Synthesis,characterization and charge transport properties of Pr–Ni Co-doped SrFe2O4 spinel for high frequency devices applications

Ferrites are materials of interest due to their broad applications in high technological devices and a lot of research has been focused to synthesize new ferrites. In this regard, an effort has been devoted to synthesize spinel Pr–Ni co-substituted strontium ferrites with a nominal formula of Sr_1-xPr_xFe_2-yNi_yO₄ (0.0 ≤ x ≤ 0.1, 0.0 ≤ y ≤ 1.0). The cubic structure of pure and Pr–Ni co-substituted strontium ferrite samples calcinated at 1073 K for 3 h has been confirmed through X-ray diffraction (XRD). Average sizes of crystallites (18–25 nm) have been estimated from XRD analysis and nanometer particle sizes of synthesized ferrites have been further verified by scanning electron microscopy (SEM). SEM results have also shown that particles are mostly agglomerated and all the samples possess porosity. It has been observed that at 298 K, the values of resistivity (ρ) increase, while that of AC conductivity, dielectric loss, and dielectric constants decrease with increasing amounts of Pr³⁺ and Ni²⁺ ions. The values of dielectric parameters initially decrease with frequency and later become constant and can be explained on the basis of dielectric polarization. Electrochemical impedance spectroscopy (EIS) studies show that the charge transport phenomenon in ferrite materials is mainly controlled via grain boundaries. Overall, synthesized ferrite materials own enhanced resistivity values in the range of 1.38 × 10⁹–1.94 × 10⁹ Ω cm and minimum dielectric losses, which makes them suitable candidates for high frequency devices applications.     

Efficient dissemination of personalized information using content-based multicast

There has been a surge of interest in the delivery of personalized information to users (e.g., personalized stocks or travel information), particularly as mobile users with limited terminal device capabilities increasingly desire updated and targeted information in real time. When the number of information recipients is large and there is sufficient commonality in their interests, as is often the case, IP multicast is an efficient way of delivering the information. However, IP multicast services do not consider the structure and semantics of the information in the multicast process. We propose the use of Content-Based Multicast (CBM) where extra content filtering is performed at the interior nodes of the IP multicast tree; this will reduce network bandwidth usage and delivery delay, as well as the computation required at the sources and sinks. We evaluate the situations in which CBM is advantageous. The benefits of CBM depend critically upon how well filters are placed at interior nodes of the IP multicast tree and the costs depend upon those introduced by filters themselves. Further, we consider the benefits of allowing the filters to be mobile so as to respond to user mobility or changes in user interests and the corresponding costs of filter mobility. The criterion that we consider is the total network bandwidth utilization. For this criterion, we develop an optimal filter placement algorithm, as well as a heuristic that executes faster than the optimal algorithm. We evaluate the algorithms by means of simulation experiments. Our results indicate that filters can be effective in substantially reducing bandwidth. We also find filter mobility is worthwhile if there is marked large-scale user mobility. We conclude with suggestions for further work.     

Preparation of ion‐exchange membranes by hydrolysis of radiation‐grafted polyethylene‐g‐polyacrylamide membranes

Polyethylene‐g‐polyacrylamide membranes were prepared by graft polymerization of acrylamide onto polyethylene films using a preirradiation method. The ion‐exchange membranes were obtained by the hydrolysis of grafted films so as to transform amide groups into carboxyl groups. The fraction of amide groups transformed into carboxyl groups was limited to ～0.5. The characterization and thermal behavior of membranes with different degrees of grafting were evaluated by FTIR, thermogravimetric analysis (TGA), and differential scanning calorimetry (DSC) measurements. The heat of fusion and the crystallinity of polyethylene decreased considerably in the hydrolyzed membranes depending on the degree of grafting. It was found that the grafting of acrylamide led to the reduction in crystallinity due to disruption of the crystallites (crystal defects) and dilution of the inherent crystallinity (dilution effect). The contribution of the hydrolysis step to the crystallinity decrease was negligible. The thermal stability of the membranes as obtained from TGA showed considerable enhancement after hydrolysis. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 149–154, 2003     

Surface designing of polypropylene by critical monitoring of the grafting conditions

The grafting of acrylic acid onto electron beam‐irradiated polypropylene was carried out using preirradiation method. The stability of peroxy radicals was investigated by electron spin resonance. It was found that the decay of peroxy radicals is much faster at 70°C than at 40°C and ambient temperature. The grafting has been observed to be strongly dependent on the monomer dilution in the reaction medium. The grafting was ascertained by attenuated total reflectance (ATR). The distribution of grafts across the samples was monitored by infrared microscopy. It was found that the graft management is considerably influenced by composition of the grafting medium. The grafting involving pure monomer leads to the surface enrichment with the polyacrylic acid chains. The samples grafted in pure monomer led to much lower contact angles as compared to the diluted monomer solution. The swelling of the grafted samples also showed a trend that was governed by the graft management. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 546–553, 2006     

Development of antimicrobial polypropylene sutures by graft copolymerization. II. Evaluation of physical properties,drug release,and antimicrobial activity

Polypropylene (PP) sutures are prepared by the simultaneous radiation grafting of 1‐vinylimidazole (VIm) onto PP monofilament sutures. The tenacity slightly decreases whereas the elongation increases with the increase in the degree of grafting. Thermogravimetric analysis shows that the stability of the sutures is enhanced by the grafting process. The grafted sutures have reasonably good water uptake. They are subsequently immobilized with an antimicrobial drug, ciprofloxacin. The modified suture releases the drug over a period of 4–5 days. The antimicrobial activity of the modified suture is determined against Esherichia coli by the zone of inhibition technique. A clear zone of inhibition is observed around the drug‐containing suture. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 103: 3534–3538, 2007     

Mechanical,Thermal and Electrical Resisitivity Properties of Thermoplastic Composites Filled with Carbon Fibers and Carbon Particles

Composites consisting of carbon fibers (CF) and carbon particles (CP) in polypropylene (PP) matrix were melt-compounded. Composites were analyzed for their mechanical, electrical and thermal properties. Results indicate that the addition of these fillers improved the mechanical properties of the composites. Thermal conductivity was enhanced as the concentration of fillers was increased. Carbon fibers render the composites electrically conductive so we observed a percolation threshold near 10 wt.% of CF for PP/CF (PP and CF composite) and near 25 wt.% of CP for PP/CP (PP and carbon particle composite). All the results indicated that carbon fibers are more effective in improving the properties as compare to the carbon particles.     

Scientific Workflow Makespan Minimization in Edge Multiple Service Providers Environment

The edge computing model offers an ultimate platform to support scientific and real-time workflow-based applications over the edge of the network. However, scientific workflow scheduling and execution still facing challenges such as response time management and latency time. This leads to deal with the acquisition delay of servers, deployed at the edge of a network and reduces the overall completion time of workflow. Previous studies show that existing scheduling methods consider the static performance of the server and ignore the impact of resource acquisition delay when scheduling workflow tasks. Our proposed method presented a meta-heuristic algorithm to schedule the scientific workflow and minimize the overall completion time by properly managing the acquisition and transmission delays. We carry out extensive experiments and evaluations based on commercial clouds and various scientific workflow templates. The proposed method has approximately 7.7% better performance than the baseline algorithms, particularly in overall deadline constraint that gives a success rate.

     

A survey on search results diversification techniques

The quantity of information placed on the web has been greater than before and is increasing rapidly day by day. Searching through the huge amount of data and finding the most relevant and useful result set involves searching, ranking, and presenting the results. Most of the users probe into the top few results and neglect the rest. In order to increase user’s satisfaction, the presented result set should not only be relevant to the search topic, but should also present a variety of perspectives, that is, the results should be different from one another. The effectiveness of web search and the satisfaction of users can be enhanced through providing various results of a search query in a certain order of relevance and concern. The technique used to avoid presenting similar, though relevant, results to the user is known as a diversification of search results. This article presents a survey of the approaches used for search result diversification. To this end, this article not only provides a technical survey of existing diversification techniques, but also presents a taxonomy of diversification algorithms with respect to the types of search queries.