Engineering egress data considering pedestrians with reduced mobility

To quantify the evacuation process, evacuation practitioners use engineering egress data describing the occupant movement characteristics. These data are typically based to young and fit populations. However, the movement abilities of occupants who might be involved in evacuations are becoming more variable—with the building populations of today typically including increasing numbers of individuals: with impairments or who are otherwise elderly or generally less mobile. Thus, there will be an increasing proportion of building occupants with reduced ability to egress. For safe evacuation, there is therefore a need to provide valid engineering egress data considering pedestrians with disabilities. Gwynne and Boyce recently compiled a series of data sets related to the evacuation process to support practitioner activities in the chapter Engineering Data in the SFPE Handbook of Fire Protection Engineering. This paper supplements these data sets by providing information on and presenting data obtained from additional research related to the premovement and horizontal movement of participants with physical‐, cognitive‐, or age‐related disabilities. The aim is to provide an overview of currently available data sets related to, and key factors affecting the egress performance of, mixed ability populations which could be used to guide fire safety engineering decisions in the context of building design.     

Proton-Detected Solid-State NMR of the Cell-Free Synthesized α-Helical Transmembrane Protein NS4B from Hepatitis C Virus

Proton-detected 100 kHz magic-angle-spinning (MAS) solid-state NMR is an emerging analysis method for proteins with only hundreds of microgram quantities, and thus allows structural investigation of eukaryotic membrane proteins. This is the case for the cell-free synthesized hepatitis C virus (HCV) nonstructural membrane protein 4B (NS4B). We demonstrate NS4B sample optimization using fast reconstitution schemes that enable lipid-environment screening directly by NMR. 2D spectra and relaxation properties guide the choice of the best sample preparation to record 2D ¹H-detected ¹H,¹⁵N and 3D ¹H,¹³C,¹⁵N correlation experiments with linewidths and sensitivity suitable to initiate sequential assignments. Amino-acid-selectively labeled NS4B can be readily obtained using cell-free synthesis, opening the door to combinatorial labeling approaches which should enable structural studies.     

Biocides used in building materials and their leaching behavior to sewer systems.

There is increasing concern about diffuse pollution of aquatic systems by biocides used in urban areas. We investigated sources and pathways of biocides significant for the pollution of storm water runoff. Main sources seem to be building envelopes, i.e. facades (paints, plasters) and roof sealing membranes. First results from a defined urban catchment drained by a separated sewer system without any agricultural activities reveal a substantial occurrence. Even after the first flush, concentrations of terbutryn, carbendazim, mecoprop as well as Irgarol 1051 and its metabolite exceeded the Swiss water quality standard of 0.1 microg/L. In laboratory experiments, leaching of mecoprop used as a root protection agent in bitumen sheets for roof waterproofing was determined. The concentrations differed in 16 different sheets two orders of magnitude, depending on the product composition. Using optimized products, it is expected to be the most efficient and sustainable way to reduce the environmental impact. To understand transport dynamics and environmental risk, further storm water events will be analyzed. Based on the ongoing project URBIC, first measures will be proposed to limit the release to surface and ground water.     

Enhancement of computed tomography liver contrast using iomeprol-containing liposomes and detection of small liver tumors in rats

RATIONALE AND OBJECTIVES: We evaluated iomeprol-containing liposomes (Lipiom), a new contrast medium for computed tomography (CT) liver scanning, in an animal model of chemically induced hepatocellular carcinomas and other liver tumors in rats. METHODS: Liver tumors were induced by administration of carcinogens to rats, either 0.55% (w/w) 1'-hydroxysafrole in the diet or induction by 3'-methyl-4-diethylaminoazobenzene followed by promotion with carbon tetrachloride. CT scanning was performed 1-3 hr after intravenous injection of iomeprol-containing liposomes. RESULTS: After injection of iomeprol-containing liposomes at a dose of 70 mg of liposome-entrapped iodine per kilogram of body weight, the normal liver parenchyma showed a contrast enhancement, in Hounsfield units, of more than 60% over the control value before bolus. Liver tumors with no or few Kupffer cells were not enhanced and appeared as dark areas within the normal parenchyma. Tumors and pretumoral lesions devoid of Kupffer cells, as small as 3 mm in diameter, could be distinguished using this non-invasive method. CONCLUSION: CT liver scanning after injection of iomeprol-containing liposomes appears to be promising method for detecting liver tumors and focal liver lesions.     

Strawberry juice colour: The effect of some processing variables on the stability of anthocyanins

The colour stability of juice and purées made from a mixture of two strawberry varieties, stored at + 20°C or at –20°C under aerobic and anaerobic conditions, was studied. High-performance liquid chromatography and spectrophotometric analysis were used to monitor the changes in colour during storage. Pelargonidin 3-glucoside comprised 80% of the total anthocyanin content. Four other pelargonidin-based peaks were found, being 10.4%, 3.5%, 0.7% and 0.3% of the total and two cyanidin peaks were present, being 3.3% and 0.4% of the total. Clarification before storage caused considerable losses in the initial anthocyanin concentrations. Storage conditions (air versus nitrogen) did not influence the rate of loss of anthocyanins during storage or the formation of polymeric pigments. There were no losses in anthocyanins and no increase in the amount of colour measured at 510 nm due to polymers in samples stored at–20°C. Polymerisation occurred in the samples stored at + 20°C, especially in the clarified samples.     

Model for knowledge and legal expert systems

This paper presents a four layer model for working with legal knowledge in expert systems. It distinguishes five sources of knowledge. Four contain basic legal knowledge found in published and unpublished sources. The fifth consists of legal metaknowledge. In the model the four basic legal knowledge sources are placed at the lowest level. The metaknowledge is placed at levels above the other four knowledge sources. The assumption is that the knowledge is represented only once. The use of metaknowledge at various levels should make it possible to use the appropriate knowledge for the problem presented to the system. The knowledge has to be represented as closely to the original format as possible for this purpose. Suitable representation formalisms for the various types of knowledge in the five knowledge sources are discussed. It is not possible to indicate a best representation formalism for each knowledge source.     

X-ray Fluorescence Uptake Measurement of Functionalized Gold Nanoparticles in Tumor Cell Microsamples

Quantitative cellular in vitro nanoparticle uptake measurements are possible with a large number of different techniques, however, all have their respective restrictions. Here, we demonstrate the application of synchrotron-based X-ray fluorescence imaging (XFI) on prostate tumor cells, which have internalized differently functionalized gold nanoparticles. Total nanoparticle uptake on the order of a few hundred picograms could be conveniently observed with microsamples consisting of only a few hundreds of cells. A comparison with mass spectroscopy quantification is provided, experimental results are both supported and sensitivity limits of this XFI approach extrapolated by Monte-Carlo simulations, yielding a minimum detectable nanoparticle mass of just 5 pg. This study demonstrates the high sensitivity level of XFI, allowing non-destructive uptake measurements with very small microsamples within just seconds of irradiation time.     

Suppression of the development of pores during laser-induced surface dispersion of TiC into aluminium, by means of a static magnetic field

A static magnetic field having the strength of B=0.6 T has been used as an additional process parameter in order to suppress the establishment of pores while dispersing TiC particles in surface layers of aluminium alloys using a laser. The migration of hydrogen towards regions of high temperatures within the melting pool can lead to the creation of gas bubbles, therefore yielding pores after resolidification in the processed layer. This mechanism (known for instance in welding technologies of aluminium) could be suppressed by Lorentz-forces induced by an externally applied magnetic field. It could be shown experimentally that magnetic fields could assist laser surface treatment processes beneficially if higher beam powers were coupled in. This may be interesting if, for instance, thicker dispersed layers should be achieved.     

The influence of training level on manual flight in connection to performance,scan pattern,and task load

This work focuses on the analysis of pilots’ performance during manual flight operations in different stages of training and their influence on gaze strategy. The secure and safe operation of air traffic is highly dependent on the individual performances of the pilots. Before becoming a pilot, he/she has to acquire a broad set of skills by training to pass all the necessary qualification and licensing standards. A basic skill for every pilot is manual control operations, which is a closed-loop control process with several cross-coupled variables. Even with increased automation in the cockpit, the manual control operations are essential for every pilot as a last resort in the event of automation failure. A key element in the analysis of manual flight operations is the development over time in relation to performance and visual perception. An experiment with 28 participants (including 11 certified pilots) was conducted in a Boeing 737 simulator. For defined flight phases, the dynamic time warping method was applied to evaluate the performance for selected criteria, and eye-tracking methodology was utilized to analyze the gaze-pattern development. The manipulation of workload and individual experience influences the performance and the gaze pattern at the same time. Findings suggest that the increase of workload has an increased influence on pilots depending on the flight phase. Gaze patterns from experienced pilots provide insights into the training requirements of both novices and experts. The connection between workload, performance and gaze pattern is complex and needs to be analyzed under as many differing conditions. The results imply the necessity to evaluate manual flight operations with respect to more flight phases and a detailed selection of performance indications.