Fat Distribution and Lipid Profile of Young Adults with Congenital Adrenal Hyperplasia Due to 21-Hydroxylase Enzyme Deficiency

We aimed to compare detailed fat distribution and lipid profile between young adults with congenital adrenal hyperplasia due to 21-hydroxylase enzyme deficiency and a control group. We also verified independent associations of treatment duration and daily hydrocortisone dose equivalent (HDE) with lipid profile within patients. This case–control study included 23 patients (7 male and 16 female) matched by an age range of young adults (18–31 years) with 20 control subjects (8 male and 12 female). Dual energy X-ray absorptiometry was used to measure the fat distribution. Male patients demonstrated elevated indices of fat mass for total (7.7 ± 2.1 vs. 4.5 ± 1.3 kg/m², p = 0.003), trunk (4.0 ± 1.2 vs. 2.2 ± 0.8 kg/m², p = 0.005), android (0.63 ± 0.24 vs. 0.32 ± 0.15 kg/m², p = 0.008), gynoid (1.34 ± 0.43 vs. 0.74 ± 0.24 kg/m², p = 0.005), arm (0.65 ± 0.16 vs. 0.39 ± 0.10 kg/m², p = 0.009), and leg regions (2.7 ± 0.8 vs. 1.6 ± 0.4 kg/m², p = 0.005) than the control group, but not in females. However, female patients demonstrated elevated ratio of low-density lipoprotein cholesterol to high-density lipoprotein cholesterol (1.90 ± 0.46 vs. 1.39 ± 0.47, p = 0.009) than the control group, but not in males. Total fat mass was inversely correlated with total testosterone (r = −0.64, p = 0.014) and positively correlated with leptin in males (r = 0.75, p = 0.002). An elevated daily HDE (β = 0.43, p = 0.038 and β = 0.47, p = 0.033) and trunk to total fat mass ratio (β = 0.46, p = 0.025, and β = 0.45, p = 0.037) were independently correlated with impaired lipid profile markers. Although there is no altered lipid profile, male patients demonstrated an increased fat distribution. However, female patients presented with an impaired lipid profile marker but demonstrated close values of normal fat distribution. Interestingly, the dose of glucocorticoid therapy can have some role in the lipid mechanisms.     

Study of a BGO calorimeter using electron and hadron beams from 1 to 50 GeV

A calorimeter of 25 bismuth germanate (BGO) crystals equipped with silicon photodiode readout has been tested at the CERN SPS in the energy range 1–50 GeV. The response for electrons has been shown to be linear in this energy range and the rms resolution obtained ( ) is approximately 1%, for E > 4 GeV. The electron/pion separation was found to be better than 1:500 in the energy range 1–20 GeV. Data on lateral and longitudinal shower development were compared with the results of a Monte Carlo simulation using the SLAC-EGS program and found to be in good agreement.     

Combined time and wavelength multiplexing technique of optical fiber grating sensor arrays using commercial OTDR equipment

The use of a commercial optical time domain reflectometry device for simultaneous wavelength and time domain multiplexing of fiber-optic Bragg grating sensors is proposed and demonstrated. The realization of such systems provides an inexpensive way of interrogating several hundreds of sensors in a single fiber. Strain resolution of 30 /spl mu/m/m over a strain measuring range of 0.5% was obtained.     

Tensile and flexural creep rupture tests on partially-damaged concrete specimens

Three series of novel tensile and flexural creep tests on partially-damaged concrete specimens were carried out in order to gain some insight into creep crack growth and failure of strain-softening materials. In the tests, each specimen was initially loaded to a given point in the descending branch and thus had a lower load-carrying capacity than that at the peak-point. Then, the specimen was unloaded and reloaded to sustain a load which was from 70% to 95% of its current load-carrying capacity. Experimental creep curves display a three-stage process, consisting of primary, secondary and tertiary stages, with a decreasing, constant and increasing creep rate, respectively. The secondary stage dominates the whole failure lifetime, whereas both the secondary and tertiary stages are important in terms of creep deformation. Failure life-time seems to be more sensitive to the change of load level in flexural tests rather than in tensile tests. The decrease in load-carrying capacity due to damage tends to result in a shorter failure lifetime and a lower critical load level for creep rupture. The descending branch of the static load-deflection or load-CMOD curve may be used as an envelope criterion for creep fracture.     

Electrical and magnetic properties of Polystyrene doped with Iron nanoparticles

Summary Polymer composites have recently received a considerable amount of scientific and technological interest, because their properties can be properly controlled, choosing the adequate doped particles, their size and concentrations, and the synthesis conditions. In this work we report the synthesis and characterization of a polystyrene (PS) matrix doped with different concentrations of iron nanoparticles. X-ray diffraction and transmission electron microscopy were used to characterize the structure of the samples. The behaviour of the d.c. electrical conductivity (σ_dc) and the complex permittivity (ε*=ε^′-iε^′′) as a function of frequency (100 Hz–10 MHz) reflects the important effect of the iron nanoparticles concentration in the sample properties. A percolation threshold in the conductivity was observed at a critical concentration of iron nanoparticles. A noticeable increase in the saturation magnetization and coercivity is observed with the rise of the iron nanoparticles concentration, being thisbehaviour also noticed in the remanent magnetization. A rise of the initial a.c. susceptibility with the iron concentration is also observed.     

High growth rate process in a SiC horizontal CVD reactor using HCl

The results of a new epitaxial process using an industrial 6 × 2″ wafer reactor with the introduction of HCl during the growth have been reported. A complete reduction of silicon nucleation in the gas phase has been observed even for high silicon dilution parameters (Si/H₂ > 0.05%) and an increase of the growth rate until about 20 μm/h has been measured. Photoluminescence at room temperature and at 50 K was used for defects quantification and distribution. On these wafers grown using HCl high voltage Schottky diodes have been realized. The diodes were analyzed by current-voltage (I-V) characteristics.     

Beam search algorithms for the single machine total weighted tardiness scheduling problem with sequence-dependent setups

In this paper, we consider the single machine weighted tardiness scheduling problem with sequence-dependent setups. We present heuristic algorithms based on the beam search technique. These algorithms include classic beam search procedures, as well as the filtered and recovering variants. Previous beam search implementations use fixed beam and filter widths. We consider the usual fixed width algorithms, and develop new versions that use variable beam and filter widths.     

Sorafenib delivery nanoplatform based on superparamagnetic iron oxide nanoparticles magnetically targets hepatocellular carcinoma

Currently,sorafenib is the only systemic therapy capable of increasing overall survival of hepatocellular carcinoma patients.Unfortunately,its side effects,particularly its overall toxicity,limit the therapeutic response that can be achieved.Superparamagnetic iron oxide nanoparticles (SPIONs) are very attractive for drug delivery because they can be targeted to specific sites in the body through application of a magnetic field,thus improving intratumoral accumulation and reducing adverse effects.Here,nanoformulations based on polyethylene glycol modified phospholipid micelles,loaded with both SPIONs and sorafenib,were successfully prepared and thoroughly investigated by complementary techniques.This nanovector system provided effective drug delivery,had an average hydrodynamic diameter of about 125 nm,had good stability in aqueous medium,and allowed controlled drug loading.Magnetic analysis allowed accurate determination of the amount of SPIONs embedded in each micelle.An in vitro system was designed to test whether the SPION micelles can be efficiently held using a magnetic field under typical flow conditions found in the human liver.Human hepatocellular carcinoma (HepG2) cells were selected as an in vitro system to evaluate tumor cell targeting efficacy of the superparamagnetic micelles loaded with sorafenib.These experiments demonstrated that this delivery platform is able to enhance sorafenib's antitumor effectiveness by magnetic targeting.The magnetic nanovectors described here represent promising candidates for targeting specific hepatic tumor sites,where selective release of sorafenib can improve its efficacy and safety profile.     

The shape of feature code: an analysis of twenty C-preprocessor-based systems

Feature annotations (e.g., code fragments guarded by #ifdef C-preprocessor directives) control code extensions related to features. Feature annotations have long been said to be undesirable. When maintaining features that control many annotations, there is a high risk of ripple effects. Also, excessive use of feature annotations leads to code clutter, hinder program comprehension and harden maintenance. To prevent such problems, developers should monitor the use of feature annotations, for example, by setting acceptable thresholds. Interestingly, little is known about how to extract thresholds in practice, and which values are representative for feature-related metrics. To address this issue, we analyze the statistical distribution of three feature-related metrics collected from a corpus of 20 well-known and long-lived C-preprocessor-based systems from different domains. We consider three metrics: scattering degree of feature constants, tangling degree of feature expressions, and nesting depth of preprocessor annotations. Our findings show that feature scattering is highly skewed; in 14 systems (70 %), the scattering distributions match a power law, making averages and standard deviations unreliable limits. Regarding tangling and nesting, the values tend to follow a uniform distribution; although outliers exist, they have little impact on the mean, suggesting that central statistics measures are reliable thresholds for tangling and nesting. Following our findings, we then propose thresholds from our benchmark data, as a basis for further investigations.     

Lifetime evaluation of concrete structures under sustained post-peak loading

Experimental tests on crack propagation in concrete under constant post-peak loading are simulated using the finite element method and the cohesive crack model, in both Mode I and Mixed-mode conditions. The time-dependent behaviour of concrete in the process zone is due to the interaction and growth of microcracks, a phenomenon which, for high constant load levels, turns out to be predominant over linear viscoelastic creep in the bulk material. In mechanical systems based on this type of material behaviour (creep and strain-softening taking place simultaneously), the initial value problem is non-parabolic, i.e., the error at one time level is affected by the accumulation of errors introduced at earlier time levels. Despite these difficulties, the scatter in numerical failure lifetime vs. load level turns out to be negligible in Mode I conditions and practically acceptable in Mixed-mode conditions. Therefore the time-dependent behaviour of the process zone can be inferred solely from the results of direct tensile tests.