Research and development of liquid hydrogen (LH2) temperature monitoring system for marine applications

Monitoring the temperature in liquid hydrogen (LH₂) storage tanks on ships is important for the safety of maritime navigation. In addition, accurate temperature measurement is also required for commercial transactions. Temperature and pressure define the density of liquid hydrogen, which is directly linked to trading interests. In this study, we developed and tested a liquid hydrogen temperature monitoring system that uses platinum resistance sensors with a nominal electrical resistance of approximately 1000 Ω at room temperature, PT-1000, for marine applications. The temperature measurements were carried out using a newly developed temperature monitoring system under different pressure conditions. The measured values are compared with a calibrated reference PT-1000 resistance thermometer. We confirm a measurement accuracy of ±50 mK in a pressure range of 0.1 MPa–0.5 MPa.     

Anti‐Sway Crane Control Considering Wind Disturbance and Container Mass

A method for estimating the sway angle using an observer has already been proposed. The state observer estimates the sway angle accurately and must use the detected sway angle value. However, the estimated sway angle has an error owing to rope length error, friction force, and wind. Moreover, the container mass cannot be determined, and therefore the observer parameter is not suitable. We already proposed robust antisway control for overcoming rope length error without adding a new sensor. Further, we designed a friction disturbance observer to cancel out the influence of the friction force. In this paper, we first propose a container mass estimation method when a crane system performs rolling up control. The observer parameter can be selected using the estimated mass value. Second, in crane parallel shift control, we propose a robust antisway control even when there is a wind disturbance. We design a wind disturbance observer and propose a wind disturbance estimator to separate the friction observer output from the wind disturbance observer output. We confirm through experiments that the proposed method can reduce vibration.     

Efficacy of interferons in treating children with chronic hepatitis C

Twenty-two children with chronic hepatitis serologically positive for hepatitis C virus (HCV) were treated with interferon-alpha (IFN-alpha). Liver biopsy showed chronic active hepatitis in 13 and chronic persistent hepatitis in 9 patients. A sustained clearance of HCV was observed in 8/22 children 12 months after the administration of IFN-alpha for 26 weeks, associated with normalization of HCV core antibody. Of these eight patients six had HCV genotype III and two HCV genotype II or IV. Hepatitis relapsed in seven other patients after completion of IFN-alpha with an increase in HCV core antibody titre, five with HCV genotype II, and two with HCV genotype III or IV. A second course of IFN-alpha suppressed the reactivation of HCV in all seven patients. Three of seven responders who relapsed after the first course remained negative for HCV RNA 12 months after their second course of IFN-alpha. However, the remaining four patients with HCV genotype II again relapsed after completing their second course of IFN-alpha. Seven children with the HCV genotype II resistant to IFN, including 8 weeks of IFN-beta administration, and showed no significant reduction in HCV core antibody titre. CONCLUSION: The genotype of HCV (III) and a reduction in the core antibody titre appear to be useful parameters for predicting the response to IFN-alpha therapy.     

Entropy,Free Volume,and Cooperative Relaxation

The high frequency end of the relaxation spectrum for polymer molecules involves the rotation of the segmental bonds. This fast relaxation process, however, cannot take place easily in the condensed state crowded by the densely packed conformers, necessitating the slower cooperatively synchronous relaxation. As the temperature is lowered, the domain of cooperativity grows towards the infinite size at the Kauzmann zero entropy temperature, though actually the system deviates from the equilibrium as the glass transition intervenes typically at 50 K above that temperature. The excess enthalpy and entropy drop faster than predicted by the rotational isomeric states which would reach zero only at 0 K. The real ΔC_P is greater than that of the RIS value. The actual volume in excess of the crystalline lattice volume, however, points towards zero at 0 K. Thus, a polymer with higher T_g typically exhibits a lower density and modulus in the glassy state. Since the configurational entropy associated with the free volume is proportional to the logarithm of the latter, the Kauzmann temperature can be scaled by ln M, where M is the algebraic average of the conformer molecular weight. The temperature dependence of the most dominant, i.e., the largest equilibrium domain size will result in the Adam-Gibbs and Vogel equations for the characteristic relaxation time. The cooperative domain distribution leads to the relaxation spectrum that follows a power law. The relationship between the characteristic relaxation time and the rate of physical aging is derived.     

Flashover voltage characteristics of contaminated station insulators under temporary ac overvoltages in the ac system connected with a frequency converter station

According to the recent analysis results of temporary ac overvoltage in the ac system connected with a frequency converter station, large-magnitude over-voltages were confirmed to occur under some special system conditions. Most of the station insulators currently used cannot withstand such overvoltages according to an evaluation based on the data obtained earlier. The necessity of tests to be done to evaluate such performance more accurately was recognized. Both power frequency and switching impulse overvoltage flashover tests were made on contaminated insulators by the method well simulating the natural wetting condition. Switching impulse flashover voltage with the waveshape having a long wavefront time of 2 ms can be well correlated with the flashover voltage characteristics of temporary ac overvoltage. Higher flashover voltage characteristics were obtained by a clean fog test method compared with those obtained by equivalent fog test method.     

Molecular Dynamics Simulation of Structural Relaxation of Asphaltene Aggregates

For asphaltene obtained from vacuum residue of Khafji crude oil, the energy-minimum conformation calculated by molecular mechanics-dynamics simulations showed that aggregated structures of asphaltene molecules through noncovalent interactions are more stable. Changes induced in aggregated structures by pretreatment with solvents were investigated using molecular dynamics calculations. The simulation showed that in quinolin at 573 K, some staking interactions could be disrupted, while, in 1-methylnaphthalene it was not observed. Autoclave experiments showed that the coke yield after pyrolysis at 713 K was decreased when the asphaltene was pretreated with quinoline at 573 K for 1 h, compared to the yield without the pretreatment. While, in the case of pretreatment in 1-methylnaphthalene, the coke yield did not change significantly. The simulation's results above can be related to the difference in coke yield between two solvents; in quinoline some aromatic-aromatic stacking interactions could be disrupted and mobility of molecules was increased. This resulted in prevention of the asphaltenes from polymerizing, as in condensation reactions among aromatic rings. Consequently, the coke yield after the pretreatment with quinoline was decreased.     

Drain structure optimization for highly reliable deep submicrometern-channel MOSFET

A guideline for n^- fully gate overlapped (FOLD) structure design optimization has been studied. From the viewpoint of reliability, the greatest reduction in substrate current directly leads to the most reliable n^- design for the FOLD structure. The current path modulation phenomenon due to the trapped charge at the n ^- extension region dominates the hot-carrier induced characteristics change for conventional lightly doped drain (LDD) structure with side-wall spacer. This phenomenon is minimized in the FOLD structure due to its higher controllability of the gate electrode than the LDD structure at the n^- extension region. Furthermore, it was also confirmed that the 0.3 μm optimized FOLD structure can achieve high circuit performance at 3.3 V operation, maintaining hot-carrier resistance