传统加氯工艺和控制系统的改进

通过分析传统加氯方式存在的弊端 ,结合水厂的实际情况 ,对水厂的加氯系统进行了有益的探讨 ,提出了一种新的投加工艺和控制系统 ,并成功应用于珠海市拱北水厂。     

半导体激光器列阵有源区电场随电流变化的定点测量

采用连续波电光检测法，对ＧａＡｓ／ＧａＡｌＡｓ双异质结激光器列阵有源区进行定点测量，实验结果反映了发光区内及发光区外电场随电流变化的不同规律。文中对实验结果给出了合理解释。     

高应力水平下滚动轴承疲劳寿命试验研究

通过在三种不同的强化负荷下进行深沟球轴承疲劳寿命试验，并与常规试验一组结果对比。结果表明，适当地加大滚动轴承疲劳寿命试验负荷，可以大大缩短试验时间，而疲劳寿命依然服从Ｗｅｉｂｕｌ分布，且与常规试验结果基本一致，同时疲劳破坏的形式仍是表面下萌生裂纹，然后扩展至表面形成剥落。     

预应变对16MnR钢断裂韧性的影响SCIEI

本文实验发现预应变对16MnR钢的断裂韧性具有显著的影响,断裂过程中裂尖区域材料的组织结构发生了变化,裂纹在二次珠光体组织上扩展。16MnR钢断裂韧性的大小取决于碳原子的扩散及二次珠光体组织生成的难易程度。     

偶联剂对地砖用PVC填充材料相态结构和力学性能的影响

研究了钛酸酯类偶联剂和硅烷类偶联剂对钙矿、硅酸盐填充的PVC填允材料力学性能、相态结构、密度、热失重率及吸水伸长率和耐热阻燃性能的影响。结果表明,偶联剂可改善填充PVC的抗冲性能,降低其拉伸强度,扫描电镜分析表明,填料越细,分散越均匀,越易被PVC树脂所包覆,力学性能越好,研究得到了比重大、热失重率低、吸水伸长率小、阻燃耐烧灼性好的高填充PVC硬质塑料地板砖。     

Denitrification and Dephosphatation by Anaerobic/Anoxic Sequencing Batch Reactor

Removal of denitrifying phosphorus was verified in a laboratory anaerobic/anoxic sequencing batch reactor (A/A SBR). The results obtained demonstrated that the anaerobic/anoxic strategy can enrich the growth of denitrifying phosphorus removing bacteria (DPB) and take up phosphate under anoxic condition by using nitrate as the electron acceptor. The phosphorus removal efficiency was higher than 90% and the effluent phosphate concentration was lower than lmg·L-1 after the A/A SBR was operated in a steady-state. When the chemical oxygen demand(COD) of influent was lower than 180mg·L-1, the more COD in the influent was, the higher efficiency of phosphorus removal could be attained under anoxic condition. However, simultaneous presence of carbon and nitrate would be detrimental to denitrifying phosphorus removal. Result of influence of sludge retention time (SRT) on denitrifying phosphorus removal suggested that the decrease of SRT caused a washout of DPB and consequently the enhanced biological phosphorus     

Measurement and Correlation for Solubility of (S)-(+)-2,2-Dimethyl-cyclopropane Carbox Amide in Different Solvents

1 INTRODUCTION (S)-(+)-2,2-dimethylcyclopropane carbox amide [(+)-DMCPCA, Fig.1] is a key intermediate of Cilas- tatin, an inhibitor of dehydropeptidase-I. As the syner- gist of imipenem (an antibiotic drug), cilastatin is widely used in clinical applications and has prosper- ous prospects[1]. In industrial manufacture[2―6], as the optical intermediate, the chemical and optical purity of (+)-DMCPCA would affect the quality of cilastatin. So, the separation and purification are impo…     

风机及泵用差动调速装置的节能效果分析

差动调速装置是一种适用于大中型风机及泵类的高效节能传动装置,它能有效调节风机及泵的流量或使其运行于高效工作区。该装置具有调速方便、效率高、节能效果显著、造价低、可靠性高等一系列优点。     

原位乳液聚合制备聚苯乙烯丁二烯橡胶/凹凸棒石纳米复合材料

采用原位乳液聚合制备了聚苯乙烯丁二烯橡胶(SBR)/凹凸棒石(AT)纳米复合材料。凹凸棒石的存在一定程度上降低了乳液聚合速率,但对最终聚合产物的分子质量及分子质量分布影响不大。凹凸棒石以长0.5～5μm、直径为20～50nm的棒状纤维均匀的分散在SBR基体中。在硫化过程中,凹凸棒石纤维与橡胶形成互穿网络结构,增加了橡胶的交联密度。随着凹凸棒石的填充量增加,纳米复合材料的300%定伸应力和拉伸强度与纯SBR相比均提高了20%～100%,其补强效果明显高于等量的炭黑N330,还表现出良好的耐磨性能。     

碳纤维纱线及其织物的电阻与温度的关系

研究碳纤维纱线及其织物的电阻对温度的响应.通过实验发现碳纤维纱线的电阻随着温度的增加而线性减小,碳纤维织物的电阻也随着温度的增加而减小,且在一定的温度范围内其变化呈线性关系.制备的经编结构碳纤维织物电阻对温度响应的灵敏度有较大提高,表明织物的结构有助于增加碳纤维织物电阻对温度响应的灵敏度.织物电阻随温度变化的机理主要是...