Multistage Zeolite Drying for Energy-Efficient Drying

This work discusses the potential of three multistage zeolite drying systems (counter-, co-, and cross-current) with a varying number of stages. The evaluation showed that for 2-4 stages with heat recovery the efficiency of the systems ranges between 80 and 90%. Additionally, by introducing a compressor, the latent heat in the exhaust air from the regenerator is recovered and used to heat the inlet air for an additional drying stage. As a result, for the counter-current drying system and compressor pressure 1.5-2 bar, a maximum energy efficiency of 120% is achieved, which results in halving the energy consumption compared to conventional drying systems.     

Thermodynamic Analysis of Various Dehumidifying Dryers for Wood

Typical methods of dehumidification of air circulating in the dehumidifying driers (indirect and direct cooler and partial exchange of the air) were analysed. Energy aspect of cooler operation was evaluated. The method for minimization of unit thermal energy consumption in a dehumidifying drier by the optimal selection of the cooler point was also given. Methods of the heat recovery of heat conveyed in a cooler lending to save energy (heat regeneration. expansion and compression of the air, a dehumidifier) were analysed. It was indicated that introduction of dehumidifiers into contemporary wood driers caused significant improvement of energy aspects of their operation     

Silver Electrodeposition from Photographic Processing Solutions

This paper describes the parameters that are important in the industrial practice of silver removal from photographic fixers. The experiments were performed under potentiostatic control using synthetic solutions. The current efficiency was analysed as a function of the cathodic potential taking into account the deposit quality. A cathodic potential of ?0.5 V against a saturated calomel electrode is recommended. The conditions to prevent the darkening of the electrodeposit were investigated. The determination of silver concentration in the solution was made by direct potentiometry. The results obtained with synthetic fixers were corroborated by making the silver deposition from commercial fixers in an electrochemical reactor with rotating cylinder electrode intercalated in an electrolytic flow circuit in order to simulate practical conditions.     

Spontaneous emulsification aspect of enhanced oil recovery

Recent studies have suggested the possibility of spontaneous emulsification as a mechanism for enhanced oil recovery (EOR). The discussions have, however, remained essentially qualitative. A study was therefore undertaken to estimate quantitatively the contribution of spontaneous emulsification as an EOR mechanism. The tests were conducted on several bulk liquid/liquid systems as well as by displacement experiments in unconsolidated synthetic sand packs. Spontaneous emulsification was found to be a mechanism for EOR: the estimated extra contribution to EOR due to this mechanism was found to be significant in laboratory scale displacement experiments. Tertiary recovery was always greater when spontaneous emulsification was evident than otherwise. Results of tests on bulk liquid/liquid systems indicate that the occurrence or absence of spontaneous emulsification can be correlated with the values of ‘partition parameter’. It may be concluded that higher oil recoveries may be achieved in chemical EOR processes where interface mass transfer (and the accompanying spontaneous emulsification) occurs. The evaluation of efficiency of residual oil mobilisation through the capillary number theory (with and without spontaneous emulsification) is also discussed. Displacement tests with spontaneously emulsifying systems showed that residual oil left behind a conventional waterflood was mobilised in a range of capillary numbers much less than that which applies to low-tension waterfloods.     

TRVs and fault clearing stresses in extra-high-voltage radial networks

To cope with the high rate of increase of power demand in the main industrialized districts in Japan, 550-kV transmission systems covering the districts have been reinforced, with most of the main power plants connected directly to these systems. Through 550-/300-kV substations, the majority of power to the districts is supplied by 300-kV systems. To limit the excess short-circuit capacity in the 300-kV systems, they tend to be reconstructed as so-called radial networks. In radial networks with high short-circuit capacity and relatively small number of transmission lines connected to the substation busbars, the rate of rise of TRV can be far higher than standard value. This paper analyzes the transient recovery voltages (TRV) in such extra-high-voltage radial networks in Japan, together with the relevant stresses to circuit-breakers during fault clearings. Future system conditions have also been introduced. As the typical rate of rise of the TRV values, more than twice that of today's standard ones are probable.     

Biosorption of heavy metals by Saccharomyces cerevisiae: Effects of nutrient conditions

Studies took place to investigate the effects of different nutrient conditions on the biosorption ability and selectivity of heavy metals by Saccharomyces cerevisiae. After having grown in media supplemented with additional glucose, ammonium, phosphate or cysteine, the yeast was exposed to an equimolar solution of lead, cadmium, zinc and copper. Lead removal from a mixed solution was significantly higher than that of copper, followed by zinc and cadmium. Generally, yeasts from cysteine-rich media showed greatest sorption capacity whereas phosphate addition influenced zinc selectivity. In addition, glucose, fructose and sucrose as carbon sources were examined. Cultures grown in glucose had a better uptake than those cultivated with fructose at an incubation time of 30 min.     

Trifluoromethanesulphonic acid catalysed transalkylation between tetrabromobisphenol-a and toluene for the production of 2,6-dibromophenol

The preparation of 2,6-dibromophenol is described. This compound, useful as raw material for brominated poly(phenyleneoxide) and pyrogallol or derived pharmaceuticals/pesticides, was prepared in 80% (isolated) yield by a transalkylation reaction between tetrabromobisphenol-A and toluene. The catalyst, trifluoromethanesulphonic acid, can be simply recovered and recycled. Perfluorinated resin sulphonic acid (NAFION-H®, DuPont) did not effectively catalyse this transalkylation.     

压缩机废油回收工艺小结

介绍了压缩机废油回收的原理、工艺及操作要点,达到了节油降耗的目的。     

浅谈计算机硬盘数据丢失原因及恢复

本文主要对计算机硬盘数据丢失的原因、恢复软件的应用方法进行分析。     

基于检查点的数据库恢复技术

从介绍基于日志的数据库恢复技术出发,阐述检查点法的数据恢复原理,并以MSSQLServer系统为例,研究数据库系统采用检查点法的数据恢复技术。