10 Gbit/s optical soliton transmission over 7200 km by using amonolithically integrated MQW-DFB-LD/MQW-EA modulator light source

The authors demonstrate 10 Gbit/s optical soliton transmission in a recirculating loop through the use of a monolithically integrated MQW-DFB-LD/MQW-EA modulator light source. The timing jitter due to the Gordon-Haus effect is successfully reduced by the optical bandpass filters conventionally used in the cascaded EDFAs to avoid the accumulation of amplified spontaneous emission. The transmission distance of 7200 km is achieved at a bit error rate of 10^-9     

Study on the "signal" constituents for the evaluation of animal crude drugs. V. The "signal" constituents for the identification of Lumbricus in cold medicines

Cell death was analyzed in neurulating mouse embryos after in vivo doses of 2-methoxyethanol (2-ME) that produce anterior neural tube defects. Characterization of 2-ME-induced cell death was performed by evaluating: (1) vital fluorochrome staining in whole embryos applying confocal laser scanning microscopy; (2) characteristics of cell debris in conventional histological sections revealed by light microscopy; and (3) Apoptag in situ immunohistochemical staining for apoptosis using light microscopy. Methods for quantification of cell death identified by these three techniques were explored using computerized image analysis. Physiological cell death in control embryos primarily occurred in the neural crest region during neural fold elevation. Embryos exposed to 2-ME had expanded areas of cell death in the neural crest and also new areas of cell death in medial regions of the anterior neural tube. Both physiological and 2-ME-induced embryonic cell death had morphological, immunohistochemical, and fluorochrome staining characteristics of apoptosis. When fluorescence data from confocal microscopic analysis of vital fluorochrome-stained embryos were analyzed, a dose-dependent increase was found in embryos exposed to 2-ME. Similar results were obtained when cell death was analyzed in either conventional histological sections or sections prepared for immunohistochemical detection of apoptosis. The cell death data obtained in this study correlate with previously observed near-term malformation rates, suggesting that a quantitative relationship exists between 2-ME-induced embryonic cell death and neural tube defects.     

Heparin affinity high-performance liquid chromatography as an alternative to bioassay of CS23 mutein of recombinant human basic fibroblast growth factor

We investigated whether a chemical assay by high-performance liquid chromatography (HPLC) as an alternative to the complicated and time-consuming bioassay for CS23 mutein of recombinant human basic fibroblast growth factor (rhbFGF-CS23) using the fetal bovine heart endothelial cell line ATCC CRL 1395. Physically, chemically or enzymatically denatured rhbFGF-CS23 was subjected to heparin affinity (HA)-HPLC and the bioassay. Good agreement was observed between the results obtained by these two methods. Moreover, HA-HPLC gave much more reproducible results (RSD = 1.9%, n = 6) than the bioassay (RSD = 7.4%, n = 18). HA-HPLC is therefore a simple, accurate and reproducible alternative to the bioassay for quality control and stability studies for rhbFGF-CS23 preparations. HA-HPLC is also considered to be applicable to assays for FGFs which have heparin affinity and biological activity similar to those of the CS23 mutein.     

Performance prediction of a hybrid‐excitation synchronous machine with axially arranged excitation poles and permanent‐magnet poles

This paper presents a method of predicting the steady‐state performance of a new hybrid‐excitation synchronous machine (HESM) theoretically. The field pole of this HESM is axially divided into two parts; one is an excitation part and the other a permanent‐magnet (PM) part. A nonlinear equivalent circuit, which can include the saliency of the rotor and the magnetic saturation due to the iron core, is derived. Based on this equivalent circuit, the steady‐state performance of the HESM is calculated, and the results are confirmed through experiments. © 2004 Wiley Periodicals, Inc. Electr Eng Jpn, 150(2): 43–49, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20033     

Electron transport in InGaO3(ZnO)m (m=integer) studied using single-crystalline thin films and transparent MISFETs

We have investigated the characteristics of transparent metal-insulator-semiconductor field-effect transistors (MISFETs) fabricated using InGaO₃(ZnO)_m (m=integer) single-crystalline thin films as n-channel layers and amorphous alumina as gate insulator films. The MISFETs exhibit good characteristics such as insensitivity to visible light illumination, off-current as low as ∼1 nA with a positive threshold voltage of ∼3 V and on/off current ratio of 10⁵. The field-effect mobility increased from ∼1 to ∼10 cm² (V s)⁻¹ as the m-value increased. Room temperature Hall mobility also increased. However, unexpectedly these values were lower than the field-effect mobility. It is explained by existence of shallow localized state in the homologous compounds.     

Effects of nondensifying inclusions on the densification and microstructure of zinc oxide matrix composites

The densification and microstructure development of ZnO containing Zn₇Sb₂O₁₂, ZrO₂, and aggregated ZnO were investigated to elucidate the effect of nondensifying inclusions on the sintering of ceramic/ceramic composites. The inclusion retarded the densification, and the degree of retardation was found to depend on the chemical species of inclusion; Zn₇Sb₂O₁₂ had the largest effect, followed by ZrO₂ and then aggregated ZnO last. The experimental results for aggregated ZnO was explained by the theory which predicts the generation of backstresses. The backstresses give a less significant effect on the densification. For Zn₇Sb₂O₁₂ and ZrO₂, the microstructure of the matrix varied with distance from an inclusion particle; much porosity was observed in the region surrounding the inclusion. Circumferential voids, which are responsible for the suppression of densification, form during the initial stage of sintering. Inclusion particles generate an anchoring effect which retards the densification of the matrix immediately surrounding the inclusion particle during the intermediate stage.Supported by the Inamori Foundation.     

The effects of R-75,317 on antiglomerular basement membrane glomerulonephritis in rats

Platelet-activating factor (PAF) is a potent inflammatory mediator which is released by various inflammatory cells and produced by certain tissues, including the kidney. PAF has been shown to increase glomerular permeability to protein and to decrease glomerular filtration rate (GFR) by contracting mesangium. On the basis of these observations, it has been suspected that PAF may play a role as mediator of glomerular damage in glomerular nephritis. To examine this possibility, we studied the effects of a specific PAF antagonist, R-75,317, on the development of an experimental model of anti-glomerular basement membrane (anti-GBM) glomerulonephritis. Glomerulonephritis was initiated by injecting rabbit anti-rat GBM serum into rats. Proteinuria gradually developed after serum injection, plateaued at week 2, and remained at the high level of week 2 throughout the experimental period (6 wk). Chronic treatment with R-75,317 (10 mg/kg/day i.p.) tended to delay the onset of proteinuria and significantly accelerated the recovery phase. Creatinine clearance (Ccr) fell to 40% at week 3. R-75,317 treatment completely prevented this decline of Ccr. Histological changes in this model (glomerular hypertrophy, proliferation of mesangial matrix and interstitial fibrosis) were also ameliorated by the R-75,317 treatment. The results suggest that PAF may play a role in the development of glomerulonephritis and that PAF antagonists could be used in the treatment of human renal disease. Based on a paper presented at the Third International Conference on Platelet-Activating Factor and Structurally Related Alkyl Ether Lipids, May 1989.     

Cooling condition dependence on ion etching rate in a softmagnetic metallic glass

Taking into consideration the knock-on cascade mechanism and the free volume theory, the cooling condition dependentR _s (ion etching rate) is investigated for a liquid-quenched Fe-10at%Si-15at%B alloy glass. A highR _s is found in a slow cooled glass.