Computation of mutual entropy in quantum markov chains

There are several damping phenomena in quantum optics. Such phenomena have been usually explained by open systems. In statistical physics, open system dynamics have been used to study the irreversibility and the approach to equilibrium. In this paper, the dynamical change of the mutual entropy for an open system, frequently studied in the quantum optics literature, is rigorously computed through a model of quantum Markov chain. In particular, the concrete formula of Stinespring expression for such a model is obtained and applied to the derivation of the mutual entropy, and some computational results are presented.     

Wear-resistant magnetic head using amorphous alloy material

An audio recording/playback head using an amorphous (Fe-Co-Ru-Cr) ₇₅(Si-B)₂₅ alloy was developed. Compared with a commercial Sendust head, three excellent features were observed. The wear of the amorphous alloy head when used with γ-Fe₂O ₃ is two-thirds that of the Sendust head. The output level at high-frequency (14 kHz) is 5 dB higher than that of the Sendust head. The bias current for the amorphous alloy head is half that of the Sendust head     

Time-dependent deformation in an enhanced SiC/SiC composite

Time-dependent deformation in an enhanced SiC/SiC composite has been studied under constant load at high temperatures of 1200 °C, 1300 °C, and 1400 °C. Creep damage evolution was evaluated by a Young’s-modulus change of partial unloading and microscopic observation. The addition of the glassy phase in the matrix is very effective for protecting the composite from oxidation. The transient creep is dominant in creep life at all the temperatures. An empirical equation is proposed to describe creep behavior of the composite. It is found that creep activation energy increases with creep time at stresses lower than matrix cracking stress, but the activation energy remains constant at stresses higher than the matrix cracking stress. The creep strain rate of the composite is considered to be controlled by creep of fibers based on examining the time, strain, stress, and temperature dependencies of creep strain rates.     

Properties of Quaternary Alloy Magnetic Semiconductor (InGaMn)As Grown on InP

We have studied properties of quaternary alloy magnetic semiconductor (InGaMn)As grown on InP substrates by low-temperature molecular-beam epitaxy (LT-MBE). A large MCD peak whose intensity is larger than 500 mdeg for (InGaMn)As was observed. This peak intensity was about three times larger than that of typical (GaMn)As films. Relatively high Curie temperature of 83 K of [(In_0.53Ga_0.47)_0.88Mn_0.12]As was observed by Hall measurements. The carrier concentration of [(In_0.53Ga_0.47)_0.88Mn_0.12]As was estimated to be more than 1.0 × 10²¹ cm^–3 by using the Curie–Weiss fitting of the Hall coefficient R _H, indicating that more than 40% of Mn atoms are activated. This means that (InGaMn)As has a higher activation ratio of Mn as acceptors than (GaMn)As.     

Radiation tolerance for the SMASH-series front-end chips for a silicon micro-strip detector

The radiation tolerance for prototype front-end chips designed for a silicon micro-strip detector was examined with a ⁶⁰Co irradiation source to establish an allowable range of the radiation dose. The irradiated front-end chips were SMA²SH-64A, a 64-channel preamplifier array; SMA²SH-1, a single-channel preamplifier circuit with a comparator; and Control-C, a digital-control chip for the preamplifiers.     

Effective thermal conductivity of compressed woods

Compression is one solution to improve the strength of softwoods. The effective thermal conductivities of compressed Japanese cedars (cryptomeria japonica), which were compressed in the radial direction of the wood, were measured. Both the effective thermal conductivities in the tangential and fiber directions increase proportionally to the density increment due to the compression. However, the thermal conductivity in the radial direction (compression direction) increases slightly with the density increment. Numerical computations were conducted to explain the characteristics of thermal conductivity in the radial direction by using a microscopic heat conduction model for the compressed wood. The numerical results were compared with the measured values. And the physical mechanism of the heat conduction in the compressed woods is discussed.     

Development of a single loop EPR test method and its relation to grain boundary microchemistry for alloy 600

A single loop electrochemical potentiokinetic reactivation test method has been developed for alloy 600 that produces good passivation on all the surfaces, good etching during the reactivation scan and no appreciable pitting. It is able to quantify and discriminate between samples with a wide range of degree of sensitization. The Pa value correlates well with the minimum level of chromium in the depletion regions at the grain boundaries. It has been shown that the width of the attacked regions is much larger than the width of chromium depletion regions and it does not show any direct correlation with either depth or width or with a volume parameter of chromium depletion regions. It has been shown that the chromium carbides are not attacked during the test and that the intragranular regions attacked during the test are the sites of chromium carbides in the grain matrix. A modified Pa parameter is shown to be sensitive down to 7.5 wt% chromium in the depletion regions and indicates that the intragranular carbides have shallower depletion profiles than those at grain boundaries. Comparison of the results of the single loop and the double loop tests showed a good correlation.     

Recovery retardation in equal channel angular pressed Al–Zr alloy during friction stir welding

The effect of Zr on reduction of hardness and microstructure in an FS weld of equal channel angular-pressed Al alloy was investigated. Zr addition to Al suppressed dynamic recovery in the thermomechanically affected zone and enabled retention of the high hardness of the ECA-pressed material throughout the weld.     

Narrow spectral linewidth characteristics of monolithic integrated-passive-cavity InGaAsP/InP semiconductor lasers

The spectral linewidth of 1.3 ?m monolithic integrated-passive-cavity (IPC) semiconductor laser is measured by a delayed self-heterodyne technique. It is found that the line-width is narrowed when longitudinal submode is suppressed. The narrowest linewidth obtained so far is 900 kHz at 6 mW output power.     

Lipid-Lowering Effect of Eriocitrin, the Main Flavonoid in Lemon Fruit, in Rats on a High-Fat and High-Cholesterol Diet

ABSTRACT:  Eriocitrin (eriodictyol 7- O -β-rutinoside) is the main flavonoid in lemon fruit. In this study, eriocitrin was investigated for its lowering effect on serum and hepatic lipids in high-fat and high-cholesterol fed rats. Rats in the control group ( N = 6) were fed a 20% lard and 1% cholesterol diet for 21 d, and rats in the 0.35% eriocitrin group ( N = 6) and 0.70% eriocitrin group ( N = 6) were fed a diet supplemented with eriocitrin 0.35% and 0.70%, respectively. The content of hepatic total cholesterol and triglyceride in the eriocitrin group was no different from that of the control group. The total cholesterol, VLDL+LDL, triglyceride, and phospholipid in the serum of the 0.35% eriocitrin group showed significantly lower concentrations than the control group ( P < 0.05), although there was no difference in the HDL concentrations among the groups. The lowering effect of eriocitrin for serum total cholesterol was thought to be caused by a decrease in VLDL+LDL. The 0.35% eriocitrin group was shown to have a significant increase in excretion of fecal bile acid ( P < 0.05) and a tendency for enhanced hepatic m-RNA levels of LDL receptor in comparison with the control group.