Text-to-picture tools,systems, and approaches: a survey

Multimedia Tools and Applications - Text-to-picture systems attempt to facilitate high-level, user-friendly communication between humans and computers while promoting understanding of natural...     

Radiolabeling,Preparation, and Bioevaluation of 99mTc-Azathioprine as a Potential Targeting Agent for Solid Tumor Imaging

Radiochemistry - Azathioprine, an antitumor agent, was labeled with 99mTc using stannous chloride dihydrate as a reducing agent. Factors such as the amounts of the reducing agent and substrate, pH,...     

Antimicrobial residues survey by LC-MS in food-producing animals in Lebanon

ABSTRACT

The treatment of animals with antimicrobial products may lead to the contamination of edible tissues by their residues, which may represent a risk to human health. Therefore, this study aimed to determine the level of antimicrobial residues in food-producing animals (chicken, beef, and milk) in Lebanon. A total of 310 samples were collected and analysed using an LC-MS/MS for the determination of 48 compounds belonging to different families in order to map their compliance according to the European Commission decision 2002/657/EC. Results show that 60% of the analysed samples were not contaminated by any residue, while 12% presented a concentration higher than the MRLs for tetracyclines, sulphonamides, quinolones, and macrolides. Results revealed that chicken were the most contaminated by antimicrobial residues, when compared to beef and milk. The obtained results demonstrate the uncontrolled use of antimicrobials in some Lebanese farms and claim for better management of livestock.     

Structural properties of phosphorous-doped polycrystalline silicon

The structural properties and hydrogen bonding of undoped and phosphorous doped polycrystalline silicon produced by step-by-step laser dehydrogenation and crystallization technique were investigated using Raman spectroscopy and hydrogen effusion measurements. At low laser fluences, E_L, a two-layer system is created. This is accompanied by the change in hydrogen bonding. The intensity of the Si–H vibration mode at 2000 decreases faster than the one at 2100 cm⁻¹. This is even more pronounced in phosphorous-doped specimens. The laser crystallization results in an increase of the hydrogen binding energy by approximately 0.2–0.3 eV compared to the amorphous starting materials.     

Cellular mechanisms for developmental toxicity of chlorpyrifos: targeting the adenylyl cyclase signaling cascade

Developmental neurotoxicity caused by chlorpyrifos exposure is generally thought to target cholinesterase but chlorpyrifos may also act on cellular intermediates, such as adenylyl cyclase, that serve global functions in the coordination of cell development. In the current study, neonatal rats were exposed to apparently subtoxic doses of chlorpyrifos (no weight loss, no mortality) either on Postnatal Days 1-4 or on Postnatal Days 11-14, and the effects on components of the adenylyl cyclase cascade were evaluated in brain regions that are enriched (forebrain) or sparse (cerebellum) in cholinergic innervation, as well as in a nonneural tissue (heart). In all three, chlorpyrifos evoked deficits in multiple components of the adenylyl cyclase cascade: expression and activity of adenylyl cyclase itself, functioning of G-proteins that link neurotransmitter and hormone receptors to cyclase activity, and expression of neurotransmitter receptors that act through this cascade. Disruption of signaling function was not restricted to transduction of cholinergic signals but rather extended to adrenergic signals as well. In most cases, the adverse effects were not evident during the immediate period of chlorpyrifos administration, but appeared after a delay of several days. These results suggest that chlorpyrifos can affect cell development by altering the activity and reactivity of the adenylyl cyclase signaling cascade, a major control point for trophic regulation of cell differentiation. The effects are not restricted to cholinergic targets, nor even to the central nervous system. Hence, disruption of cell development by chlorpyrifos is likely to be more widespread than previously thought.     

Fatigue Behavior of a Pavement Foundation with Recycled Aggregate and Waste HDPE Strips

A laboratory investigation was conducted to evaluate the fatigue behavior of an alternative pavement foundation material containing cement stabilized reclaimed crushed aggregate. Class C fly ash, and waste-plastic strip [high density polyethylene (HDPE)] reinforcement. The primary motivation for this research was to evaluate a composite that contained more than 90% recycled materials for use as an alternative foundation layer underneath conventional flexible or rigid pavement. The specific objectives of this study were (1) to evaluate the flexural fatigue behavior of the new composite, and (2) to evaluate the accumulation of fatigue damage in the material. The results indicate that the fatigue resistance of this material is similar to other traditional stabilized pavement materials. It was found that the dynamic elastic modulus remained approximately constant (degraded slowly) for most specimens up to the end of fatigue life. Fatigue damage computed using a dissipated energy approach showed that the damage accumulation in this material approximately follows Miner's rule for cumulative damage, which is often used in pavement engineering.     

Analysis and Optimization of Noise in Bipolar RF Harmonic Mixers

A noise analysis of bipolar harmonic mixers (BHM) used for direct-conversion receivers is presented in this paper. Analytical and simulated results for the transfer function of the mixer are presented. Simple analytical expressions describing noise contribution from all sources are derived. Estimation of flicker noise quite agrees with harmonic-balance simulation results. Based on the derived expressions, total time average noise power spectral density (PSD) at the output is compared with simulation results. For the recommended regions of operation, error is less than 20%. The overall BHM noise figure (NF) is calculated and optimized based on a simple extracted formula. Errors introduced by analysis remain within a 1.5-dB margin with respect to simulation results. The validity of analysis for high frequencies is justified. The effect of flicker noise coefficient on the overall mixer NF is compared for different available processes.     

An investigation of pore cracking in titanium welds

Two welded Ti-6A1-4V pressure vessels leaked prematurely in service. The leaks were caused by cracks emanating from weld porosity. The cracks originated during fabrication, with subsequent growth in service leading to the formation of the leak paths. Pore cracking is thought to be caused by a mechanism that involves both sustained-load and cyclic contributions, with the former being the more prominent. It is shown that the tendency for cracking is influenced by pore position and that pore size is not a deciding factor in that regard. The factors that govern pore cracking are discussed, and the possible role of interstitial embrittlement is assessed.     

Breakdown probabilities for thin heterostructure avalanche photodiodes

The recurrence theory for the breakdown probability in avalanche photodiodes (APDs) is generalized to heterostructure APDs that may have multiple multiplication layers. The generalization addresses layer-boundary effects such as the initial energy of injected carriers as well as the layer-dependent profile of the dead space in the multiplication region. Reducing the width of the multiplication layer serves to both downshift and sharpen the breakdown probability curve as a function of the applied reverse-bias voltage. In structures where the injected carriers have an initial energy that is comparable to the ionization threshold energy, the transition from linear mode to Geiger-mode is more abrupt than in structures in which such initial energy is negligible. The theory is applied to two recently fabricated Al/sub 0.6/Ga/sub 0.4/As-GaAs heterostructure APDs and to other homostructure thin GaAs APDs and the predictions of the breakdown-voltage thresholds are verified.     

50-nm Self-Aligned and “Standard” T-gate InP pHEMT Comparison: The Influence of Parasitics on Performance at the 50-nm Node

Continued research into the development of III-V high-electron mobility transistors (HEMTs), specifically the minimization of the device gate length, has yielded the fastest performance reported for any three terminal devices to date. In addition, more recent research has begun to focus on reducing the parasitic device elements such as access resistance and gate fringing capacitance, which become crucial for short gate length device performance maximization. Adopting a self-aligned T-gate architecture is one method used to reduce parasitic device access resistance, but at the cost of increasing parasitic gate fringing capacitances. As the device gate length is then reduced, the benefits of the self-aligned gate process come into question, as at these ultrashort-gate dimensions, the magnitude of the static fringing capacitances will have a greater impact on performance. To better understand the influence of these issues on the dc and RF performance of short gate length InP pHEMTs, the authors present a comparison between In_0.7Ga_0.3As channel 50-nm self-aligned and "standard" T-gate devices. Figures of merit for these devices include transconductance greater than 1.9 S/mm, drive current in the range 1.4 A/mm, and fT up to 490 GHz. Simulation of the parasitic capacitances associated with the self-aligned gate structure then leads a discussion concerning the realistic benefits of incorporating the self-aligned gate process into a sub-50-nm HEMT system