High energy storage and ultrafast discharge in NaNbO3-based lead-free dielectric capacitors via a relaxor strategy

Dielectric capacitors with decent energy storage and fast charge-discharge performances are essential in advanced pulsed power systems. In this study, novel ceramics (1-x)NaNbO₃-xBi(Ni_2/3Nb_1/3)O₃(xBNN, x = 0.05, 0.1, 0.15 and 0.20) with high energy storage capability, large power density and ultrafast discharge speed were designed and prepared. The impedance analysis proves that the introducing an appropriate amount of Bi(Ni_0·5Nb_0.5)O₃ boosts the insulation ability, thus obtaining a high breakdown strength (E_b) of 440 kV/cm in xBNN ceramics. A high energy storage density (W_total) of 4.09 J/cm³, recoverable energy storage density (W_rec) of 3.31 J/cm³, and efficiency (η) of 80.9% were attained in the 0.15BNN ceramics. Furthermore, frequency and temperature stability (fluctuations of W_rec ≤ 0.4% over 5–100 Hz and W_rec ≤ 12.3% over 20–120 °C) were also observed. The 0.15BNN ceramics exhibited a large power density (19 MW/cm³) and ultrafast discharge time (~37 ns) over the range of ambient temperature to 120 °C. These enhanced performances may be attributed to the improved breakdown strength and relaxor behavior through the incorporation of BNN. In conclusion, these findings indicate that 0.15BNN ceramics may serve as promising materials for pulsed power systems.     

甲玛地区角岩矿微生物浸出的试验研究

介绍了西藏华泰龙矿业开发有限公司角岩的矿石性质,针对该低品位铜矿石进行了详细的微生物浸出试验研究,在原矿铜品位仅为0.12%、SiO_2含量高达69.12%的情况下,用接种量为10%的浸矿菌液,浸出1 d时,铜浸出率即为34.44%,浸出11 d时,浸出率达到70.02%,此时较无菌条件下的浸出率高出17.46个百分点。     

Core–shell NTC materials with low thermal constant and high resistivity for wide-temperature thermistor ceramics

Core–shell structures have been proposed to improve the electrical properties of negative-temperature coefficient (NTC) thermistor ceramics. In this work, Al₂O₃-modified Co_1.5Mn_1.2Ni_0.3O₄ NTC thermistor ceramics with adjustable electrical properties were prepared through citrate-chelation followed by conventional sintering. Co_1.5Mn_1.2Ni_0.3O₄ powder was coated with a thin Al₂O₃ shell layer to form a core–shell structure. Resistivity (ρ) increased rapidly with increasing thickness of the Al₂O₃ layer, and the thermal constant (B) varied moderately between 3706 and 3846 K. In particular, Co_1.5Mn_1.2Ni_0.3O₄@Al₂O₃ ceramic with 0.08 wt% Al₂O₃ showed the increase of ρ double, and the change in its B was less than 140 K. The Co_1.5Mn_1.2Ni_0.3O₄@Al₂O₃ NTC ceramics showed high stability, and their grain size was relatively uniform due to the protection offered by the shell. The aging coefficient of the ceramic was less than 0.2% after aging for 500 hours at 125°C. Taken together, the results indicate that as-prepared Co_1.5Mn_1.2Ni_0.3O₄@Al₂O₃ NTC ceramics with a core–shell structure may be promising candidates for application as wide-temperature NTC thermistor ceramics.     

Microstructural and electrical changes in Ca0.9R0.1CeNbMoO8 (R = Y,Sm, Nd,La) ceramics induced by rare-earth ion doping

Rare-earth ions doped Ca_0.9R_0.1CeNbMoO₈ (R = Y, Sm, Nd, La) ceramics have been successfully prepared by solid-state method, and their modifications to the microstructure and electrical properties are also investigated. The rare-earth ions doped ceramics exhibit the scheelite structure. With the increase in the radius of rare-earth ions, the lattice distortion and bond interaction will be enhanced, and the consistency of grain size will be reduced. The ceramics exhibit negative temperature coefficient (NTC) thermistor characteristics in the temperature range of 473 K-1273 K, and the activation energy decreases with the increase of the radius of rare-earth ions. Rare-earth ions doping can increase the content of Ce³⁺ ions and promote the conductivity of ceramics. Except for Sm³⁺-doped ceramics, the high-temperature aging rate of other ceramics is less than 2%. The existence of some metastable Sm²⁺ ions in Sm³⁺-doped ceramics not only increases the activation energy, but also reduces the high-temperature stability of the ceramics.     

Key-dependent side-channel cube attack on CRAFT

CRAFT is a tweakable block cipher introduced in 2019 that aims to provide strong protection against differential fault analysis. In this paper, we show that CRAFT is vulnerable to side-channel cube attacks. We apply side-channel cube attacks to CRAFT with the Hamming weight leakage assumption. We found that the first half of the secret key can be recovered from the Hamming weight leakage after the first round. Next, using the recovered key bits, we continue our attack to recover the second half of the secret key. We show that the set of equations that are solvable varies depending on the value of the key bits. Our result shows that 99.90% of the key space can be fully recovered within a practical time.     

Novel thermal-sensitive properties of NBT-BZT composite ceramics for high-temperature NTC thermistors

We found for the first time that (1 − x) Na_0.5Bi_0.5TiO₃-xBiZn_0.5Ti_0.5O₃ (NBT–BZT) composite ceramics showed negative temperature coefficient (NTC) at a high temperature. The NBT–BZT nanopowders were successfully prepared by Pechini method. Their ceramics were sintered at 1100°C. The NBT–BZT ceramic exhibited a good linear relationship between logarithm of electrical resistivity (Inρ) and reciprocal of absolute temperature (1000/T) at 250°C–1050°C. The obtained ρ₆₀₀, ρ₉₀₀, and B_600/900 constants of the NBT–ZBT NTC thermistors are approximately 5.92 × 10⁶ to 3.01 × 10⁴ Ω cm, 7.03 × 10³ to 7.60 × 10² Ω cm and 2.3 × 10⁴-1.3 × 10⁴ K, respectively. The electrical characteristics can be tuned to the desired value by changing the Na_0.5Bi_0.5TiO₃ content in the compound. The electrical conductivity in these compounds is due to the electron jumps between Ti³⁺ and Ti⁴⁺ and oxygen-ion conductivity. Results demonstrate a tremendous potential of the studied system for perovskite materials with NTC performance.     

分布式连接全装配RC楼盖动力特性分析

为研究分布式连接全装配RC楼盖(DCPCD)的动力特性,进行了 4个足尺DCPCD试件和一个整浇板试件在两端简支条件下的锤击法试验和数值模拟分析,研究了 DCPCD的板缝构造、连接件锚固方式、边界约束条件和自重等对楼盖竖向动力特性的影响.试验结果表明:与整浇板相比DCPCD横板向刚度较小,自振频率较低,板缝构造是影响楼盖刚度和振动特性的主要因素;连接件数量越多,楼盖的刚度和自振频率越高;板缝数量越多,楼盖的刚度和自振频率越低.所提出的有限元模拟方法可以准确模拟DCPCD的动力特性;连接件锚固强度越高,楼盖的刚度和自振频率越高;两端嵌固约束下的楼盖基频比两端简支约束下提高了 70％;随着楼盖自重的增加,自振频率显著降低.研究结果可为四边约束下楼盖的竖向振动特性与人致激励响应研究提供参考和依据.     

施工过程中腐蚀隐患的控制

通过分析石化装置施工过程中常见的现象,分析产生由这些现象加重腐蚀的原因和机理, 指出应加强施工过程中的控制,而达到预期的防腐蚀效果,消除腐蚀隐患。     

阜阳地区石炭-二叠系煤系烃源岩特征

阜阳地区石炭-二叠系煤系地层发育，但由于勘探程度较低，对该区煤系地层烃源岩的生烃潜力认识不清，严重制约了该区的油气勘探。在已有资料的基础上，通过有机地球化学和有机岩石学方法并结合模拟实验，探讨了该区煤系烃源岩的生烃潜力。研究结果表明阜阳地区石炭-二叠系煤系烃源岩有机质丰度达到中等-好烃源岩标准，有机质类型以腐殖型为主，盆地模拟结果显示阜阳地区石炭-二叠系煤系地层油资源量为（30.47~152.33）×10⁶t，气资源量为（266.7～1333.7）×10⁸m³，展示阜阳地区石炭-二叠系煤系地层具有较好的生油气潜力。