Characterization of Aluminum Foam Impact Response

Strength of Materials - The paper addresses the investigation of high-strain rate compressive behavior of Al foams subjected to impact at the intermediate striking velocity ranged from 40 to...     

Photoinduced recovery of gamma-irradiated fluoride glasses

Radiation-induced changes in the optical properties of fluoride glasses (FGs) were studied on samples of zirconium fluoride and aluminum fluoride based compositions gamma-irradiated to a total dose of 1.2 MGy. Upon exposure, the fundamental absorption edge smears and shifts toward longer wavelengths. The FGs studied exhibit self-recovery of the optical properties, whereby the radiation-induced absorption decreases in the course of storage without action of any external factors. Photostimulated recovery of the optical properties of the gamma-irradiated FGs was studied in the range of light wavelengths from 400 to 1200 nm at a light intensity of 1–3 mW/cm². The maximum rate of recovery for both zirconium and aluminum fluoride based glasses was observed for the photoannealing at 600 nm.     

Precision Spectrometric Determination of Th and Pu in Solutions with Arsenazo III Using Internal Standardization

A spectrophotometric procedure with internal standardization was suggested for precision determination of the concentrations of Th and Pu in the form of colored complexes with arsenazo III in nitric acid solutions. The sensitivity of the method was significantly improved owing to the use of colored complexes. The optical density optimum (0.3-0.5) of the solutions for spectrophotometric measurements can be achieved at concentrations in solution of the element analyzed as low as (2-3) ×10^-6 M, at the arsenazo and HNO₃ concentrations of 1 ×10^-4 and 6 M, respectively. With this composition of the solution, the relative rms deviation of the results for a single run is no greater than 0.15 and 0.3% for thorium and plutonium, respectively.     

Rehabilitation of the radioactively contaminated objects and territory of the Russian Science Center Kurchatov Institute

This article is devoted to work done in 2002–2006 as part of the unified project Reabilitatsiya to rehabilitate radiation hazardous objects and sections of the radioactively contaminated territory of the Russian Science Center Kurchatov Institute. The main objects of the rehabilitation work were old storage sites built for radioactive wastes on the territory of the Institute when military and civilian nuclear technologies were under development. The structural features of the storage sites, including the volumes and characteristics of the wastes stored, are presented. The salient aspects of the disposal sites, taken into account during the rehabilitation work, are discussed. The organization of the rehabilitation operations and the sequence in which they are performed, the special features of the technical design solutions used, the technological methods, and ways for conducting the work are described. __________ Translated from Atomnaya énergiya, Vol. 102, No. 5, pp. 300–306, May, 2007.     

Optical properties of doped bismuth telluride crystals in the region of plasma effects

The optical properties of bismuth telluride crystals doped with donor-and acceptor-type impurities are studied. The fact that energy corresponding to the resonance frequency of plasma oscillations of free charge carriers (plasmons) approaches the band-gap energy is detected in the infrared spectral region, where the main elementary excitations in the electronic system of these materials are observed. The mentioned approach of energies varies the intensity of electron-plasmon interaction, which affects the recombination processes in the materials widely used for the fabrication of thermoelectric energy converters.     

SVBR-75/100 Multipurpose Modular Low-Power Fast Reactor with Lead–Bismuth Coolant

The results of development work on the SVBR-75/100 modular fast reactor cooled by lead–bismuth coolant are presented. The design is based on the experience gained operating reactors in nuclear-powered submarines. The SVBR-75/100 reactor is inherently safe because of its low power, the chemical inertness and high boiling point of the lead–bismuth coolant, and the integrated basin-type arrangement of the first-loop equipment. This eliminates the conflict between the safety and economic requirements that is characteristic of conventional-type reactors. The lower power makes it possible to build the reactor in a factory and deliver the reactor using any form of transportation to the nuclear power plant site. All safety systems operate passively. Most of these systems are used as normal-operating systems. This creates conditions for multipurpose applications of such reactor modules in developed and developing countries.     

Life Calculations for Header – PGV-1000 Steam Generator Connector Weld Joints under NPP Service Conditions

The procedure for calculating the life of header – steam generator connector weld joints is proposed. It allows for running out the material plasticity reserve upon static cyclic elastoplastic loading as well as operating conditions, local stress concentrations, and residual stresses after welding.