Doped silicon and NIS junctions for bolometer applications

We discuss the performance, of a normal metal hot electron bolometer (NHEB) that we have measured at 0.3 K. We found that the noise equivalent power was limited by the amplifier noise. To improve the NHEB power response and to make it more robust and reliable we propose to substitute the normal metal with heavily doped silicon. The heavily doped silicon behaves like a metal with lower carrier concentration and has a smaller electron–phonon thermal coupling. We have fabricated superconductor-doped silicon-superconductor contacts (S-Sm-S) and we have used them as thermometers and coolers.     

Thermal stability of Al/AlGaAs and Al/GaAs/AlGaAs (MBE) Schottky barriers

Outstanding stability has been observed in Al/Al/sub x/Ga/sub 1-x/As and Al/GaAs/Al/sub x/Ga/sub 1-x/As (x=0.25) Schottky barriers prepared by depositing Al in situ by MBE on annealing up to 400 degrees C. Conventionally evaporated barriers have been fabricated and compared with epitaxial ones. The changes in barrier height and ideality factor induced by annealing are reported.<>     

Stable redesign of predictive control

The paper deals with I/O versions of receding horizon controllers based on the minimization of multistep quadratic costs with the constraint that the terminal state goes to zero. The resulting control law yields stable closed-loop systems under sharp conditions. Simulation results are presented to both verify the theoretical analysis and relate the new control law with GPC     

Primary lymphoma of the breast. Three cases of non-Hodgkin lymphoma

Primary and sole breast lymphoma is a very rare disease. With the review of our series of 616 cases operated on for breast cancer, only 3 cases (0.48%) of primary breast non-Hodgkin lymphoma (LNH) have been observed. The authors outline the problems concerning diagnosis and therapy of this rare disease: pathological and immunohistochemical aspects are discussed. They stress the importance of staging in order to plan a correct multidisciplinary approach.     

Paste Residence Time in a Spouted Bed Dryer. III: Effect of Paste Properties and Quality Interactions

The aim of this study was to evaluate the effects of paste properties on residence time during drying in a spouted bed dryer with inert bodies. The effect of paste solids content, surface tension, and viscosity on the residence time distribution and the mean residence times were studied using factorial experimental designs. The inert bodies used were glass and polyethylene beads. The mean residence times varied from 13.6 to 16.3 and 12.2 to 17.7 min for drying on glass and polyethylene beads, respectively. The analysis of variance showed that mean residence times significantly depended on solids content and surface tension for glass beads and also on viscosity for polyethylene beads. The residence time distributions for all conditions studied fitted well to the perfect mixing cell when applying the continuous stirred vessels in series model analysis. The powder density, flowability, and particle size depended on paste properties and inert type.     

Nisin expression production from Lactococcus lactis in milk whey medium

BACKGROUND: Nisin is a commercially available bacteriocin produced by Lactococcus lactis ATCC 11454 and used as a natural agent in the biopreservation of food. In the current investigation, milk whey, a byproduct from dairy industries was used as a fermentation substrate for the production of nisin. Lactococcus lactis ATCC 11454 was developed in a rotary shaker (30 °C/36 h/100 rpm) using two different media with milk whey (i) without filtration, pH 6.8, adjusted with NaOH 2 mol L^?1 and without pH adjustment, both autoclaved at 121 °C for 30 min, and (ii) filtrated (1.20 µm and 0.22 µm membrane filter). These cultures were transferred five times using 5 mL aliquots of broth culture for every new volume of the respective media. RESULTS: The results showed that culture media composed of milk whey without filtration supplied L. lactis its adaptation needs better than filtrated milk whey. Nisin titers, in milk whey without filtration (pH adjusted), was 11120.13 mg L^?1 in the second transfer, and up to 1628‐fold higher than the filtrated milk whey, 6.83 mg.L^?1 obtained in the first^t transfer. CONCLUSIONS: Biological processing of milk byproducts (milk whey) can be considered a profitable alternative, generating high‐value bioproducts and contributing to decreasing river disposals by dairy industries. Copyright © 2008 Society of Chemical Industry     

Cervical electrostimulation in some vestibular diseases

Vestibular disorders may be treated by means of drugs, surgical tools or rehabilitation. Cervical electrostimulation may be regarded as physical therapy and its activity is connected to neural pathways between cervical receptors and vestibular nuclei. In present study electrodes were placed lateral to cervical column on the opposite side of vestibular deficit as pointed by electronystagmography; stimulus duration was 18 msec and frequency 100 Hz. Every stimulation lasts for 30 minutes and were repeated twice a week for a total number of 10. The ability to adjust vestibulo-ocular reflex was evaluated by means of a Compensatory Index. The following materials were enrolled in the study: 20 normal subjects were observed before and after a cycle of stimulations: 24 patients suffering from acute labyrinthitis or neuritis, 48 cervical vertigo, 8 cervical traumatic injures and 3 patients operated for acoustical neuroma. All these groups were coupled with control groups composed of the same pathology and the same number of subjects. Statistical treatment of reports was evaluated by t-student test before therapy after one month and after 3 months. Results point out good effects of electrostimulation on vestibulo-ocular reflex compensation, especially in cervical vertigo and labyrinthitis or neuritis with respect to control groups. No important results were obtained in neuroma group and in normal subjects. Electrostimulation may act on vestibular nuclei by direct spino-vestibular pathway but also by repeated decompensations mainly mediated via the cerebellum or spino-reticular connections.     

Performance of Green Solvents in the Extraction of Sunflower Oil from Enzyme-Treated Collets

The main goal of this work is to evaluate the extraction of sunflower oil from enzyme-treated collets using ethanol and isopropanol (IPA) as solvents. The sunflower collets are pretreated with the multienzyme complex Viscozyme L prior to solvent extraction by the Soxhlet method. The influence of the moisture content of the collets, pretreatment, processing time, and solvent type on the amount of total extracted material and the oil extraction efficiency is studied. Some quality parameters such as phospholipid content of the oil and chlorogenic acid content of the residual meal are also analyzed. At low moisture content (7%) the solvents exhibit similar oil extraction ability (98–99%), but with increasing moisture the extraction efficiency of ethanol decreases to about 85%, while no significant differences are observed for IPA. The enzymatic treatment increases the extraction efficiency for all times, especially for ethanol. It is observed that IPA is more efficient in the extraction compared to ethanol, and the amount of nonlipid material is reduced by ≈70%. In addition, the oil extracted with IPA have lower phospholipid content and the residual meal presents a higher chlorogenic acid content. Practical Applications:This work would contribute toward the use of green solvents in the extraction of sunflower oil from collets. Ethanol and isopropanol, used as solvents, present attractive advantages, including low toxicity, good operational security, as well as being obtained from a renewable source. The obtained data provide up-to-date information on the use of these alcohols in the extraction of sunflower oil from collets and the influence of operating conditions, such as moisture content, enzymatic pretreatment of the collets, and the extraction time. Information about oil and meal quality is also reported.     

Nickel Activation for Hydrogenolysis Reaction on USY Zeolite

The effects of the SAR (14 and 38) and of the methodology of introduction of nickel (wetness impregnation and ion exchange) on catalyst activation were investigated in Ni/USY model catalysts submitted to two activation treatments: reduction (A) and reduction/calcination/reduction, successively (B). the catalysts prepared by wetness impregnation, a marked increase in the catalytic activity after treatment B was observed. On the basis of the catalyst efficiency toward ethane hydrogenolysis, the lower SAR catalyst presents a threefold higher activity. On the contrary, the catalysts prepared by ion exchange, as well as a model catalyst prepared by wetness impregnation over a USY exhaustively exchanged with nickel ions, do not present measurable increasing of the catalytic activity under the same activation conditions. Monitoring the catalyst activation by EXAFS indicates the formation of nickel clusters in the impregnated catalysts after activation treatment B, which should be responsible for the high catalytic activity. However, TEM images reveal a bimodal particle size distribution, with large (ca. 20 nm) and small nickel particles. Temperature-programmed reduction performed under the same conditions of catalyst activation suggests that only the small nickel particles are activated under the experimental conditions adopted in this work.