Very low surface recombination velocities on p-type silicon wafers passivated with a dielectric with fixed negative charge

Surface recombination velocities as low as 10 cm/s have been obtained by treated atomic layer deposition (ALD) of Al₂O₃ layers on p-type CZ silicon wafers. Low surface recombination is achieved by means of field induced surface passivation due to a high density of negative charges stored at the interface. In comparison to a diffused back surface field, an external field source allows for higher band bending, that is, a better performance. While this process yields state of the art results, it is not suited for large-scale production. Preliminary results on an industrially viable, alternative process based on a pseudo-binary system containing Al₂O₃ are presented, too. With this process, surface recombination velocities of 500–1000 cm/s have been attained on mc-Si wafers.     

STW resonator with organo-functionalized metallic nanoparticle film for vapor sensing

A 1 GHz surface transverse wave resonator on 36° Y-cut quartz plate coated with organothiol-functionalized gold nanoparticle film has been studied as a chemical gas sensor. Considerable sensitivity of the resonant frequency to vapors of ethanol, methanol, chloroform, and acetic acid has been found. Owing to the high short-term stability of the oscillator built, the detection limit is in the low ppm range. The results qualitatively confirm previous results on the same film type obtained by conductivity measurements. In the present case, the conductivity effect resulting from variable separation of nanoparticles is accompanied with surface-attached mass of the absorbed gas. The film matrix exhibits considerable capacity to absorb large amounts of molecules at high gas concentrations.     

NMR of 89Y in the Copper-Oxide Spin-Chain Compound Ca2+x Y2−x Cu5O10

We report NMR lineshape, spin-lattice relaxation time T ₁, and spin-spin relaxation time T ₂ data at 17 MHz (8.07 T) for ⁸⁹Y in the copper-oxide spin-chain compound Ca_2+x Y_2–x Cu₅O₁₀. For x=0, a broad, asymmetric line with width 90 kHz is observed for T=250–300 K. The spectra exhibit an appreciable average shift (H/H+0.7%) and sharpen at lower temperature, possibly due to increasing intrachain ferromagnetic correlations. T ₁ and T ₂ decrease with decreasing temperature. The Tl data imply a short correlation-time limit, with _e=3–5×10^–11 s. The T ₂ data apparently include a contribution from dipolar interactions with copper nuclei. Relaxation time data for a doped (x=0.5) compound surprisingly show more rapid relaxation.     

Layer thickness impact on the capacity of poly(urethaneimide) for sorbing toxic gases

The sensitivity of a thick layer (500 nm) of poly(urethaneimide) to toxic gases such as pyridine and hexamethyleneimine was studied by the quartz crystal microbalance method. The resonant frequency was registered by a spectrum analyzer. The successful overcoming of the unfavorable impact of the increased viscous damping, typical for the standard oscillator measurement method, allowed complete understanding of the behavior of a thick polymer layer toward highly pollutant gases. Quantitative information for polymer adsorption capacity and gas diffusivity was extracted. The comparison with our recent results for thinner layers revealed strong dependence on layer thickness for pyridine whereas the corresponding effect with hexamethyleneimine was found much less significant. Intermolecular interactions and the impact of the gas physical adsorption on the polymer matrix properties were shown as the driving parameters for the sensors response. The thickness dependence provides a tool for tuning the sensitivity of a potentially efficient poly(urethaneimide) sensor for pyridine. © 2016 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2016 , 133, 44214.     

Impedance spectroscopy studies of dual membrane fuel cell

This paper reports impedance studies of a dual membrane fuel cell - an innovative design based on the idea for a junction between an oxygen ion conducting cathode/electrolyte part and proton conducting anode/electrolyte part through a mixed oxygen ion and proton conducting porous membrane. Thus oxygen, hydrogen and water are located in three independent chambers. This concept allows avoiding all the severe pitfalls connected to the presence of water at electrodes in both SOFC and PCFC. The performed measurements of the 3 compartments and the data analysis are improved by introducing some specialized approaches and techniques, which are discussed. The impedance contribution in the proof of the new concept is also presented.     

Analyses and assessment of the spatial and temporal distribution of nitrogen compounds in surface waters

The temporal concentration variations and spatial distribution of nitrogen compounds (nitrate, nitrite, ammonium) in the natural surface waters of Stara Zagora Region, Bulgaria, over a period of 1 year were assessed in the present study. Nitrate‐nitrogen concentrations in all surface water samples, except for the December value – 21.8 mg/L in Zetyovo Reservoir, were within the permissible national quality standards. NO₂ ^–‐N could be classified as a priority pollutant of Chirpan and Zetyovo Reservoirs waters. The greatest extent of NH ₄ ⁺‐N pollution was registered in Chirpan Reservoir surface waters. The correlation study revealed appreciable mutual relationship only between NH₄ ⁺‐N and NO ₂ ^–‐N in the surface waters. The hierarchical cluster analysis (HCA) exhibited divergent apportionment of nitrogen compounds in the surface water bodies.     

Estimating activation energies for multi-mode failures

In Accelerated Life Time Modeling, the goal is to estimate the activation energy and failure time distribution. Existing methods assume data sets come from just one mechanism of failure. However, in many applications, more failure modes can be involved and few data are available; hence, we have to develop a method to identify the number of failure modes and assign observations to the appropriate failure mode. We developed a methodology based on Finite Mixture models and Bayesian Model selection to identify multiple failure modes. The approach provides the probability for each observation being associated with a certain failure mode, and provides good estimates for the activation energy of each mode.     

Energy in transition: From the iron curtain to the European Union

The fall of communism left some of the most polluting and wasteful energy sectors of the World in Central and Eastern Europe (CEE). After 15 years of restructuring, eight of these countries have joined the European Union (EU), closing an era of economic transitions. What progress has been made in these countries in the field of energy from the perspective of sustainability? Has the transition agenda been completed, or do any of the socialist energy sector legacies prevail?     

Interface Behavior of a Bimaterial Plate under Dynamic Loading

The paper deals with interface behavior of bimaterial ceramic-metal composites under dynamic time-harmonic load. The first plate is precracked with a normal crack touching the interface between the plates. It is assumed that the respective restriction for the ratio of energy release rates of the plates allowing the occurrence of an interface single delamination before the initiation of the normal crack in the second plate is satisfied. The growth of interface delamination is not considered. The used approximate shear-lag dynamic approach gives a possibility to obtain solutions in a closed form for axial and shear stresses of the structure. At an elastic-brittle interface behavior theoretical predictions for single debond length of two bimaterial structures are calculated. The parametric analysis reveals the sensitivity of the interface single debond length and shear stress to the type of bimaterial structure and to the characteristics of the dynamic load—in particular its frequency and amplitude. All results are illustrated in figures and tables and are discussed.