An in vitro model of traumatic neuronal injury: loading rate-dependent changes in acute cytosolic calcium and lactate dehydrogenase release

We developed a new in vitro model of neuronal injury using NT2-N cells to examine the effects of hydrodynamic loading rate on intraneuronal calcium dynamics and lactate dehydrogenase (LDH) release. Our apparatus consisted of a parallel disk viscometer which induced fluid shear stress with well-defined magnitudes and loading rates to cultured cells. We found that the deformation response of the cells was dependent on the severity of the insult, with increased cellular strains generated for higher shear stresses at a constant loading rate. Peak intracellular free calcium concentration correlated with strain, suggesting that mechanical deformation may regulate calcium response. Slowly applied fluid shear stress elicited no response, whereas high loading rates resulted in peak calcium increases 2.9 to 3.6 times baseline values as injury severity was increased. LDH release measured within 5 min after the insult correlated with loading rate. In addition, LDH release continued to increase out to 24 h following high loading rate conditions, demonstrating that the application of fluid shear stress led to prolonged cell damage. The acute response in NT2-N cells subjected to an insult with the CSID is dependent on the loading rate, and these results suggest that initial membrane deformation may trigger subsequent events.     

Intelligent control of the feeding of aluminum electrolytic cells using neural networks

To be efficient, the control of alumina feeding of the electrolytic cell must be based on cell resistance, alumina concentration, and cell state. Most control schemes now in use are based on cell resistance only, and, thus, constitute an open-loop control that lacks robustness because their decision criteria are not explicitly tied to concentration nor to cell state. This results in the cell operating at nonoptimal concentrations, and cell efficiency is diminished. An optimal operation requires a knowledge of concentration and an adjustment of the decision criteria as a function of concentration. A learning vector quantization (LVQ) type of neural network was built and trained to recognize the cell state. Knowing the state of the cell and its resistance, concentration can be estimated using predetermined regression functions. The decision criteria for the control logic are then consequently adapted. A closed-loop control scheme is thus obtained. Results show that, with its control so structured, the cell can operate at or near optimal concentrations independently of its state. This flexible and intelligent character of the neural control can provide a considerable advantage as compared to the standard control.     

Establishment and characterization of three cell lines from Aedes triseriatus (Diptera: Culicidae)

The objectives of this study were to develop sex-, age-, and body size-specific nomograms and partition values for upper and lower limits of M-mode echocardiographic aortic root measurements derived from a large population-based cohort. The study sample consisted of 1433 male and 1816 female participants in the Framingham Heart Study and Framingham Offspring Study who were normotensive and free of clinically apparent heart disease at the baseline examination. Aortic root measurements were obtained by M-mode echocardiography by a leading-edge to leading-edge technique. The relations of age and measures of body size with aortic root dimensions were evaluated with sex-specific correlations and multiple stepwise linear regression analyses. Age was the most important determinant of aortic root size in both men and women in the multivariable regression models. Models with age and body surface area yielded R2 values of 0.214 in men and 0.222 in women. Models with age and height yielded lower R2 values of 0.136 in men and 0.181 in women. Thus aortic root dimensions vary widely with the age, sex, and body size of individuals. Sex-specific reference nomograms of aortic root dimensions in relation to age and body size (body surface area or height) are presented to facilitate the detection of abnormalities of aortic root size.     

Multihour engineering and traffic routing optimization in hierarchical telephone networks

Classical hierarchical routing in telephone networks is extended to a wider class called out-of-chain routing in such a way that some useful properties of hierarchical routing are retained. This new routing pattern offers more potential paths than the fixed hierarchical one and can be introduced as a dynamic routing where the fixed alternate sequences change at some predetermined instants during the day. The effect of this new routing pattern on the network performances is examined. The main topic of this paper is to present heuristic methods used to optimise such routings in large networks. We show on artificial networks that the throughput of a given network can be significantly improved by suitable routing choices. We demonstrate that the integration of routing changes within a multihour dimensioning process is possible but the lack of realistic data does not permit at this time to quantify the value of routing optimization on real networks.     

Study of microstructure and solute partitioning in a cast Ti-48Al-2Cr-2Nb alloy by quenching during directional solidification technique

One major hindrance to effective implementation of cast gamma TiAl-based intermetallic alloys in aircraft engines lies in the variability of their mechanical properties resulting from chemical and microstructural heterogeneities. In the present work, the buildup of microsegregation in a cast Ti-48Al-2Cr-2Nb alloy is investigated through experiments of quenching during directional solidification (QDS). The solidification process, as well as the partitioning of alloying elements, between the solid and liquid phases, is investigated. Considering experimental conditions, the α-hcp phase is found to be the primary solidifying phase. A low dendrite tip temperature of 1475 °C was estimated from thermal recordings. These observations could be explained considering the value of the thermal gradient (around 4 °C/mm). Quantitative values of partition coefficients are proposed for Al, Cr, and Nb. In addition to Al, Cr is found to segregate in interdendritic regions, whereas Nb tends to be retained in the Ti-rich inner dendrites. Considering experimental cumulative solute distributions, the buildup of microsegregation can be satisfactorily represented on the basis of Gulliver-Scheil assumptions. Due to high-temperature quenching, the QDS experiments are also found to be appropriate to the study of high-temperature phase transformations and microstructural development of TiAl-based alloys. The results of QDS experiments are discussed with regard to the range of microstructural and chemical heterogeneities determined within Ti-48Al-2Cr-2Nb investment castings. Finally, regarding solid-state phase transformations subsequent to solidification, the study attempts to explain the formation of B2 phase particles stabilized by the ternary additions. This article is based on a presentation made in the symposium entitled “Fundamentals of Structural Intermetallics,” presented at the 2002 TMS Annual Meeting, February 17–21, 2002, in Seattle, Washington, under the auspices of the ASM and TMS Joint Committee on Mechanical Behavior of Materials.     

Immunolocalization of natriuretic peptide receptor B in the rat kidney

The natriuretic peptide receptor (NPR) family consists of three receptor subtypes: two transmembrane forms that contain a guanylyl cyclase intracellular domain (NPR-A and NPR-B), and one truncated form (NPR-C). Because of the lack of specific agonists and antagonists for each receptor subtype and to the difficulty to detect the presence of small quantities of NPR-B by ligand binding studies, polyclonal antibodies against a peptide whose sequence was chosen from a region of the extracellular domain of rat NPR-B that is not homologous to sequences in NPR-A and NPR-C were developed. Western blotting with affinity-purified anti-NPR-B (413-426)-Tyr revealed a polypeptide of approximately 120 kD on COS-1 cell membranes transfected with rat NPR-B cDNA. The antibody recognized a second polypeptide, approximately 5 to 10 kD smaller, which probably represents the unglycosylated receptor. Anti-NPR-B (413-426)-Tyr did not show crossreactivity to any other NPR. Western blotting analysis with anti-NPR-B (413-426)-Tyr also identified a protein of appropriate size in renal vascular membranes. These results were supported by immunohistochemistry findings that demonstrated staining for NPR-B on papillary and medullary capillaries, glomeruli, and renal arteries. This study concludes that NPR-B is present in the rat kidney, although it was only detected in vascular structures.     

Thermal expansion of helium filled Aerogel at the lambda point

Under reasonable assumptions, we show that He-filled Aerogels should exhibit a strong negative thermal expansion at the point : =–10^–3/K. We observed an expansion smaller than 10^–6/K across the transition. This very strong discrepancy can be related either to (i) specific elastic properties of the gels, (ii) the dependance of T on the pore size is drastically different of what could be expected.     

Association of IgG1 Antibody Clearance with FcγRIIA Polymorphism and Platelet Count in Infliximab-Treated Patients

The FcγRIIA/CD32A is mainly expressed on platelets, myeloid and several endothelial cells. Its affinity is considered insufficient for allowing significant binding of monomeric IgG, while its H131R polymorphism (histidine > arginine at position 131) influences affinity for multimeric IgG2. Platelet FcγRIIA has been reported to contribute to IgG-containing immune-complexe clearance. Given our finding that platelet FcγRIIA actually binds monomeric IgG, we investigated the role of platelets and FcγRIIA in IgG antibody elimination. We used pharmacokinetics analysis of infliximab (IgG1) in individuals with controlled Crohn’s disease. The influence of platelet count and FcγRIIA polymorphism was quantified by multivariate linear modelling. The infliximab half-life increased with R allele number (13.2, 14.4 and 15.6 days for HH, HR and RR patients, respectively). It decreased with increasing platelet count in R carriers: from ≈20 days (RR) and ≈17 days (HR) at 150 × 10⁹/L, respectively, to ≈13 days (both HR and RR) at 350 × 10⁹/L. Moreover, a flow cytometry assay showed that infliximab and monomeric IgG1 bound efficiently to platelet FcγRIIA H and R allotypes, whereas panitumumab and IgG2 bound poorly to the latter. We propose that infliximab (and presumably any IgG1 antibody) elimination is partly due to an unappreciated mechanism dependent on binding to platelet FcγRIIA, which is probably tuned by its affinity for IgG2.     

SOLUBILITY AND DIFFUSIVITY OF GASES IN AN ORGANIC SOLUTION OF AMINE

Solubilities and diffusivities of carbon dioxide and nitrous oxide in a mixture of toluene and isopropanol organic solution of cyclohexylamine were measured at 20°C in the range of pressures of solute from 1 to 3 bars. This was performed with an original chromatographic technique taking into account the presence of the product of the reaction.     

A numerical model for single screw extrusion with poly(vinyl chloride) (PVC) resins

A computer model has been developed to simulate the behavior of molten polymer in the melt conveying zone of extruders. This model, based on a hybrid finite difference/finite element resolution of the equations of change governing momentum and heat transfer, allows the prediction of the pressure profile while accounting for wall end effects as well as the solid bed velocity. Simulation results are compared with analytical and finite difference method results found in the literature. A fairly good agreement is obtained in the case of low density polyethylene. Numerical tests are also carried out with rigid poly(vinyl chloride) compound used for window profile extrusion. The good agreement found between the predictions and experimental measurements obtained on an industrial extruder confirms the performance of the proposed model.