The phosphorescence emission in undoped lead-halide Cs4PbBr6 single crystals at low temperature

Recently, all-inorganic cesium lead-halide perovskites have shown their promise for light emission applications, due to the excellent optical performance. Herein, we report that the initially nonphosphorescent undoped lead-halide Cs₄PbBr₆ single crystals (SCs) exhibit an ultralong phosphorescence emission under X-ray excitation at low temperatures. It is shown that the dramatic change has been taken place in radioluminescence spectra and the broad-band emission gradually appeared with the decrease of temperature. Below 210 K, the radioluminescence spectra can be deconvoluted into one narrow peak located at 530 nm and two broad peaks centered at 595 nm and 672 nm respectively. Subsequently, the time-dependent radioluminescence spectra in undoped lead-halide Cs₄PbBr₆ SCs were investigated. The ultralong phosphorescence emission can persist over 120 min at 70 K. We consider that ultralong phosphorescence originates from defect-related emission. To the best of our knowledge, our finding is the first time that undoped Cs₄PbBr₆ SCs exhibit the phosphorescence emission, which will offer a paradigm to motivate revolutionary applications on perovskite.     

Evaluation of back-calculated elastic moduli of unreinforced and geocell-reinforced unbound granular material from full-scale field tests

This paper presents a field-scale experimental track over a poor subgrade with an unreinforced section and a geocell-reinforced section subjected to in-situ performance tests. Plate load tests and Benkelman beam tests were carried out distributed in several unreinforced and reinforced layers. The objective was to: (1) examine the variability of the elastic modulus of unbound granular material (UGM) due the influence of its thickness and the presence of poor subgrade in its base, (2) evaluate the modulus improvement factor (MIF) generated by the geocell reinforcement in the UGM and (3) verify the most appropriate condition to apply the MIF to transport infrastructure design. The results showed that there is a significant influence of the thickness of the UGM layer on its elastic modulus when the layer is supported directly over a soft subgrade. The MIF values obtained in field suggest that its determination is mostly related to the UGM maximum elastic modulus rather than its decreased values (by virtue of poor subgrade or reduced thicknesses), and that the analytical formulation presented for MIF calculation has good predictive capability to be applied to pavement design.     

Synthesis of Diamond@SiO2@Ag composite materials for high SERS effect

Among various carbon materials, diamond stands out due to excellent physical and chemical properties. In this work, we designed Dia@SiO₂@Ag composites combining diamond micropowder and Ag nanoparticles by a simple chemical method and obtained stable substrate for surface enhanced Raman scattering (SERS) owing to its high surface-to-volume ratio, low density, as well as close bond between diamond and Ag. As-prepared Dia@SiO₂@Ag presented high activity to detect crystal violet and rhodamine 6G molecules, which was demonstrated by significantly enhanced SERS spectra and high enhancement factor values (10⁸-10⁹). Moreover, Dia@SiO₂@Ag also showed desired sensitivity, which was investigated by detection limit. Therefore, our study provided more theoretical support and broadened the functional applications of diamond, particularly in Raman detection.     

抗FGF-2纳米抗体抑制碱烧伤诱导大鼠角膜血管新生

目的：研究抗成纤维细胞生长因子（FGF-2）纳米抗体对碱烧伤诱导的大鼠角膜血管生成的治疗作用。方法：将SD大鼠分为：假手术组（Sham），模型组（Model，直径为3 mm的浸有1 mol/L NaOH溶液圆形滤纸贴于大鼠眼角膜中央处30 s，制备大鼠碱烧伤血管生成模型）和治疗组（Treatment，术后7天至21天用3 mg/mL的抗FGF-2纳米抗体溶液滴眼，每日3次，每次10 μL，共14天）。通过体视显微镜和CD31免疫组织化学染色计算大鼠角膜血管生成情况。实时荧光定量PCR、酶联免疫吸附测定和免疫组织化学染色3种方法检测抗血管内皮生长因子（VEGF）和FGF-2的mRNA和蛋白表达水平。结果：（1）血管：治疗组较模型组的面积显著减少，血管管腔较窄（P<0.05），在药物干预14天后，差异最为显著；（2）FGF-2的mRNA和蛋白表达水平：模型组与治疗组的结果相近（P>0.05）；（3）VEGF的mRNA和蛋白表达水平：治疗组显著高于模型组（P<0.05）。此外，假手术组的持续给药也使得VEGF表达显著增加（P<0.05）。 结论：抗FGF-2纳米抗体可抑制由碱烧伤诱导的角膜血管新生，但也使得正常大鼠角膜或病理大鼠角膜的VEGF表达水平代偿性升高。     

Testing EGFR with Idylla on Cytological Specimens of Lung Cancer: A Review

The current standard of care for advanced non-small-cell lung cancer is based on detecting actionable mutations that can benefit from targeted therapy. Comprehensive genetic tests can have long turn-around times, and because EGFR mutations are the most prevalent actionable mutation, a quick detection would enable a prompt initiation of targeted therapy. Furthermore, the scarcity of diagnostic material means that sometimes only cytologic material is available. The Idylla™ EGFR assay is a real-time PCR–based method able to detect 51 EGFR mutations in 2.5 h. Idylla is validated for use only on FFPE sections, but some researchers described their experiences with cytological material. We reviewed the relevant literature, finding four articles describing 471 cases and many types of cytological input material: smears, cell-block sections, suspensions, and extracted DNA. The sensitivity, specificity, and limit of detection appear comparable to those obtained with histological input material, with one exception: the usage of scraped stained smears as input may reduce the accuracy of the test. In conclusion, usage of cytological material as input to the Idylla EGFR test is possible. A workflow where common mutations are tested first and fast, leaving rarer mutations for subsequent comprehensive profiling, seems the most effective approach.     

Improving the fill factor of N2200-based all polymer solar cells by introducing EPPDI as a solid additive

A cheap and commercially available small molecule (namely EPPDI) is introduced to the active layer of N2200-based all polymer solar cells as a solid additive. EPPDI at the optimal ratio can improve the D-A nano-scale morphology and reduce trap density of the active layer by filling morphological spaces. As a result, the photovoltaic performance of the resulting devices based on PF2:N2200 are increased from 6.28% to 7.03% with significantly enhanced fill factor. This work demonstrates a facile approach for improving the performance of all polymer solar cells.     

Comparative study of mechanical and chemical methods for surface cleaning of a marine shell‐and‐tube heat exchanger

In this article, experimental analysis is done on shell‐and‐tube heat exchanger of a marine vessel for removal of fouling using optimum surface‐cleaning techniques. The main objective is to compare the performance of the heat exchanger before and after maintenance. Two identical deteriorated systems of heat exchangers are taken and real‐time analysis is conducted. The log data are taken before and after undergoing maintenance for the two systems. Two different cleaning techniques are used, namely, chemical cleaning and mechanical cleaning. Detailed calculations are made for the shell‐and‐tube heat exchanger. From the obtained data, comparisons are made for different parameters on the tube side such as friction factor, heat transfer coefficient and pressure drop, as well as total heat transfer rate on the shell side. From the analysis and comparison, it was found that greater heat transfer takes place for the tubes cleaned using the chemical cleaning method than for tubes cleaned by the mechanical cleaning method. Pressure drop is found to be less for chemical cleaning method than mechanical cleaning method. This indicates that the fouling effect is reduced for tubes cleaned by the chemical cleaning method, and furthermore these tubes remain corrosion‐resistant for longer periods of time.     

瞬变电磁井间勘探的全空间几何因子

井间是剩余油的主要分布区域,为探测井间剩余油,提高采收率,提出了基于全空间几何因子的瞬变电磁井间勘探方法。在本井使用线圈发射、邻井使用线圈接收,根据瞬变电磁场理论,在阶跃信号的激励下发射线圈在地层中激发出沿圆周方向的闭合瞬变电场,该电场在导电地层中产生与地层电导率呈正比的涡流。由Doll地层环模型可知,地层中的涡流在空间任意点激发得到与地层电导率成正比的二次场响应信号(有用信号),并可表示为空间各点电导率的加权平均值,其权重即为井间瞬变电磁勘探的全空间几何因子;全空间几何因子集中分布在发射线圈和接收线圈附近,其它区域分布较少,在发射线圈和接收线圈两侧呈现不同的极性;对瞬变电磁响应与地层电导率、井间距和源距的变化规律研究可知,瞬变电磁井间勘探有用信号随着地层电导率的增大而增大,随着井间距的增加单调减小,在发射线圈和接收线圈处于同一深度时该响应信号幅度最大。     

我国主产区油茶持久性有机污染物分布特征及相关性研究

为了明确油茶中持久性有机污染物(POPs)的污染分布特征,利用气相色谱-三重四极杆串联质谱(GC-MS/MS)对我国主产区45个采样点135批次油茶果不同部位及对应油茶林土壤进行16种多环芳烃(PAHs)、18种多氯联苯(PCBs)和21种有机氯(OCPs)污染水平分析。同时分析油茶籽仁和油茶林土壤中主要POPs之间相关性。结果表明:油茶果各部位及油茶林土壤PAHs污染以萘、苊烯、苊萘嵌戊烷、荧蒽等低环PAHs污染较为明显;PCBs污染程度很轻,含量均在1μg/kg以下;OCPs污染主要为狄氏剂、毒杀芬、α-六六六、硫丹、异狄氏剂和艾氏剂。油茶籽仁中荧蒽与菲具有强正相关(R~2=0.90);油茶林土壤中芴与菲,■与苯并(a)蒽、苯并(b)荧蒽、苯并(k)荧蒽、苯并(a)芘和苯并(a)蒽,PCB138与茚并(1,2,3-cd)芘,PCB180与苯并(g,h,i)苝,p,p′-DDE与o,p′-DDT、p,p′-DDD之间均具有较强相关性(R~2=0.81～0.98)。     

普通食用油检验关键点分析

以实际案例和文献资料收集为基础,主要围绕食用油检测从采样到结果判定一系列过程中可能涉及的操作风险点进行分析,并对部分典型检验指标(苯并(a)芘、塑化剂、抗氧化剂、残留溶剂、过氧化值、酸价、辣椒素、黄曲霉毒素B1)进行分析,介绍了分析过程中实验室环境、接触器具、试剂、样本本底、特殊基质干扰、指标稳定性等对实验结果有关键影响的因素,并针对具体问题提出解决措施,旨在为食用油检验风险防控提供技术支撑。