Functional activation of cerebral blood flow abolished by scopolamine is reversed by cognitive enhancers associated with cholinesterase inhibition: a positron emission tomography study in unanesthetized monkeys

The effects of somatosensory stimulation on the regional cerebral blood flow (rCBF) response were studied in unanesthetized monkeys before and after treatment with scopolamine and three cognitive enhancers (physostigmine, E2020 and tacrine) that inhibit cholinesterase, using 15O-labeled water and high-resolution positron emission tomography. Under control conditions, somatosensory stimulation induced a significant increase in the rCBF response in the contralateral somatosensory cortex of monkey brain. Intravenous administration of scopolamine (50 microg/kg) resulted in abolishment of the rCBF response to stimulation. The rCBF response abolished by pretreatment with scopolamine was recovered by administration of physostigmine (1 or 10 microg/kg), E2020 (10 or 100 microg/kg) or tacrine (100 or 1000 microg/kg), in a dose-dependent manner. The effect of E2020 (100 microg/kg) on the rCBF response lasted for >4 hr, whereas the effects of physostigmine and tacrine were of shorter duration. These findings suggest that these compounds reversed the scopolamine-abolished rCBF response to somatosensory stimulation via enhancement of cholinergic neurotransmission, which was mainly induced by cholinesterase inhibition.     

Vapor phase hydroformylation of ethene over Co/SiO2 promoted by noble metals: dynamic in situ diffuse reflectance FT-IR study of surface species

An in situ diffuse reflectance FT-IR technique was employed to investigate the active surface species and the reaction mechanism of the oxygenate formation in the vapor phase hydroformylation of ethene on Co/SiO₂ promoted with various noble metals such as Ir, Rh, Pt, Re, Ru, and Pd. Co(A)/SiO₂ and Ir(CO)/SiO₂ which were derived from cobalt(II) acetate and Ir₄(CO)₁₂, respectively, were quite inactive in the reaction, and showed only quite small peaks of adsorbed CO under the conditions of 1.1 MPa of C₂H₄/CO/H₂ at 298 K. In contrast, Co(A)-Ir(CO)/SiO₂, which were very active in the reaction, exhibited strong absorption bands of linear and bridged CO species. At 423–463 K, propanal adsorbed on the catalyst and acyl species which is suggested as the intermediate for the formation of propanal were also observed on this catalyst. By exposing CO preadsorbed on this catalyst to C₂H₄/H₂ at 289 K and 0.1 MPa, the intensity of the linear CO band decreased, and the bands of propanal and acyl species emerged simultaneously, whereas that of the bridged CO band remained constant after the initial drop. These results suggested that the oxygenates are formed via the CO insertion into adsorbed ethyl species, and linear CO species plays a major role in the CO insertion on these noble metal-promoted cobalt catalysts.     

Coal liquefaction by in-situ hydrogen generation.: 2. Zinc-water model compound reactions

Model compound studies were carried out to elucidate the reaction mechanisms taking place during the liquefaction of coal with the hydrogen produced from the reaction of zinc and water. In compounds of the type Ph-(CH₂)_n-Ph the splitting of the aliphatic bridge was easier with higher n values. Ether type compounds such as diphenylether were unreactive although the C-O bond in dibenzylether was easily cleaved. Condensed ring aromatic compounds gave low conversion with hydrogenation being facilitated by an increase in ring number. Phenolic compounds such as phenol did not react well, but the reactivity increased with increase in aromatic ring size. The cleavage of the aliphatic bridge was accelerated by the OH group, for example, in the case of 4-hydroxydiphenylmethane bond scission was about 15 times higher than that of diphenylmethane. Heterocyclic compounds were unreactive.     

Anodic polarization of aluminium in organic electrolytes

The polarization characteristics of aluminium anodes have been studied in various organic electrolytes containing aluminium chloride. The small amount of oxide present on the metal was dissolved by an anodic pre-treatment. The charge transfer number of the overall reaction was three. The current density supported by the electrolytes decreased in the order nitromethane>acetonitrile >propylene carbonate, formamide>tetrahydrofuran. The rest potential increased in the order formamide     

Cathode properties of metal trifluorides in Li and Na secondary batteries

Fluorine compounds have high discharge voltage due to its highly ionic metal-ligand bonds. In them, perovskite-type metal trifluorides with corner sharing matrix have large bottlenecks of diffusion pathways for intercalants. Iron trifluoride composites (FeF₃-C) prepared by planetary ball milling with carbon showed reversible charge/discharge behavior not only for Li, but also for Na anodes. X-ray diffraction and ⁵⁷Fe Mössbauer spectroscopy were applied to characterize the electrochemical properties of FeF₃ vs. Li and Na anodes. The cathode performances of the other commercially available transition metal trifluorides such as MF₃ (M = Ti, V, Mn, Co) have been also investigated.     

Modification of Shockley surface state by long-chain n-alkane: Photoemission study on tetratetracontane/Au(111) interface

Modification of quasi two-dimensional surface electron system on Au(111) with adsorption of long-chain n-alkane molecule n-CH₃(CH₂)₄₂CH₃ (tetratetracontane: TTC) was investigated by angle-resolved photoemission spectroscopy. Significant modification of the energy band structure of the Shockley surface state was induced by the adsorption of TTC monolayer with “flat-on” structure. The energy shift of the Shockley surface state toward the Fermi level reaches about 160 meV at Γ? point (k = 0 Å^− 1). The possible origin of the stabilization of the surface electron system with TTC monolayer is discussed.     

Optimization of Co-content in C14 Laves phase multi-component alloys for NiMH battery application

The structural, electrochemical, and gas phase hydrogen storage properties of predominantly C14 crystalline phase alloys with partial replacement by Co (up to 2.5 at%) are reported. Minor phases, including C15 and cubic TiNi, were found by X-ray diffraction and contributed to the improved hydrogen diffusion through the alloy. The optimal Co-content of between 1.0 and 1.5 at% provides easy activation, high gas phase capacity, and a high discharge capacity. An optimized alloy formula also provided the smallest metallic nickel cluster size embedded in the surface oxide and the largest number of nickel clusters. In sealed cell studies, a Co-content of 1.5% gives the best performance in formation, cycle life, and charge retention, but has worse specific power and low temperature performance than some other compositions. The high-rate dischargeabilities at lower rates were found to be limited by surface reactions, not bulk diffusion.     

Lateral Inhomogeneity in the Electronic Structure of a Conjugated Poly(3‐hexylthiophene) Thin Film

How annealing influences the morphology of a highly regioregular poly(3‐hexylthiophene) (RR‐P3HT) film at the substrate interface as well as the lateral inhomogeneity in the electronic structure of the film are elucidated. Whereas previous studies have reported that high‐molecular‐weight (MW) RR‐P3HT films tend to show low crystallinity even after annealing, it is found that high‐MW RR‐P3HT does show high crystallinity after annealing at high temperature for a long time. Photoemission electron microscopy (PEEM), X‐ray photoemission spectroscopy, and ultraviolet photoemission spectroscopy results clearly resolve a considerable lateral inhomogeneity in the morphology of RR‐P3HT film, which results in a variation of the electronic structure depending on the local crystallinity. The PEEM results show how annealing facilitates crystal growth in a high‐MW RR‐P3HT film.     

Correlation of reactivity to hydrogenation and chemical structure of lignites

Three North Dakota lignites with almost the same percentage carbon have been used to determine the relation between chemical structure and reactivity to hydrogenation. Average structural indices of the lignites were estimated using the pyridine-soluble products after alcohol-alkali treatment, the structural indices obtained at various reaction times being extrapolated to zero reaction time. Hydrogenation was influenced by the average structure, with the lignite having higher aromaticity, higher molecular weight of the pyridine extract from the alcohol-alkali reaction product, larger aromatic ring size and lower content of aliphatic structure, showing a smaller degree of conversion.     

Energy-level alignment at model interfaces of organic electroluminescent devices studied by UV photoemission: trend in the deviation from the traditional way of estimating the interfacial electronic structures

The electronic structures of model interfaces of organic electroluminescent (EL) devices were investigated with UV photoemission spectroscopy (UPS). Interfaces of TTN (tetrathianaphthacene) and TCNQ (tetracyanoquinodimethane) were also studied as extreme cases for hole transport and electron transport material, respectively. For all organic/metal interfaces studied, the work function of metal electrode was changed by deposition of organic layer, i.e., the vacuum level was shifted at the interface, indicating the invalidity of the traditional energy level alignment model where a common vacuum level was assumed at organic/metal interface. At TCNQ/Au, DP-NTCI/Al, which are acceptor/metal interfaces, upward shift of the vacuum level of organic layer relative to that of metal was observed, suggesting the formation of interfacial dipole due to electron-transfer from metal to acceptor. At other organic/metal interfaces, TPD(N, N'-diphenyl-N, N'-(3-methylphenyl)-1, 1'-biphenyl-4, 4'-diamine)/Au or ITO (indium tin oxide), ALq/sub 3/ (tris(8-hydroxyquinolino) aluminum)/Al, DP-NTCl(N, N'-diphenyl-1,4,5,8- naphthyltetracarboxylimide)/Al or Au, downward shift of the vacuum level was observed. Such downward shift has been also observed in our previous study for porphyrin/metal interfaces, and seems to be a trend for organic/metal interfaces at which no electron-transfer from metal to organic layer occurs. This trend suggests that the traditional model tends to underestimate (overestimate) the barrier height for hole (electron) injection. On the other hand, the vacuum level shift at ALq/sub 3//TPD interface was less than 0.1 eV, leading to an apparent applicability of the traditional model. However, it is not always the case for organic/organic interfaces: finite shift of 0.2 eV was observed at TTN/TCNQ interface due to electron-transfer from TTN to TCNQ. Possible origins of vacuum level shift at organic/metal interfaces were also discussed.