Rheology of cementitious paste with silica fume or limestone

The rheological behaviour of cementitious pastes where cement has increasingly been replaced by densified silica fume (SF), untreated SF or limestone has been studied. The effect of SF on the flow resistance, taken as the area under the flow curve, was found to depend on the dispersing ability of the plasticizer as illustrated by pastes with naphtalene sulphonate-formaldehyde condensate (SNF) and polyether grafted polyacrylate (PA).The gel strengths increased with increasing SF replacement of cement independently of plasticizer type. The cementitious gel strength was, however, depending on the type of SF since pastes with densified SF developed lower gel strengths than pastes with untreated SF. This phenomenon was attributed to agglomerates in the densified SF which remained unbroken by the mixing and measurement sequence.Both flow resistance and gel strength decreased with increasing limestone replacement. Thus, silica fume may have an advantage over limestone filler as stabilizing agent for self-compacting concrete preventing segregation upon standing and reduced form pressure due to a more rapid gel formation.     

Radiotherapy in Ewing's sarcoma and PNET of the chest wall: results of the trials CESS 81, CESS 86 and EICESS 92

PURPOSE: Treatment results and the pattern of relapse were evaluated in the multimodal treatment of Ewing's sarcomas of the chest wall. METHODS AND MATERIALS: In a retrospective analysis, 114 patients with non-metastatic Ewing's sarcoma of the chest wall were evaluated. They were treated in the CESS 81, CESS 86, or EICESS 92 studies between January 1981 and December 1993. The treatment consisted of polychemotherapy (VACA, VAIA, or EVAIA) and local therapy, either surgery alone (14 patients), radiotherapy alone (28 patients) or a combination of both (71 patients). The median follow-up was 46.6 months (range 5-170). A relapse analysis for all patients with local or combined relapses was performed. RESULTS: Overall survival was 60% after 5 years, event-free survival was 50%. Thirty-seven patients had a systemic relapse (32.4%), 11 patients had a local relapse alone (9.6%), and 3 patients had a combined local and systemic relapse (2.6%). The risk to relapse locally after 5 years was 0% after surgery alone, 19% after radiation alone, and 19% after postoperative irradiation. None of the 8 patients with preoperative irradiation have failed locally so far. With the introduction of central radiotherapy planning in CESS 86, local control of irradiated patients improved. Ten of 14 patients with local failure could be evaluated in the relapse analysis: 3 patients had an in-field relapse, 4 patients had a marginal relapse, 2 patients had a relapse outside the radiation fields, and 1 patient failed with pleural dissemination. Six treatment deviations were observed. CONCLUSION: Local control was best after surgery alone in a positively selected group of patients. Local control after radiation or combined radiation and surgery was good. With diligent performance of radiotherapy, it will be possible to further improve the results in the radiotherapy group.     

Human atrial natriuretic peptide in patients with type 1 diabetes mellitus: is it related to the development of diabetic nephropathy?

There is controversy as to whether increased plasma levels of human atrial natriuretic peptide (hANP) in patients with type 1 diabetes mellitus may contribute to the development of diabetic nephropathy. Therefore, we decided to conduct two studies to examine the relationship of hANP levels to urinary albumin excretion and blood pressure. In a cross-sectional study, 83 randomly selected type 1 diabetic patients were investigated. 19 of the patients had increased urinary albumin excretion. 45 healthy volunteers served as controls. In a longitudinal study, 19 type 1 diabetic patients were examined for one year at monthly intervals. An increased risk of eventually developing diabetic nephropathy was identified in 7 out of these patients by repeatedly revealing increased urinary albumin excretion. On the average, hANP levels were increased in type 1 diabetic patients in comparison to controls (P < 0.001). In both studies, hANP levels were positively related (P < 0.05) to mean arterial blood pressure. There was no correlation between hANP levels and metabolic control. hANP levels lay within normal range irrespective of normal or elevated urinary albumin excretion provided that mean arterial blood pressure was normal. In the longitudinal study, increased urinary albumin and alpha-1-microglobulin excretion preceded the increase in both hANP levels and mean arterial blood pressure. Although hANP levels were evidently not related to the disease mechanisms of early diabetic nephropathy, it is tempting to speculate that hANP may contribute to the vicious circle connecting diabetic kidney disease to hypertension once that its levels are increased by elevated blood pressure.     

Anthocyanins: optimisation of extraction from Cabernet Sauvignon grapes,microcapsulation and stability in soft drink

The aim of this study was to establish the optimum conditions for the extraction of anthocyanins from Cabernet Sauvignon (Vitis vinifera L.) grapes using the response surface methodology and to evaluate the stability of these anthocyanins encapsulated with different carrier agents in an isotonic soft drink system under different light and temperature conditions. The extraction process was optimised with the response surface methodology to obtain the highest anthocyanin concentration (40 mL of ethanol:1.5 N HCL (85:15) as solvent, extraction time 29.4 h at pH 2.4). The degradation of the anthocyanins followed first‐order kinetics in the situations evaluated. Maltodextrin, maltodextrin/γ‐cyclodextrin and maltodextrin/arabic gum were tested as carrier agents and the combination of maltodextrin/arabic gum presented the longest half‐life time and lowest degradation constant for all the conditions evaluated. The formation of microcapsules was observed through scanning electron microscopy.     

Reliability of roughness measurements using contact stylus instruments with particular reference to results of recent research at the Physikalisch-Technische bundesanstalt

Even today international comparison measurements of surface roughness show differences of 40% and more, as they did more than 10 years ago. However, within the framework of the Deutscher Kalibrierdienst, differences occurring in comparison measurements do not exceed 5%. At the end of 1982, a project of the European Communities was started for the purpose of also carrying out comparison measurements yielding small differences. The prerequisites are the following: clearly defined surface roughness parameters including details of the measurement conditions required and calibration and testing of the contact stylus instruments before the comparison measurements are made.In recent years the contacting process, the interaction between stylus and surface, has been the subject of very thorough investigations at the Physikalisch-Technische Bundesanstalt. Elastic and plastic deformations of the surface were examined. The parameters of influence are the geometry of the stylus tip and of the surface under examination, the properties of the materials, the static and dynamic measuring forces and the rate of feed. Calculation methods for optimizing these parameters are stated in order to keep the resulting measurement errors as small as possible. A new contactless measuring method is described which is based on the evaluation of scanning electron microscopy stereo pairs. An error analysis makes precision measurements possible which up to now could not be carried out at all. Examples examined have shown that sometimes, particularly on finely ground surfaces, measurements with contact stylus instruments on surfaces with R_z values below 1 μm can be very significantly in error.     

Evaluation of Antioxidative Constituents from Thyme

The non-polar fraction of thyme was examined for the occurrence of phenolic components and their antioxidative activity. In addition to carvacrol ( II ) and thymol ( III ), p -cymene-2,3-diol (I ; 2,3-dihydroxy-4-isopropyl-1-methylbenzene) was isolated for the first time from thyme. The structure of I was elucidated using ¹H nuclear magnetic resonance (NMR), ¹³C NMR, and mass spectrometry. Antioxidative activity was investigated with the Rancimat method (100°C) and the Schaal test (60°C). Compound I exhibited the strongest antioxidative activity which was greater than that of α-tocopherol and butylated hydroxyanisole. Five thyme species were analysed by means of HPLC with electrochemical detection for the concentration of compounds I – III . The highest amounts of I – III were found in Thymus vulgaris L.     

Viscosity‐molecular weight relationship for cellulose solutions in either NMMO monohydrate or cuen

The intrinsic viscosities, [η], of nine cellulose samples, with molar masses from 50 × 10³ to 1 390 × 10³ were determined in the solvents NMMO*H₂O (N‐methyl morpholin N‐oxide hydrate) at 80°C and in cuen (copper II‐ethlenediamine) at 25°C. The evaluation of these results with respect to the Kuhn–Mark–Houwink relations shows that the data for NMMO*H₂O fall on the usual straight line in the double logarithmic plots only for M ≤ 158 10³; the corresponding [η]/M relation reads log ([η]/mL g⁻¹) = –1.465 + 0.735 log M. Beyond that molar mass [η] remains almost constant up to M ≈ 10⁶ and increases again thereafter. In contrast to NMMO*H₂O the cellulose solutions in cuen behave normal and the Kuhn–Mark–Houwink relation reads log ([η]/mL g⁻¹) = −1.185 + 0.735 log M. Possible reasons for the dissimilarities of the behavior of cellulose in these two solvents are being discussed. The comparison of three different methods for the determination of [η] from viscosity measurements at different polymer concentrations, c, demonstrates the advantages of plotting the natural logarithm of the relative viscosities as a function of c. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2011     

Wärmeübergang in kurzen,wandgängig gerührten Apparaten

Scraped surface heat exchanger are often used in industrial settings for the treatment of systems with solid particle formation or higher viscosities. In reactors with a small length‐diameter ratio, the backmixing has thereby a significant influence on the heat transfer. In the experiments presented here, it can be shown that the heat transfer coefficient strongly depends on the flow pattern within the laminar flow regime, and that, depending on the running conditions, an increased rotor speed may have a negative effect on the heat transfer rate.     

An ecotoxicity assessment of contaminated forest soils from the Kola Peninsula

Point source copper and nickel contamination emanating from smelters of the Kola Peninsula, NW Russia, has been observed since the mid-1960s. Previous studies have concentrated on the spatial distribution of heavy metals and their effects on forest ecology and indigenous mammals and birds. Soil is perceived as the major repository for the metal pollutants but there is a need to link the soil concentration of pollutants on the Kola Peninsula with biological parameters. Many standard methods currently used in soil ecotoxicology are developed and refined with artificial amendments and rarely modified for use in historically contaminated environments. In this study, forest soils were sampled along a 34 km transect from the smelter and analysed both chemically and with a range of ecologically relevant biological tests. Soil respiration, total nematode count, microbial heterotrophic numbers and minimal inhibitory concentrations to copper and nickel were carried out on bulk soil. The soil pore water was tested with bacterial and fungal bioluminescence-based biosensors. The heterotrophic numbers and their inhibitory concentration showed strong correlation with heavy metal concentrations while decreasing biosensor luminescence was related to increasing copper concentrations present in the pore waters. Overall, there were considerable impacts on some microbial parameters but other measures including respiration and nematode populations were insensitive to pollutant levels. While chemical analysis of heavy metals proved essential in defining the extent of contamination, environmentally relevant ecotoxicological tests complemented these data by demonstrating pollutant impact. Ecotoxicological approaches that study both the bulk soil and pore water may represent the key to understanding the fate of heavy metal in soils.