The influence of mining factors on seismic activity during longwall mining of a coal seam

In this article an attempt to determine the influence of mining factors on the seismic activity during the longwall mining of the upper layer of coal seam no. 405/2 in one of the Polish hard coal mines in the Upper Silesian Coal Basin was conducted. Two longwall panels were mined in analogous geological conditions and based on the same mining system and technology. However, there was significant difference with regards to the mining factors, which was reflected in the observed seismic activity. Some tools used in mining seismology were applied to illustrate the aforementioned influence of mining factors, e.g. the frequency-energy distribution, the frequency-magnitude distribution, the 2 D distribution of released seismic energy, the relationship between released seismic energy and the volume of mined coal, the Benioff strain release, and the Gutenberg-Richter(GR) b coefficient distribution(b is the proportion between high and low energy tremors). Concerning the Benioff strain release, a new solution, based on the slope of a fitted line in a moving time window, is proposed.     

2.3–21 GHz broadband and high linearity distributed low noise amplifier

This paper focuses on the design of a 2.3–21 GHz Distributed Low Noise Amplifier (LNA) with low noise figure (NF), high gain (S₂₁), and high linearity (IIP3) for broadband applications. This distributed amplifier (DA) includes S/C/X/Ku/K-band, which makes it very suitable for heterodyne receivers. The proposed DA uses a 0.18 μm GaAs pHEMT process (OMMIC ED02AH) in cascade architecture with lines adaptation and equalization of phase velocity techniques, to absorb their parasitic capacitances into the gate and drain transmission lines in order to achieve wide bandwidth and to enhance gain and linearity. The proposed broadband DA achieved an excellent gain in the flatness of 13.5 ± 0.2 dB, a low noise figure of 3.44 ± 1.12 dB, and a small group delay variation of ±19.721 ps over the range of 2.3–21 GHz. The input and output reflection coefficients S₁₁ and S₂₂ are less than −10 dB. The input compression point (P_1dB) and input third-order intercept point (IIP3) are −1.5 dBm and 11.5 dBm, respectively at 13 GHz. The dissipated power is 282 mW and the core layout size is 2.2 × 0.8 mm².     

基于压缩机-支架系统的异常噪声研究

针对某乘用车发动机转速在1 573 r/min，压缩机开启时车内噪声异常的问题，对样车进行试验分析与诊断，对压缩机-支架系统进行仿真分析，提出改进方案并验证改进效果。利用LMS声振信号采集系统采集振动噪声数据，采用频谱分析、阶次追踪等方法，并结合压缩机-支架系统模态仿真结果，确定车内异常噪声是压缩机轴频21阶与压缩机-支架系统3阶模态频率接近发生共振造成的。通过优化支架结构来提高压缩机-支架系统3阶模态频率以此来避免共振，并换装橡胶驱动盘缓和压缩机输入扭矩波动。将改进结构进行整车试验，结果表明：匀速工况空调开启时问题转速下，车内噪声降低了2.5 dB(A)；匀加速工况空调开启时发动机转速1 500~1 650 r/min区间，车内噪声无峰值，其余转速空调开启时改进前/后车内噪声基本不变，噪声波动趋势平缓。     

广州市郊填埋场附近蔬菜重金属检测与讨论

蔬菜是人们餐桌上必不可少的食物,重金属在受污染的自然环境中又无处不在,而蔬菜中的重金属含量尤其令人担忧。本文使用原子吸收分光光度法(石墨炉)和原子荧光分光光度法检测了广州市郊某垃圾填埋场附近所种植蔬菜中重金属含量。结果:抽样由2013年10月至2014年9月共持续一年,共抽样检测12次,按平均每个月一次的频率,检测结果并未发现有蔬菜超出国家规定的限量值。     

马尔可夫跳变线性系统最优控制的研究现状与进展

马尔可夫跳变线性系统（MJLS）是一种具有多个模态的随机系统，系统在各个模态之间的跳变转移由一组马尔可夫链来决定。MJLS模型因其在表示过程中可以产生突变而更能精确的描述实际工程应用中的系统。近年来，MJLS的最优控制问题成为了研究的热点，动态规划、极大值原理以及线性矩阵不等式等成为了解决此类问题的主流方法。本文对MJLS最优控制领域的研究现状进行了综述。分别对一般情况下、带有噪声的情况下、带有时滞的情况下以及某些特定情况下的MLJS最优控制问题的国内外研究现状进行论述。最后进行了总结并提出MJLS最优控制领域未来值得关注的研究方向。     

一款紧凑增强型可变阻抗电磁带隙结构

基于传统AI-EBG结构,提出了一种小尺寸的增强型电磁带隙结构,实现了从0.5~9.4 GHz的宽频带-40 dB噪声抑制深度,且下截止频率减少到数百MHz,可有效抑制多层PCB板间地弹噪声。文中同时研究了EBG结构在高速电路应用时的信号完整性问题,使用差分信号方案可改善信号完整性。     

Kernel-based fourth-order diffusion for image noise removal

The fourth-order partial differential equations have good performance on noise smoothing and edge preservation without creating blocky effects on smooth regions. However, for low signal-to-noise ratio images, the discrimination between edges and noise is a challenging problem. A novel kernel-based fourth-order diffusion is proposed in this paper. It introduces a kernelized gradient operator in the fourth-order diffusion process, which leads to more effective noise removal capability. Experiment results show that this method outperforms several previous anisotropic diffusion methods for noise removal and edge preservation.     

基于交会图和多元统计法的神经网络技术在火山岩识别中的应用

针对火山岩储层的特殊性(复杂性、离散性和随机性),应用BP神经网络技术对火山岩测井解释中岩性识别问题进行了研究。该方法的技术关键是样本集和初始权重的建立,以及模型的优选。本文提出了一种基于交会图和多元统计法的学习样本生成方法,即根据取心岩样的地球化学和岩石学研究,用交会图技术建立样本集,采用聚类分析和距离判别法确定初始权重。将研究方法应用在松辽盆地杏山地区火山岩岩性识别问题中,取得了很好的效果,岩性解释符合率高于90%。文中通过四种岩性识别处理模式的对比研究,表明赋权重处理模式为最优处理模型。在神经网络模型预测过程中,需充分利用已有的地质经验和测井曲线信息建立典型可靠的样本文件,同时考虑神经网络方法中各种因素的影响,优选模型和计算参数才能使预测结果符合实际情况。     

基于正演模拟的地震反射特征主要影响因素分析

随着储层地球物理学的发展，利用地震信息直接预测储层砂岩厚度的横向变化，愈来愈迫切要求对地震数据进行高保真处理。利用波动方程理论法对楔形体砂岩模型进行正演模拟，探讨了随机噪声、地层吸收对地震记录、地震属性以及砂岩预测结果的影响。分析认为，当Q小于100时，地层对地震反射能量吸收严重，需要在处理中加强能量补偿。当S／N小于5时，储层砂岩厚度与地震反射特征、地震属性的相关性变差，噪声对预测结果产生干扰，影响储层预测精度。