1/f noise in large-area Hg<Subscript>1−x</Subscript>Cd<Subscript>x</Subscript>Te photodiodes

The 1/f noise in photovoltaic (PV) molecular-beam epitaxy (MBE)-grown Hg_1−xCd_xTe double-layer planar heterostructure (DLPH) large-area detectors is a critical noise component with the potential to limit sensitivity of the cross-track infrared sounder (CrIS) instrument. Therefore, an understanding of the origins and mechanisms of noise currents in these PV detectors is of great importance. Excess low-frequency noise has been measured on a number of 1000-μm-diameter active-area detectors of varying “quality” (i.e., having a wide range of I-V characteristics at 78 K). The 1/f noise was measured as a function of cut-off wavelength under illuminated conditions. For short-wave infrared (SWIR) detectors at 98 K, minimal 1/f noise was measured when the total current was dominated by diffusion with white noise spectral density in the mid-10⁻¹⁵A/Hz^1/2 range. For SWIR detectors dominated by other than diffusion current, the ratio, α, of the noise current in unit bandwidth i_n(f = 1 Hz, V_d = −60 mV, and Δf = 1 Hz) to dark current I_d(V_d = −60 mV) was α_SW-d = i_n/I_d ∼ 1 × 10⁻³. The SWIR detectors measured at 0 mV under illuminated conditions had median α_SW-P = i_n/I_ph ∼ 7 × 10⁻⁶. For mid-wave infrared (MWIR) detectors, α_MW-d = i_n/I_d ∼ 2 × 10⁻⁴, due to tunneling current contributions to the 1/f noise. Measurements on forty-nine 1000-μm-diameter MWIR detectors under illuminated conditions at 98 K and −60 mV bias resulted in α_MW-P = i_n/I_ph = 4.16 ± 1.69 × 10⁻⁶. A significant point to note is that the photo-induced noise spectra are nearly identical at 0 mV and 100 mV reverse bias, with a noise-current-to-photocurrent ratio, α_MW-P, in the mid 10⁻⁶ range. For long-wave infrared (LWIR) detectors measured at 78 K, the ratio, α_LW-d = i_n/I_d ∼ 6 × 10⁻⁶, for the best performers. The majority of the LWIR detectors exhibited α_LW-d on the order of 2 × 10⁻⁵. The photo-induced 1/f noise had α_LW-P = i_n/I_ph ∼ 5 × 10⁻⁶. The value of the noise-current-to-dark-current ratio, α appears to increase with increasing bandgap. It is not clear if this is due to different current mechanisms impacting 1/f noise performance. Measurements on detectors of different bandgaps are needed at temperatures where diffusion current is the dominant current. Excess low-frequency noise measurements made as a function of detector reverse bias indicate 1/f noise may result primarily from the dominant current mechanism at each particular bias. The 1/f noise was not a direct function of the applied bias.     

Health promotion for women with physical disabilities: A pilot study.

Objective: To pilot test a health promotion intervention for women with physical disabilities. Design: Pre- and postintervention questionnaires. Participants: Two groups of women with physical disabilities (n=15). Intervention: Seven-session weekly workshop intervention grounded primarily in social-cognitive theory. Setting: Disability and rehabilitation settings. Main Outcome Measures: Indicators of health status. Results: Statistically significant positive changes between pre- and postintervention scores on measures of self-efficacy for dietary behaviors, medical decision making, social interaction, physical functioning, impact of physical limitation on role activities, and vitality. Conclusion: Women with disabilities who participate in this health promotion intervention may exhibit improvements on indicators of health status. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Performance characteristics of a therapeutic ultrasound wire waveguide apparatus

Therapeutic ultrasound angioplasty has been investigated, clinically, by a number of researchers and represents a potentially promising therapy for the treatment of atherosclerotic lesions. To date, there has been no detailed analysis of the effect of mechanical design parameters, such as wire geometry or damping characteristics, on wire waveguide performance. An apparatus capable of delivering therapeutic ultrasound down small diameter nickel–titanium (NiTi) wire waveguides is described. The output peak-to-peak (p–p) displacements at the distal tip of a 1.0 mm diameter waveguide were measured experimentally, by means of an optical microscope and image analysis software. The output was measured for a range of waveguide lengths from 118 to 303 mm. Wire waveguide distal tip displacements as high as 98 μm (p–p) at 23.5 kHz were measured. For the range of lengths tested, the experimental measurements show the critical relationship between the length of the waveguide and the output distal tip displacements. A finite element model that can predict the resonant frequencies and distal tip displacements of various wire waveguide geometries and configurations, including the effect of damping, is presented. This numerical model has been validated against the experimental displacement data obtained. This will be a valuable design tool for ensuring the safety and effectiveness of therapeutic ultrasound angioplasty procedures.     

Application of the Soil and Water Assessment Tool for six watersheds of Lake Erie: Model parameterization and calibration

The Soil and Water Assessment Tool (SWAT), a physically-based watershed-scale model, holds promise as a means to predict tributary sediment and nutrient loads to the Laurentian Great Lakes. In the present study, model performance is compared across six watersheds draining into Lake Erie to determine the applicability of SWAT to watersheds of differing characteristics. After initial model parameterization, the Huron, Raisin, Maumee, Sandusky, Cuyahoga, and Grand SWAT models were calibrated (1998-2001) and confirmed, or validated (2002-2005), individually for stream water discharge, sediment loads, and nutrient loads (total P, soluble reactive P, total N, and nitrate) based on available datasets. SWAT effectively predicted hydrology and sediments across a range of watershed characteristics. SWAT estimation of nutrient loads was weaker although still satisfactory at least two-thirds of the time across all nutrient parameters and watersheds. SWAT model performance was most satisfactory in agricultural and forested watersheds, and was less so in urbanized settings. Model performance was influenced by the availability of observational data with high sampling frequency and long duration for calibration and confirmation evaluation. In some instances, it appeared that parameter adjustments that improved calibration of hydrology negatively affected subsequent sediment and nutrient calibration, suggesting trade-offs in calibrating for hydrologic vs. water quality model performance. Despite these considerations, SWAT accurately predicted average stream discharge, sediment loads, and nutrient loads for the Raisin, Maumee, Sandusky, and Grand watersheds such that future use of these SWAT models for various scenario testing is reasonable and warranted.     

Multidimensionality of oral health in dentate adults

OBJECTIVES: An understanding of the validity and usefulness of self-reported measures (as distinct from clinically determined measures) of oral health is emerging. These self-reported measures include self-rated oral health (SROH). Three objectives were to: (1) describe self-rated oral health in dentate adults, (2) quantify associations between self-rated oral health and other measures of oral health (oral disease and tissue damage, pain and discomfort, functional limitation, and disadvantage), and (3) assess the construct validity of a model of oral health proposed herein. METHODS: The Florida Dental Care Study is a longitudinal study of oral health, which included at baseline 873 subjects who had at least one tooth, were 45 years or older, and who participated for an interview and clinical examination. RESULTS: The prevalence of self-rated oral health decrements was substantial; approximately one fourth of subjects reported their oral health as only fair or poor. Bivariate and multivariate results provided consistent evidence of the construct validity of the proposed model of oral health. Additionally, the salience of one measure of dental appearance suggests that persons may use esthetic cues when rating their oral health. CONCLUSIONS: The proposed multidimensional model of oral health has construct validity. Self-rated oral health is affected by oral disease and tissue damage, oral pain and discomfort, oral functional limitation, and oral disadvantage. These self-reported measures and the proposed model should provide useful information for dental care effectiveness research. General health status has been disaggregated into the "physical" and the "mental;" an additional separation into the "oral" aspects of health seems warranted.     

Using ICESat's Geoscience Laser Altimeter System (GLAS) to assess large-scale forest disturbance caused by hurricane Katrina

In 2005, hurricane Katrina resulted in a large disturbance to U.S. forests. Recent estimates of damage from hurricane Katrina have relied primarily on optical remote sensing and field data. This paper is the first large-scale study to use satellite-based lidar data to quantify changes in forest structure from that event. GLAS data for the years prior to and following hurricane Katrina were compared to wind speed, forest cover, and damage data to assess the adequacy of sensor sampling, and to estimate changes in Mean Canopy Height (MCH) over all areas that experienced tropical force winds and greater. Statistically significant decreases in MCH post-Katrina were found to increase with wind intensity: Tropical Storm ?MCH = − 0.5 m, Category 1 ?MCH = − 2 m, and Category 2 ?MCH = − 4 m. A strong relationship was also found between changes in non-photosynthetic vegetation (?NPV), a metric previously shown to be related to storm damage, and post-storm MCH. The season of data acquisition was shown to influence calculations of MCH and MCH loss, but did not preclude the detection of major large-scale patterns of damage. Results from this study show promise for using space-borne lidar for large-scale assessments of forest disturbance, and highlight the need for future data on vegetation structure from space.     

Analysis of factors contributing to success in a program of micromanipulation-assisted fertilization

OBJECTIVE: To determine factors important to clinical success in micromanipulation-assisted in vitro fertilization (IVF). DESIGN: Procedures invoked in two separate series of micromanipulation-assisted IVF cycles, one unsuccessful (series I) and the other successful (series II), were compared in an effort to identify changes that led to clinical success. SETTING: University-based IVF clinic. PATIENTS: In both IVF series involving micromanipulation, patients consisted of infertile couples who fit any of five categories of male-factor related infertility. The female patients underwent controlled hyperstimulation for oocyte retrieval and the oocytes were inseminated normally or were subjected either to partial zona dissection or subzonal sperm insertion to assist fertilization. Results in all groups were compared between the two patient series. RESULTS: In the successful series II, a noticeable improvement in fertilization rate and embryo quality was observed compared with series I. A significant increase in the percentage of patients reaching embryo transfer, the pregnancy rate per transfer, and the pregnancy rate per retrieval were noted in series II; a 25% ongoing pregnancy rate per retrieval was observed overall in this successful group, with "ongoing" defined as manifestation of at least a fetal sac on ultrasound with no detectable problems. Patients with a mixed transfer of embryos derived from manipulated and normally inseminated oocytes had a 75% rate of pregnancy per transfer in series II. Differences between the two series could not be attributed to patient selection or biases in selection of oocytes relegated to micromanipulation. However, oocyte handling, micromanipulation, and culture protocols differed significantly between the two series in that temperature and pH of oocytes was better controlled, and micromanipulation time was minimized in series II. CONCLUSION: Success in micromanipulation depends on maintenance of the oocyte in a stable and supportive environment throughout the micromanipulation procedure. It is also important to minimize trauma to the eggs by performing micromanipulation rapidly and with minimal distortion of the egg. Patients with a poor fertilization rate in standard IVF may experience a substantial increase in the likelihood of pregnancy when micromanipulation-assisted fertilization is performed on some eggs.     

Great Lakes total phosphorus revisited: 1. Loading analysis and update (1994–2008)

Phosphorus load estimates have been updated for all of the Great Lakes with an emphasis on lakes Superior, Michigan, Huron and Ontario for 1994–2008. Lake Erie phosphorus loads have been kept current with previous work and for completeness are reported here. A combination of modeling and data analysis is employed to evaluate whether target loads established by the Great Lakes Water Quality Agreement (GLWQA, 1978, Annex 3) have been and are currently being met. Data from federal, state, and provincial agencies were assembled and processed to yield annual estimates for all lakes and sources. A mass-balance model was used to check the consistency of loads and to estimate interlake transport. The analysis suggests that the GLWQA target loads have been consistently met for the main bodies of lakes Superior, Michigan and Huron. However, exceedances still persist for Saginaw Bay. For lakes Erie and Ontario, loadings are currently estimated to be at or just under the target (with some notable exceptions). Because interannual variability is high, the target loads have not been met consistently for the lower Great Lakes. The analysis also indicates that, because of decreasing TP concentrations in the lakes, interlake transport of TP has declined significantly since the mid-1970s. Thus, it is important that these changes be included in future assessments of compliance with TP load targets. Finally, detailed tables of the yearly (1994–2008) estimates are provided, as well as annual summaries by lake tributary basin (in Supplementary Information).     

Stereotype Threat and Group Differences in Test Performance: A Question of Measurement Invariance.

Studies into the effects of stereotype threat (ST) on test performance have shed new light on race and sex differences in achievement and intelligence test scores. In this article, the authors relate ST theory to the psychometric concept of measurement invariance and show that ST effects may be viewed as a source of measurement bias. As such, ST effects are detectable by means of multigroup confirmatory factor analysis. This enables research into the generalizability of ST effects to real-life or high-stakes testing. The modeling approach is described in detail and applied to 3 experiments in which the amount of ST for minorities and women was manipulated. Results indicate that ST results in measurement bias of intelligence and mathematics tests. (PsycINFO Database Record (c) 2010 APA, all rights reserved)