A two-dimensional time-domain finite element formulation for periodic structures

A formulation is presented for a two-dimensional time-domain finite-element method (FEM-TD) that incorporates periodic boundaries. The specifics of the method are shown for scattering problems, but it should be straightforward to extend it to radiation problems. The method solves for a transformed field variable (instead of solving directly for the electric field) in order to easily enable periodic boundary conditions in the time domain. The accuracy and stability of the method is demonstrated by a series of examples where the new formulation is compared with reference solutions. Very accurate results are obtained when the excitation (frequency range) and the geometry are such that no higher order Floquet modes are present. The accuracy is degraded in the presence of higher order modes due to the rather simple absorbing boundary condition that is used with the present formulation. The method is found to be stable even for angles of incidence close to grazing.     

QoS enhancement for adaptive streaming services over WCDMA

This paper presents a new method to adapt the quality-of-service (QoS) in a wideband code-division multiple-access (WCDMA) system, called radio network feedback (RNF). The concept of RNF is in general applicable to all the services requiring a minimum quality (i.e., non best effort) and in this paper, the focus is on streaming. In this context, RNF makes it possible for a streaming server to adapt its source bit rate to a WCDMA radio link, whose bandwidth may vary in time due, for example, to decongestion/congestion situations over the air interface or to handover. This is very beneficial for the end user as it allows to increase the bandwidth (i.e., the quality) when possible and to decrease it (instead of just dropping the service) when needed. RNF was compared with Client-based adaptation solutions. Simulation results show that RNF is fast and accurate and performs better than Client-based adaptation. For example, rebuffering occurs only with Client-based method. Moreover, with RNF the up-switch is performed only when needed, whereas the up-switch performed by means of the Client-based method is often erroneous and may annoy the end user.     

Pheromonal secretions from glands on the 5th abdominal sternite of hydropsychid and rhyacophilid caddisflies (Trichoptera)

Extracts of different body parts of adult Trichoptera were tested for electrophysiological activity. Extracts of the IVth and Vth abdominal sternites of femaleHydropsyche angustipennis, Rhyacophila nubila, andR. fasciata, containing a paired exocrine gland, elicited significant electroan-tennographic responses when tested on conspecific male antennae. The paired gland occurs also in males of all the species, and inH. angustipennis, extracts from males were more active than female extracts when tested on male antennae. Female and male extracts from all species were analyzed by gas chromatography with simultaneous flame ionization and electroantennographic detection (EAD). EAD-active peaks in female extracts, stimulating male antennae, were identified inH. angustipennis as nonan-2-one; and inR. nubila andR. fasciata as heptan-2-one, heptan-2-ol, nonan-2-one, and nonan-2-ol. EAD-active components from maleH. angustipennis stimulating male antennae were octan-2-one, nonan-2-one (major peak), (Z)-6-nonen-2-one, decan-2-one, and a methylbranched decan-2-one. Female extracts and synthetic mixtures of compounds identified from femaleH. angustipennis andR. fasciata were tested for attractivity in the field. High catches with control traps obscured the results, but a synthetic mixture of the four identified compounds was significantly attractive and not different from female extracts for attracting maleR. fasciata. InH. angustipennis, a synthetic six-component male blend, in which nonan-2-one was the major component, attracted significant numbers of male and femaleH. angustipennis. Extracts of maleR. nubila andR. fasciata contained acetophenone and hexanoic and octanoic acids but did not have any electrophysiological or behavioral activity on either male or female antennae of conspecifics. The occurrence of a female sex pheromone inRhyacophila and an aggregation pheromone inHydropsyche corresponds to earlier described differences in mating behaviors in the Rhyacophilidae and Hydropsychidae.     

The Polymorphism of Low Erucic Rapeseed Oil with High Content of Palmitic Acid

A new type of low erucic acid rapeseed oil containing high amount (11%) of palmitic acid (C₁₆-LOBRA) was studied, both in labscale and in pilot-plant equipment. The polymorphic behaviour of fat blends and margarine emulsions consisting of C₁₆-LOBRA, LOBRA and soybean oil and their hydrogenated fats were examined. The results clearly show the potential in the hydrogenated C₁₆-LOBRA. The time before the stable ß-form is developed is much longer for the hydrogenated C₁₆-LOBRA compared with the hydrogenated LOBRA and in fact similar to a hydrogenated soybean oil. The hydrogenated C₁₆-LOBRA is therefore well suited to be used in e.g. margarine systems.     

Zur Analyse von Triglyceriden

Analysis of Triglycerides Only recently the analytic of triglycerides of natural fats and oils has found in HPLC an adaquate method. By means of HPLC it is possible to separate the glycerides of the fat with respect to partition number (PN) and to analyse the collected fractions by GLC with respect to carbon number (CN). This procedure yields a complete basis for calculation of the composition of triglyceride groups which are characterized by their carbon number and number of double bonds (e.g. C54:1). If the analytical data of each fraction are completed with the fatty acid composition, the fatty acid combination of the single triglycerides and their distribution can likely be characterized. This method was applied to triglyceride analysis of LOBRA oil. The obtained results are reported.     

Using maleic anhydride grafted poly(lactic acid) as a compatibilizer in poly(lactic acid)/layered‐silicate nanocomposites

The goal of this work was to prepare exfoliated poly(lactic acid) (PLA)/layered‐silicate nanocomposites with maleic anhydride grafted poly(lactic acid) (PLA–MA) as a compatibilizer. Two different layered silicates were used in the study: bentonite and hectorite. The nanocomposites were prepared by the incorporation of each layered silicate (5 wt %) into PLA via solution casting. X‐ray diffraction of the prepared nanocomposites indicated exfoliation of the silicates. However, micrographs from transmission electron microscopy showed the presence of intercalated and partially exfoliated areas. Tensile testing showed improvements in both the tensile modulus and yield strength for all the prepared nanocomposites. The results from the dynamic mechanical thermal analysis showed an improvement in the storage modulus over the entire temperature range for both layered silicates together with a shift in the tan δ peak to higher temperatures. The effect of using PLA–MA differed between the two layered silicates because of a difference in the organic treatment. The bentonite layered silicate showed a more distinct improvement in exfoliation and an increase in the mechanical properties because of the addition of PLA–MA in comparison with the hectorite layered silicate. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 1852–1862, 2006     

Behaviourally constrained contact force optimization

In this paper, the problem of optimizing the contact force distribution between a rigid obstacle and an elastic discrete body is considered. The initial distances between the bodies are taken as design variables and the equilibrium total potential energy as the cost function.A standard result is now that if an isoperimetric design constraint prescribing the gap volume is included, the resulting distribution of contact forces is constant; a desirable property. This article includes an investigation of the outcome when the design constraint is interchanged with general behavioural constraints on the contact forces.Special cases are considered: on one hand, if the sum of all contact forces is prescribed, constant interference is a result, and on the other hand, if the value of each contact force is bounded, the optimization gives constant contact forces.     

表面致密化--一种提高烧结齿轮性能的有效方法

表面致密化与传统的粉末冶金方法相结合，可以显著改善烧结齿轮的疲劳及表面磨损性能。从而提高齿轮的寿命，同时使生产高性能齿轮的总成本降低，为用粉末冶金(PM)方法生产汽车变速箱齿轮提供了更大的可能性。本文着重讲述了使用这种方法生产高性能PM齿轮的工艺过程，同时介绍了测定致密化效果及齿轮性能的几种主要方法，并根据工艺过程比较了使用传统的机加工方法及本文所述的方法生产同性能齿轮的成本差别。最后，以两个实例分别介绍了使用上述方法对Volvo 850系第五挡变速齿轮及Scania载重车变速箱中行星齿轮的研发。     

Vision in and out of vehicles

At the Australian National University's Intelligent Vehicle Project, we are developing subsystems for: driver fatigue or inattention detection; pedestrian spotting; blind-spot checking and merging assistance to validate whether sufficient clearance exists between cars; driver feedback for lane keeping; computer-augmented vision (that is, lane boundary or vehicle highlighting on a head-up display); traffic sign detection and recognition; and human factors research aids Systems that perform such supporting tasks are generally called driver assistance systems (DAS). We believe that implementing DAS could prevent similar accidents or at least reduce their severity.