG)BLUP with fixed unknown parent groups or metafounders, where, for metafounders, their relationship matrix gamma was estimated using either a model for inbreeding trend, or base allele frequencies estimated by peeling. The estimate of gamma obtained by modeling the inbreeding trend resulted in an estimated increase of inbreeding, based on markers, faster than the pedigree-based one. The estimated genetic trends were similar for most models and scenarios across all traits, but were shrunken when gamma was estimated by peeling. This was due to shrinking of the estimates of metafounders in the latter case. Across scenarios, all traits showed bias, generally as an overestimate of genetic trend for milk yield and an underestimate for the other traits. As for the slope, it showed overdispersion of estimated breeding values for all traits. Using multiple-trait models slightly reduced the overestimate of genetic trend and the overdispersion, as did including genomic information (i.e., SSGBLUP) when the gamma matrix was estimated by the model for inbreeding trend. However, only deletion of historical data before 1990 resulted in elimination of both kind of biases. The SSGBLUP resulted in more accurate early proofs than BLUP for all traits. We considered that a snowball effect of small errors in each genetic evaluation, combined with selection, may have resulted in biased evaluations. Improving statistical methods reduced some bias but not all, and a simple solution for this data set was to remove historical records.     

Breeding schemes with optimum-contribution selection or truncation selection for beef cattle destined for use on dairy females

We tested the hypothesis that the size of a beef cattle population destined for use on dairy females is smaller under optimum-contribution selection (OCS) than under truncation selection (TRS) at the same genetic gain (ΔG) and the same rate of inbreeding (ΔF). We used stochastic simulation to estimate true ΔG realized at a 0.005 ΔF in breeding schemes with OCS or TRS. The schemes for the beef cattle population also differed in the number of purebred offspring per dam and the total number of purebred offspring per generation. Dams of the next generation were exclusively selected among the one-year-old heifers. All dams were donors for embryo transfer and produced a maximum of 5 or 10 offspring. The total number of purebred offspring per generation was: 400, 800, 1,600 or 4,000 calves, and it was used as a measure of population size. Rate of inbreeding was predicted and controlled using pedigree relationships. Each OCS (TRS) scheme was simulated for 10 discrete generations and replicated 100 (200) times. The OCS scheme and the TRS scheme with a maximum of 10 offspring per dam required approximately 783 and 1,257 purebred offspring per generation to realize a true ΔG of €14 and a ΔF of 0.005 per generation. Schemes with a maximum of 5 offspring per dam required more purebred offspring per generation to realize a similar true ΔG and a similar ΔF. Our results show that OCS and multiple ovulation and embryo transfer act on selection intensity through different mechanisms to achieve fewer selection candidates and fewer selected sires and dams than under TRS at the same ΔG and a fixed ΔF. Therefore, we advocate the use of a breeding scheme with OCS and multiple ovulation and embryo transfer for beef cattle destined for use on dairy females because it is favorable both from an economic perspective and a carbon footprint perspective.     

Convolutional Neural Network Auto Encoder Channel Estimation Algorithm in MIMO-OFDM System

Higher transmission rate is one of the technological features of prominently used wireless communication namely Multiple Input Multiple Output-Orthogonal Frequency Division Multiplexing (MIMO–OFDM). One among an effective solution for channel estimation in wireless communication system, specifically in different environments is Deep Learning (DL) method. This research greatly utilizes channel estimator on the basis of Convolutional Neural Network Auto Encoder (CNNAE) classifier for MIMO-OFDM systems. A CNNAE classifier is one among Deep Learning (DL) algorithm, in which video signal is fed as input by allotting significant learnable weights and biases in various aspects/objects for video signal and capable of differentiating from one another. Improved performances are achieved by using CNNAE based channel estimation, in which extension is done for channel selection as well as achieve enhanced performances numerically, when compared with conventional estimators in quite a lot of scenarios. Considering reduction in number of parameters involved and re-usability of weights, CNNAE based channel estimation is quite suitable and properly fits to the video signal. CNNAE classifier weights updation are done with minimized Signal to Noise Ratio (SNR), Bit Error Rate (BER) and Mean Square Error (MSE).     

Sizing of multi-stage Op Amps by combining design equations with the gm/ID method

Analog integrated circuit design has as integral parts both analytical reasoning and numerical validation in the process from topology construction to sizing. Given a circuit topology, different circuit sizing results can be obtained from different processes of sizing inference. Sizing methods by simulation-based numerical searching have been a continuously studied subject. However, almost all approaches in this category require an overwhelming number of circuit simulations to arrive at an optimized sizing result. On the other hand, many published manual sizing methods by using the conventional device equations also require repeated SPICE simulations to correct the equation-based sizing results. This paper proposes a systematic gm/ID-based initial sizing method specifically customized for designing multiple-stage operational amplifiers (Op Amps). A main feature of the proposal is to use circuit-level design equations as constraints on the gm/ID table lookup method to substantially reduce the uncertainty in the sizing calculations. As a result, a significant amount of SPICE based correction work can be reduced to complete an initial sizing. The proposed sizing procedure includes a few regular sizing rules customized to the configuration of multi-stage Op Amps. We validate the proposed sizing method by application to several multi-stage Op Amp examples with a capacitive load or Miller compensation. Simulations have justified that the produced initial sizing results can achieve most of the prespecified design targets.     

基于全相位预处理的时域多重信号分类波达方向估计方法

低信噪比下,针对宽带短脉冲情况下频域多重信号分类(MUSIC)中噪声子空间估计不稳定问题,提出一种基于全相位预处理的时域多重信号分类波达方向(DOA)估计方法。①对线列阵接收数据进行分组处理;②按搜索角度对各组数据进行相移预处理,并对各组数据预处理结果进行相加,得到一组新数据;③对线列阵接收数据在时域构建相移后的协方差矩阵,在更短数据长度下,稳定实现噪声子空间估计,并依据估计出的噪声子空间含有的正交特性,通过单位矩阵加法器得到相应空间谱估计值,实现波达方向估计。数值仿真和实测数据处理结果表明,相比频域MUSIC方法,该方法有效提高了线列阵接收数据协方差矩阵中信号含有量和信噪比,能够在更短数据长度情况下实现对噪声子空间的稳定估计,具有较好的稳定性和检测性能,提高了MUSIC方法在实际波达方向估计中的鲁棒性。     

海上稠油油田蒸汽吞吐产量确定新方法

针对目前蒸汽吞吐产量预测模型假设条件简单、普适性差等问题,一般采用测试法和类比法综合确定海上稠油油田蒸汽吞吐初期产量。由于目前海上油田通常只开展常规测试,无法直接获得热采开发初期产量。笔者提出海上稠油油田蒸汽吞吐初期产量确定新方法,建立蒸汽吞吐相对于常规开发的初期产量倍数预测模型,通过蒸汽吞吐产量倍数,将常规测试确定的产量转化为蒸汽吞吐产量。研究表明,蒸汽吞吐初期产量倍数主要受储集层渗透率、原油黏度、注入强度、蒸汽干度等因素影响,利用正交试验设计和多元回归等方法,建立海上稠油油田蒸汽吞吐初期产量倍数与油藏地质参数及注入参数之间的非线性预测模型,该模型经实际生产数据验证,预测误差小于5%,可靠性高,能够为海上稠油油田蒸汽吞吐初期产量的确定提供依据。     

Analyzing dissipation effects on the non-classicality witnessing by a qubit via the entangled state representation

ABSTRACT

In this paper, we study detection of the state non-classicality for a quantum harmonic oscillator by a qubit in the presence of dissipation effects. We show that dissipation can enhance the effectiveness of the method in case of using the corrected form of the related nonclassicality witness. Such an improvement is attributed to the fact that dissipation leads to probing a surface, instead of a curve, of the complex plane for non-classicality condition on normally-ordered characteristic function.     

低活化马氏体钢热变形行为及机理型本构建模研究

利用Gleeble-3500热模拟试验机研究了低活化马氏体钢在变形温度为850～950 ℃、应变速率为0.001～1 s^-1条件下的热变形行为。建立了流变应力本构方程，并评估了该方程的预测能力。绘制了低活化马氏体钢在不同应变下的热加工图。结果表明：在较高的应变速率条件下，该材料主要发生动态回复，在较高变形温度和较低应变速率下具有明显的动态再结晶特征；本构方程的预测结果与实验结果符合良好；变形温度870～930 ℃、应变速率0.001～0.01 s^-1和变形温度920～950 ℃、应变速率0.3～1 s^-1分别是真应变为0.4和0.6下最优的热加工区域。     

A values–beliefs–attitude model of local food consumption: An empirical study in China and Denmark

Consumers’ and policy makers’ interest in local foods is growing. Accordingly, researchers are also increasingly paying attention to the consumption of local foods. Studies have identified preference for local foods as an emergent consumer ideology called “locavorism”, but they have not yet addressed its antecedents or put it into a theoretical context. In addition, extant research provides several insights into local food buying behaviour in developed economies (e.g., USA, UK, Germany, or Italy); however, studies simultaneously conducted in developed and emerging economies are lacking. To address these research gaps, this study develops a conceptual framework with proposed relationships among values, beliefs (locavorism and fresh start mindset), and attitudes towards and intentions to purchase local foods in China and Denmark. We conducted an online survey in China and Denmark that evaluated our constructs with pre-developed multiple-item measures. Using structural equation modelling to test the integrated model, we find that values and long-term orientation are antecedents of consumer beliefs but the influences of values on consumer beliefs differ between collectivistic-dominated China and individualistic-dominated Denmark. Specifically, collectivistic values are significantly and positively related to locavorism in both countries, while individualistic values are strongly linked to locavorism only in Denmark; collectivistic values have no effects on fresh start mindset for the two samples, but individualistic values are significantly and positively related to a fresh start mindset in Denmark. In addition, consumer beliefs are significantly and positively associated with attitudes towards and intentions to buy local foods. Local food marketers can use our findings to target their communications more effectively.     

煤样多元物性参数在煤与瓦斯突出防治中的应用研究

煤与瓦斯突出是一种复杂的动力现象，突出的类型不同、引起突出的危险因素不同，预测指标对其的敏感性也就不同，选择适应的突出危险性预测敏感指标及突出敏感指标的临界值，研究可靠的突出预测手段和方法来实现对突出危险性的准确预测，是指导突出防治工作的重要技术基础，而为了获得突出敏感指标的临界值就必须对煤的多元物性参数进行实验研究，掌握煤层的各项物化性质，是有效确定防治突出方法体系的关键基础。