Robustness of an aerobic metabolically vinyl chloride degrading bacterial enrichment culture

Degradation of the lower chlorinated ethenes is crucial to the application of natural attenuation or in situ bioremediation on chlorinated ethene contaminated sites. Recently, within mixtures of several chloroethenes as they can occur in contaminated groundwater inhibiting effects on aerobic chloroethene degradation have been shown. The current study demonstrated that metabolic vinyl chloride (VC) degradation by an enrichment culture originating from groundwater was not affected by an equimolar concentration (50 μM) of cis-1,2-dichloroethene (cDCE). Only cDCE concentrations at a ratio of 2.4:1 (initial cDCE to VC concentration) caused minor inhibition of VC degradation. Furthermore, the degradation of VC was not affected by the presence of trans-1,2-dichloroethene (tDCE), 1,1-dichloroethene (1,1-DCE), trichloroethene (TCE), and tetrachloroethene (PCE) in equimolar concentrations (50 μM). Only cDCE and tDCE were cometabolically degraded in small amounts. The VC-degrading culture demonstrated a broad pH tolerance from 5 to 9 with an optimum between 6 and 7. Results also showed that the culture could degrade VC concentrations up to 1,800 μM (110 mg/L).     

Invited article: development of high-field superconducting Ioffe magnetic traps

We describe the design, construction, and performance of three generations of superconducting Ioffe magnetic traps. The first two are low current traps, built from four racetrack shaped quadrupole coils and two solenoid assemblies. Coils are wet wound with multifilament NbTi superconducting wires embedded in epoxy matrices. The magnet bore diameters are 51 and 105 mm with identical trap depths of 1.0 T at their operating currents and at 4.2 K. A third trap uses a high current accelerator-type quadrupole magnet and two low current solenoids. This trap has a bore diameter of 140 mm and tested trap depth of 2.8 T. Both low current traps show signs of excessive training. The high current hybrid trap, on the other hand, exhibits good training behavior and is amenable to quench protection.     

Improvement of differential optical absorption spectroscopy with a multichannel scanning technique

Differential optical absorption spectroscopy (DOAS) of atmospheric trace gases requires the detection of optical densities below 0.1%. Photodiode arrays are used more and more as detectors for DOAS because they allow one to record larger spectral intervals simultaneously. This type of optical multichannel analyzer (OMA), however, shows sensitivity differences among the individual photodiodes (pixels), which are of the order of 1%. To correct for this a sensitivity reference spectrum is usually recorded separately from the trace-gas measurements. Because of atmospheric turbulence the illumination of the detector while an atmospheric absorption spectrum is being recorded is different from the conditions during the reference measurement. As a result the sensitivity patterns do not exactly match, and the corrected spectra still show a residual structure that is due to the sensitivity difference. This effect usually limits the detection of optical densities to approximately 3 × 10(-4). A new method for the removal of the sensitivity pattern is presented in this paper: Scanning the spectrometer by small wavelength increments after each readout of the OMA allows one to separate the OMA-fixed pattern and the wavelength-fixed structures (absorption lines). The properties of the new method and its applicability are demonstrated with simulated spectra. Finally, first atmospheric measurements with a laser long-path instrument demonstrate a detection limit of 3 × 10(-5) of a DOAS experiment.     

Elliptical trough reflector for the collection of light from linear sources

A trough reflector with a reflective, truncated elliptical surface was designed to efficiently collect freely propagating light from a linear source. The source was placed at one focus of the reflector, and light was collected through a rectangular aperture near the second focus. Collection efficiency was much greater than that of a spherical integrator and approximately 6.5x greater than that of an objective lens; as much as approximately 55% of the light could be captured from the full aperture. This reflector could be used to efficiently collect surface fluorescence excited by use of evanescent waves in fluorescence-based fiber optic or capillary waveguide sensors.     

Combination of fiber-guided pulsed erbium and holmium laser radiation for tissue ablation under water

Because of the high absorption of near-infrared laser radiation in biological tissue, erbium lasers and holmium lasers emitting at 3 and 2 μm, respectively, have been proven to have optimal qualities for cutting or welding and coagulating tissue. To combine the advantages of both wavelengths, we realized a multiwavelength laser system by simultaneously guiding erbium and holmium laser radiation by means of a single zirconium fluoride (ZrF(4)) fiber. Laser-induced channel formation in water and poly(acrylamide) gel was investigated by the use of a time-resolved flash-photography setup, while pressure transients were recorded simultaneously with a needle hydrophone. The shapes and depths of vapor channels produced in water and in a submerged gel after single erbium and after combination erbium-holmium radiation delivered by means of a 400-μm ZrF(4) fiber were measured. Transmission measurements were performed to determine the amount of pulse energy available for tissue ablation. The effects of laser wavelength and the delay time between pulses of different wavelengths on the photomechanical and photothermal responses of meniscal tissue were evaluated in vitro by the use of histology. It was observed that the use of a short (200-μs, 100-mJ) holmium laser pulse as a prepulse to generate a vapor bubble through which the ablating erbium laser pulse can be transmitted (delay time, 100 μs) increases the cutting depth in meniscus from 450 to 1120 μm as compared with the depth following a single erbium pulse. The results indicate that a combination of erbium and holmium laser radiation precisely and efficiently cuts tissue under water with 20-50-μm collateral tissue damage.     

Gene expression changes in a transgenic mouse model overexpressing human wildtype and mutant torsinA

Primary torsion dystonia is an autosomal-dominantly inherited, neurodevelopmental movement disorder caused by a GAG deletion (ΔGAG) in the DYT1 gene, encoding torsinA. This mutation is responsible for approximately 70% of cases of early-onset primary torsion dystonia. The function of wildtype torsinA is still unknown, and it is unsolved how the deletion in the DYT1 gene contributes to the development of the disease. To better understand the molecular processes involved in torsinA pathology, we used genome-wide oligonucleotide microarrays to characterize gene expression patterns in the striatum of mouse models overexpressing the human wildtype and mutant torsinA. By this approach we were able to detect gene expression changes that seem to be specific for torsinA pathology. We found an impact of torsinA, independent from genotype, on vesicle trafficking, exocytosis, and neurotransmitter release in our mouse model. In addition, we were able to identify several new pathways and processes involved in the development of the nervous system that are affected by wildtype and mutant torsinA. Furthermore, we have striking evidence from our gene expression data that glutamate receptor mediated synaptic plasticity in the striatum is the affected underlying cellular process for impaired motor learning in human ΔGAG torsinA transgenic mice.