Experimental and Computational Chemistry Studies on the Inhibition Efficiency of Phthalic Acid (PHA) for the Corrosion of Aluminum in Hydrochloric and Tetraoxosulphate (VI) Acids

Protection of Metals and Physical Chemistry of Surfaces - In this work, phthalic acid is investigated for its corrosion inhibition properties (for aluminum in solutions of HCl and H2SO4) through...     

Visible transmission spectroscopy for the assessment of egg freshness

The objective of this research was to investigate the feasibility of visible transmission spectroscopy for the non‐destructive assessment of the freshness of an individual egg. A total of 600 intact white‐shelled eggs of the same flock (Lohmann, 40 weeks of age) were measured. To obtain a considerable variation in freshness, groups consisting of 60 eggs were stored (18 °C, 55% RH) for 0, 2, 4, 6, 8, 10, 12, 14, 16 and 18 days. The non‐destructive spectral measurements were compared with the two most widely used destructive freshness parameters, namely Haugh units and albumen pH. A partial least squares (PLS1) model was built in order to predict Haugh units and pH of the albumen based on the transmission spectra. The correlation coefficients between the predicted value and the measured value were 0.842 and 0.867 for Haugh unit and pH of the albumen, respectively. These results show that the light transmission spectrum of an egg provides quantitative information about egg freshness. Relevant information concerning egg freshness is restricted to the interval between 570 and 750 nm. Furthermore, the models obtained for both destructive parameters were strikingly similar, indicating that Haugh unit and pH have the same physico‐chemical background. Copyright © 2006 Society of Chemical Industry     

Growth of highly orientated strontium barium niobate thin films on Si substrates through the sol–gel process using a K: SBN template layer

We report the growth of highly C-axis orientation of Sr _x Ba_1−x Nb₂O₆ (SBN) thin films on p-type (100) Si substrates by using a potassium-substituted SBN template layer with the sol–gel method. The crystallization of SBN thin films was found closely related to the potassium ion doping concentration and the postannealing temperature of the K-SBN template layer. Secondary ion mass spectrometry analysis showed that potassium elements were accumulated at the interface of the template layer and silicon substrate. SBN films postannealed at 750 °C with K-SBN template layer has a smaller full width at half maximum of X-ray rocking curve of 2.45° than that of 5.40° for the pure SBN films. By introducing a template layer, the surface morphologies of SBN films fabricated on silicon substrate were greatly improved.     

Effect of beam voltage on the properties of aluminium nitride prepared by ion beam assisted deposition

The effects of nitrogen-beam voltage on the structure, stress, energy band gap and hardness of AIN thin films deposited on Si (111), Si (100) and sapphire (0001) by ion beam assisted deposition (IBAD) are reported. As the nitrogen-beam voltage was increased from 50 to 200 V, the stress and disorder in the AIN films increased as determined by X-ray diffraction, FTIR and Raman spectroscopy. The preferred orientation of the film's c-axis changed from completely normal to the film at 100 V, to a mixture of normal and in the plane of the film at 200 V. For AIN films deposited under the same conditions, the films were more highly oriented on sapphire (0001) than in Si (111). The hardness of the films increased from 18.2 to 23.7 GPa with the nitrogen-beam voltage, and possible reasons for this change in hardness are considered.     

Essential contribution of caspase 3/CPP32 to apoptosis and its associated nuclear changes

Caspases are fundamental components of the mammalian apoptotic machinery, but the precise contribution of individual caspases is controversial. CPP32 (caspase 3) is a prototypical caspase that becomes activated during apoptosis. In this study, we took a comprehensive approach to examining the role of CPP32 in apoptosis using mice, embryonic stem (ES) cells, and mouse embryonic fibroblasts (MEFs) deficient for CPP32. CPP32(ex3-/-) mice have reduced viability and, consistent with an earlier report, display defective neuronal apoptosis and neurological defects. Inactivation of CPP32 dramatically reduces apoptosis in diverse settings, including activation-induced cell death (AICD) of peripheral T cells, as well as chemotherapy-induced apoptosis of oncogenically transformed CPP32(-/-) MEFs. As well, the requirement for CPP32 can be remarkably stimulus-dependent: In ES cells, CPP32 is necessary for efficient apoptosis following UV- but not gamma-irradiation. Conversely, the same stimulus can show a tissue-specific dependence on CPP32: Hence, TNFalpha treatment induces normal levels of apoptosis in CPP32 deficient thymocytes, but defective apoptosis in oncogenically transformed MEFs. Finally, in some settings, CPP32 is required for certain apoptotic events but not others: Select CPP32(ex3-/-) cell types undergoing cell death are incapable of chromatin condensation and DNA degradation, but display other hallmarks of apoptosis. Together, these results indicate that CPP32 is an essential component in apoptotic events that is remarkably system- and stimulus-dependent. Consequently, drugs that inhibit CPP32 may preferentially disrupt specific forms of cell death.     

Change of foot size with weightbearing. A study of 2829 children 3 to 18 years of age

The change of foot length and width with age has been reported in a few anthropometric studies in the literature. However, the relationship with body height rarely is reported, and the dynamic effect of weightbearing on foot size has not been documented. In this series, 2829 children 3 to 18 years of age of equal gender distribution were included in the study. The foot length and width on weightbearing and nonweightbearing were measured with a special precision electronic caliper. The foot length and width were found to increase linearly from the age of 3 years until 12 years in girls and 15 years in boys. This was followed by a phase during which the increase plateaued. The foot length and width increased significantly on weightbearing at all ages in both genders with a mean of 2.1 to 4.4 mm or 3.1% to 4.8%, respectively. The foot length and width also were found to correlate significantly with the body height in both genders, with a correlation coefficient of 0.96 to 0.98. No significant differences were found between the sizes of the dominant and nondominant foot in either gender.     

Virtual Teams: Guide to Successful Implementation

The successful initiation and execution of a virtual team is gaining increasing attention in the design and construction community. From opportunities to integrate international and multidisciplinary teams to the opportunity to leverage the best resources in an organization on a given project, virtual teams can transform the concept of project planning and execution. However, potential barriers exist in several areas to the successful implementation of virtual teams. The needs of increased management emphasis, social and cultural understanding, and emphasis on common goals are only a few of the nontechnical factors that can turn successful virtual teaming into virtual frustration. When combined with traditional technical challenges including compatibility of systems, security, and the selection of appropriate technologies, the line between leveraging virtual technologies for enhanced solutions and introducing additional complications into the project process is one that can be easily crossed. This paper presents the findings of research that addresses the opportunities and potential barriers to successful virtual teams in the engineering, procurement, and construction industry. Combining results from current research, industry practices, and early results from nonconstruction industries, the research findings provide an initial path to successful virtual team implementation.     

Two-step channel selection-a novel technique for reconfigurable multistandard transceiver front-ends

This paper starts with a review of the prevailing channel-selection techniques utilized so far in the design of wireless transceiver analog front-ends before describing a novel two-step channel-selection technique, which handles the traditionally unwanted image, in radio frequency-to-intermediate frequency (RF-to-IF) or IF-to-RF frequency conversion, as a useful adjacent channel of the desired one, and selects deliberately either of them from IF to baseband (or baseband to IF). Thus, one more channel-selection possibility is created for both low-IF receivers and two-step-up transmitters. The consequential benefits of introducing channel selection at IF consist of two. First, many design specifications (such as phase noise and settling time) of the RF frequency synthesizer and local oscillator can be substantially relaxed. Second, a low-IF/zero-IF reconfigurable receiver and a direct-up/two-step-up reconfigurable transmitter can be synthesized to match better with narrowband-wideband-mixed multistandard systems. The operating principles of such architectures are presented in easy-to-understand complex-signal spectral-flow illustrations, and their practicability is demonstrated in the design of a Bluetooth/IEEE 802.11FH/HomeRF multistandard receiver. SPECTRE simulation results validate the reconfigurable functionalities mainly implemented by a triple-mode channel-select filter and a multifunctional sampling-mixer scheme.