基于音频特征的工程车辆工况识别研究

高效率地使用工程车辆是工程项目管理中节约成本的有效方法，无人监管环境下工程车辆的工况识别，是实现工程车辆高效率使用的有效手段。目前以GPS等技术为核心的车辆智能管理系统未对工程车辆进行工况识别，提出一种基于GRU循环神经网络的工程车辆工况识别方法，通过对工程车辆在不同工况下产生的音频信号进行分析，从中提取Mel倒谱系数作为主要特征，构建GRU循环神经网络模型进行训练和识别。实验结果表明，该方法可以实现对工程车辆工况的有效识别。     

Effect of microwave heating time on the gel properties of chicken myofibrillar proteins and their formation mechanism

The present work was conducted to illustrate the mechanism of gel formation of myofibrillar proteins (MPs) under different microwave heating times. The results showed that the denaturation enthalpy (ΔH) of the MPs significantly decreased when the heating time increased from 3 to 9 s and then completely disappeared as the heating time progressed, indicating that the MPs gradually denatured and subsequently aggregated with increasing heating time, which was further verified by the changes in the secondary structure, electrophoretic bands, and gel properties (e.g., water holding capacity and textural profiles) of the MPs. Microstructural images indicated that the MP gel formed under 12 s had the most compact network, indicating that extended microwave heating time could induce quality deterioration of MP gels. Moreover, the hydrophobic forces, electrostatic forces, and disulphide bonds of the MPs gradually intensified with increasing microwave heating time, suggesting that both non-covalent and covalent bonds could promote molecular denaturation and subsequent aggregation of MPs. In addition, correlation analysis revealed that the changes in the molecular conformation of MPs induced by different microwave heating times could effectively regulate the formation of MP gels and their related properties.     

Construction and analysis of photovoltaic directly coupled conditions in PEM electrolyzer

The Markov model and the PEM electrolyzer system model for directly coupled photovoltaic are combined to construct an efficient and reliable working condition that fits the fluctuation characteristics of solar energy. The working condition is designed through genetic algorithm so that the average coupling efficiency of the system can reach 98.8%. Then, the durability and recovery test are conducted on the basis of the constructed conditions. It is found that the attenuation rate at the current density of 1A/cm² under the photovoltaic fluctuating condition reached 7.8mV/h, which is twice that under the constant current condition. The charge transfer impedance (R_ct) is the main factor leading to the degradation. It is proved by the recovery experiment that the increase of R_ct is related to the pollution of metal ions. After pickling to remove some metal ions, R_ct can be significantly reduced by 46.8% and 65.2%, respectively. After the durability test, the voltammetric charges under the photovoltaic fluctuating condition and the constant current condition are reduced by 48.3% and 19.1% It indicates that the photovoltaic fluctuation condition will accelerate the attenuation of the effective reaction area of MEA, which is irreversible even after pickling. It can be observed from the SEM images that the catalyst layer of MEA has more obvious peeling under the photovoltaic fluctuation condition, which is not conducive to material transmission and destroys the transmission channel of ions and electrons. This result can provide a reliable reference for the coupling design of PEM electrolyzer and renewable energy in the future.     

Intrinsic Defect Limit to the Growth of Orthorhombic HfO2 and (Hf,Zr)O2 with Strong Ferroelectricity: First-Principles Insights

It is believed that promoting the fraction of ferroelectric orthorhombic phase (o-phase) through O-poor growth conditions can increase the spontaneous polarization of HfO₂ and (Hf,Zr)O₂ thin films. However, the first-principles calculations show that the growth may be limited by the easy formation of point defects in the orthorhombic and tetragonal phases of HfO₂, ZrO₂, and (Hf,Zr)O₂. Their dominant defects, O interstitial (O_i) under O-rich conditions and O vacancy (V_O) under O-poor condition, have low formation energies and quite high density (10¹⁶–10¹⁹ cm⁻³ for 800–1400 K growth temperature). Especially, O_i has negative formation energy in tetragonal HfO₂ under O-rich condition, causing non-stoichiometry and limiting the crystalline-seed formation during o-phase growth. High-density defects can cause disordering of dipole moments and increase leakage current, both diminishing the polarization. These results explain the experimental puzzle that the measured polarization is much lower than the ideal value even in O-poor thin films and highlight that controlling defects is as important as promoting the o-phase fraction for enhancing ferroelectricity. The O-intermediate condition (average of O-rich and O-poor conditions) and low growth temperature are proposed for fabricating HfO₂ and (Hf,Zr)O₂ with fewer defects, lower leakage current, and stronger ferroelectricity, which challenges the belief that O-poor condition is optimal.     

可控中子及X射线源测井技术发展现状及趋势

随着核仪器技术的进步以及安全健康的工业发展需求，具有人工可控性的中子源及X射线源逐步在测井领域得到推广应用，为油气等矿产资源的勘探开发提供了关键技术手段。可控中子及X射线源测井技术是以中子发生器或X射线管产生的中子或X射线与地层物质作用，通过探测中子、伽马或X射线从而进行地层孔隙度、密度、油气饱和度和元素含量的测井技术。本文概述了可控中子及X射线源测井技术，回顾了其发展历程；介绍了可控中子及X射线测井技术在数值模拟、仪器研制及数据处理方法方面的研究现状及应用，并展望了可控中子及X射线源测井技术的发展前景，认为未来可控中子及X射线源测井技术可从以下三个方面开展研究：分析不同射线在能量、时间及空间的分布规律，开展探测理论基础研究；联合不同学科优势，开展多类型多模式的新型仪器研制；增强谱数据校正及解析方法研究，开展谱信息综合分析及应用。     

Event-triggered distributed receding horizon control for tracking and formation of homogeneous multi-agent systems

This paper proposes an event-triggered distributed receding horizon control (DRHC) approach for the formation and tracking problems of homogeneous multi-agent systems. For each agent, an event-triggering condition, based on assumed predictive information of the neighbours, is derived from stability analysis. Considering the uncertain deviation between the assumed and true predictive information, we design a time-varying compatibility constraint for the individual optimization problem. In the event-triggered DRHC algorithm, each agent solves the optimization problem and communicates with its neighbours only when the event-triggering condition is satisfied, so the communication and computation burden are reduced. Moreover, guarantees for the recursive feasibility and asymptotic stability of the overall system are proved. A simulation example is provided to illustrate effectiveness of the proposed approach.     

利用地震品质因子Q比例的分布特征预测南川页岩气藏保存条件

根据地震数据、地质资料和地震属性，开展了南川地区五峰组-龙马溪组下部页岩的地震品质因子Q平面上分布与页岩气保存条件评价研究。针对南川地区页岩气开发中的断裂破碎带，提出了一种获取稳定品质因子Q比例及界限的工作流程和相应的迭代算法。研究表明，地震品质因子Q比例的分布可以快速、直观识别出断裂破碎带的内幕特征与不同类型页岩分布区。其中，断裂破碎带页岩区的品质因子Q比例总体上偏小，大多低于0.2，局部超过0.5，平面上分布杂乱、碎斑状；页岩呈北东向展布的条带，被断裂所撕裂、破碎，保存条件较差。稳定分布的页岩区的品质因子Q比例是较高的，超过0.7，平面变化稳定，没有突变现象，保存条件好。微裂缝发育的页岩区的品质因子Q比例具有渐变的趋势性，品质因子Q比例的分布从该页岩区的边部0.7向中部有规律地减小至0.1，保存条件最佳。实践证明，高产气井大多位于稳定分布的页岩区或内部微裂隙发育的稳定页岩区，地震品质因子Q比例研究方法对页岩气保存评价与开发井优化部署是一个实用工具。     

生物毒素的脱毒技术及药物研究进展

作为一种特殊的生物源化学物质,生物毒素对农产品、人畜、环境等有不可忽视的健康隐患,但由于其结构与功能作用的多样性,其对于生物化学、医药学、环境生态学等又具有重要意义。本研究就生物毒素的来源分类、危害、脱毒技术及生物毒素的应用进行综述,以期为进一步生物毒素的监管与开发利用提供理论参考。     

基于临界钙矾石膨胀破坏的磷石膏基复合胶凝材料的配料计算研究

为制备大掺量磷石膏基复合胶凝材料,在确定主要水化产物类型的基础上,通过计算临界钙矾石膨胀破坏的边界条件,确定各组分最佳掺量范围,研究其对复合胶凝材料力学性能、干缩性能的影响,并通过X射线衍射（XRD）、扫描电镜（SEM）等测试方法研究水化产物的组成及发展规律。研究结果表明：通过理论配料计算,矿粉掺量为50%（质量分数）时,最大磷石膏掺量为26.3%（质量分数）,最小熟料掺量为23.6%（质量分数）。最佳配比组28 d胶砂抗压强度为45.2 MPa,线膨胀率小于0.04%;对比组28 d抗压强度仅有36.4 MPa,线膨胀率远大于0.04%。XRD、SEM表征结果表明,磷石膏基复合胶凝材料的水化产物主要是钙矾石（AFt）和水化硅酸钙（C-S-H）凝胶,氢氧化钙几乎反应完全;对比组钙矾石生成量远大于最佳配料组,微观结构存在大量裂缝。这说明理论配料计算可以有效用于磷石膏基复合胶凝材料的配比优化。     

Effect of storage time and temperature on hydrogen fermentation of food waste

Practically, before being fed to the treatment plant, food waste (FW) is stored for up to a week in a storage tank under ambient temperature condition, which would have an impact on the bioenergy yield. In the present work, FW was stored at different temperatures (5 °C, 20 °C, and 35 °C) for 0 d, 1 d, and 2 d, and it was used as a feedstock for mesophilic H₂ fermentation. H₂ production curves were divided by three groups, finally attaining 1.7–1.8 mol H₂/mol hexose_added, 1.4–1.5 mol H₂/mol hexose_added, and 1.2 mol H₂/mol hexose_added, achieved from the (fresh, FW stored at 5 °C), (FW stored at 20 °C, and 35 °C for 1 d), and (FW stored at 35 °C for 2 d), respectively. The different performance was attributed to the growth of indigenous lactic acid bacteria such as Lactobacillus and Weissella during storage under high temperature condition. In addition, it was found that the activity of homoacetogenic reaction (R17, 4H₂ + CO₂ → Acetate) calculated by establishing metabolic flux balance was different depending on the H₂ production performance. The flux of R17 ranged 0.03–0.06 under low H₂ yield achieved conditions, while it increased to 0.10–0.17 those showing low H₂ yields.