Quality enhancement of the abundant under‐valued crustacean,lobster krill (Munida spp.), during its chilled storage

Lobster krill (Munida genus) represents an under‐valued crustacean frequently caught on European fishing banks. In this work, its sensory, microbiological and biochemical qualities were evaluated during chilled storage. Additionally, the effects of a prestorage antimelanosic treatment consisting of soaking in sodium metabisulphite (SMB) solutions at two different concentrations (0.25% and 0.75%) were also studied. SMB prestorage treatment provided lobster specimens that still exhibited acceptable sensory quality after 10 days of storage, while control specimens were unacceptable at that time. SMB treatment also resulted in a significant (P < 0.05) inhibition of microbial growth, mainly of Enterobacteriaceae, psychrotrophes and proteolytic bacteria. Low lipid oxidation levels were observed for all batches; however, a significantly higher (P < 0.05) retention of polyunsaturated fatty acids was found in SMB‐treated lobster, especially in the 0.75% SMB batch. The results presented here open the way to the potential commercialisation of currently under‐utilised lobster krill as a chilled product.     

Comprehensive heat exchange model for a semiconductor laser diode

By measuring the total energy flow from an optical device, we can develop new design strategies for thermal stabilization. Here we present a comprehensive model for heat exchange between a semiconductor laser diode and its environment that includes the mechanisms of conduction, convection, and radiation. We perform quantitative measurements of these processes for several devices, deriving parameters such as a laser's heat transfer coefficient, and then demonstrate the feasibility of thermal probing for the nondestructive wafer-scale characterization of optical devices.     

Mechanical improvement of concrete by irradiated polypropylene fibers

Fiber reinforced concrete (FRC) contains fibers physically mixed with gravel, sand, cement, and water. So far, adequate mechanical performance of FRC has been obtained at high cost and using complex technologies; important here is the geometry and surface characteristics of the polymers. We have modified polymeric‐fiber surfaces by using gamma radiation. Irradiated polypropylene (PP) fibers were submitted to 0, 5, 10, 50, and 100 kGy of gamma irradiation dosages. First, tensile strength of PP fibers was evaluated, and then fibers blended at 0, 1.0, 1.5, and 2.0% in volume with Portland cement, gravel, sand, and water. The highest values of compressive strength were obtained with irradiated‐fibers at 10 kGy and 1.5% in volume of fiber. The result is 101 MPa, as compared to 35 MPa for simple concrete without fibers. POLYM. ENG. SCI., 45:1426–1431, 2005. © 2005 Society of Plastics Engineers     

Power sector development in India with CO2 emission targets: Effects of regional grid integration and the role of clean technologies

The power sector in India at present comprises of five separate regional electricity grids having practically no integrated operation in between them. This study analyses the utility planning, environmental and economical effects of integrated power sector development at the national level in which the regional electric grids are developed and operated as one integrated system. It also examines the effects of selected CO₂ emission reduction targets in the power sector and the role of renewable power generation technologies in India. The study shows that the integrated development and operation of the power system at the national level would reduce the total cost including fuel cost by 4912 million $, total capacity addition by 2784 MW, while the emission of CO₂, SO₂ and NO_x would be reduced by 231.6 (1.9%), 0.8 (0.9%), 0.4 (1.2%) million tons, respectively, during the planning horizon. Furthermore, the study shows that the expected unserved energy, one of the indices of generation system reliability, would decrease to 26 GWh under integrated national power system from 5158 GWh. As different levels of CO₂ emission reduction targets were imposed, there is a switching of generation from conventional coal plants to gas fired plants, clean coal technologies and nuclear based plants. As a result the capacity expansion cost has increased. It was found that wind power plant is most attractive and economical in the Indian perspective among the renewable options considered (Solar, wind and biomass). Copyright © 2003 John Wiley & Sons, Ltd.     

Effect of bismuth replacement at barium site in Y-Ba-Cu-O system

X-ray diffraction, electron paramagnetic resonance, microwave absorption and resistivity measurements were carried out on YBa_2−x Bi _x Cu₃O₇ (0≤x≤0·5) superconductors in order to study the effect of bismuth on the structural and superconducting properties. A decrease in sintering temperature increased the amount of impurity phase. Transition from an orthorhombic (superconducting) phase to tetragonal structure produced no significant change in EPR zero-field signal at liquid nitrogen temperature (LNT). The non-resonance signal height decreased on higher concentration of bismuth. Sintered YBa_2−x Bi _x Cu₃O₇ superconductor had a strong EPR zero-field signal at LNT. We have evaluated particle size from XRD and EPR studies. The average particle size was about 0·4μm.     

Corrosion Condition Evaluation at Muddy Creek Bridge

Corrosion rates were measured at the exposed spots of rebars near three corners of Muddy Creek Bridge located in northern West Virginia using a 3LP device. Also, chloride contents of the concrete samples taken from the vicinity of the spots were analyzed using a wet chemical method that had been developed in this study. The average corrosion rate over the three spots was 4.66 mA/m2, which is in the range of corrosion damage possible in 10–15 years. The average chloride content of the concrete over the three spots was 703 parts per million (ppm), which is well above the threshold limit value of 260 ppm. Although the corrosion rate measurement method using a 3LP device is by manual operation, it is found to be reliable and effective, and, thus, recommended for future studies of this kind of research. The wet chemical method developed in this study is found to be effective.     

Compulsory notification of cysticercosis in Ribeir?o Preto-SP, Brazil

Cysticercosis is a severe public health problem in several regions of Asia, Africa and Latin America. Epidemiologic studies based on the frequency of cases observed in specialized neurology, neurosurgery and computed tomography services, at autopsy and in seroepidemiologic studies do not permit the determination of the true prevalence of the disease in the population. The objective of the present study was to investigate the prevalence of cysticercosis by compulsory notification. The coefficient of prevalence was 54 cases/100,000 inhabitants in the municipality of Ribeir?o Preto. The results also indicated that cysticercosis is not under control in our region since 21% of cases presented the active form of the disease. Compulsory notification proved to be a valuable resource for the epidemiologic study of cysticercosis, also permitting the mapping of more affected areas for a better direction of prevention strategies.     

A genetic model for undifferentiated cell tumor formation: similar tumors formed by different cell lines transformed by the E1A oncogene

The activation of oncogenes and the mutation/deletion of suppressor genes may be involved in tumor heterogeneity. In an attempt to study tumor heterogeneity, we transformed cell lines from epithelial (PAM 212), mesenchymal (NIH-3T3), or melanocytic origin (L-BIOBR) with the wild type E1a oncogene. To make the cell lines tumorigenic, cells were infected with Harvey sarcoma virus carrying the v-H-ras oncogene. The transformed cells were injected into nude mice and the tumors studied by optical and electron microscopy. The tumors formed by v-H-ras-transformed cells consisted of epitheliod melanomas, spindle cells sarcomas and poorly-differentiated carcinomas, depending on the cell of origin. In contrast, the tumors obtained from cells also carrying the E1a oncogene showed a predominant small and undifferentiated cell pattern regardless of the cell of origin. We conclude that the E1a oncogene products induce a negative control of differentiation, independent of the cell type, and that tumors formed by cells carrying the E1a oncogene display an undifferentiated cell pattern.