A Novel LRRK2 Variant p.G2294R in the WD40 Domain Identified in Familial Parkinson’s Disease Affects LRRK2 Protein Levels

Leucine-rich repeat kinase 2 (LRRK2) is a major causative gene of late-onset familial Parkinson’s disease (PD). The suppression of kinase activity is believed to confer neuroprotection, as most pathogenic variants of LRRK2 associated with PD exhibit increased kinase activity. We herein report a novel LRRK2 variant—p.G2294R—located in the WD40 domain, detected through targeted gene-panel screening in a patient with familial PD. The proband showed late-onset Parkinsonism with dysautonomia and a good response to levodopa, without cognitive decline or psychosis. Cultured cell experiments revealed that p.G2294R is highly destabilized at the protein level. The LRRK2 p.G2294R protein expression was upregulated in the patient’s peripheral blood lymphocytes. However, macrophages differentiated from the same peripheral blood showed decreased LRRK2 protein levels. Moreover, our experiment indicated reduced phagocytic activity in the pathogenic yeasts and α-synuclein fibrils. This PD case presents an example wherein the decrease in LRRK2 activity did not act in a neuroprotective manner. Further investigations are needed in order to elucidate the relationship between LRRK2 expression in the central nervous system and the pathogenesis caused by altered LRRK2 activity.     

Effects of SO2 on selective catalytic reduction of NO with NH3 over a TiO2 photocatalyst

The effect of SO₂ gas was investigated on the activity of the photo-assisted selective catalytic reduction of nitrogen monoxide (NO) with ammonia (NH₃) over a TiO₂ photocatalyst in the presence of excess oxygen (photo-SCR). The introduction of SO₂ (300 ppm) greatly decreased the activity of the photo-SCR at 373 K. The increment of the reaction temperature enhanced the resistance to SO₂ gas, and at 553 K the conversion of NO was stable for at least 300 min of the reaction. X-ray diffraction, FTIR spectroscopy, thermogravimetry and differential thermal analysis, x-ray photoelectron spectroscopy (XPS), elemental analysis and N₂ adsorption measurement revealed that the ammonium sulfate species were generated after the reaction. There was a strong negative correlation between the deposition amount of the ammonium sulfate species and the specific surface area. Based on the above relationship, we concluded that the deposition of the ammonium sulfate species decreased the specific surface area by plugging the pore structure of the catalyst, and the decrease of the specific surface area resulted in the deactivation of the catalyst.     

Anti‐Sway Crane Control Considering Wind Disturbance and Container Mass

A method for estimating the sway angle using an observer has already been proposed. The state observer estimates the sway angle accurately and must use the detected sway angle value. However, the estimated sway angle has an error owing to rope length error, friction force, and wind. Moreover, the container mass cannot be determined, and therefore the observer parameter is not suitable. We already proposed robust antisway control for overcoming rope length error without adding a new sensor. Further, we designed a friction disturbance observer to cancel out the influence of the friction force. In this paper, we first propose a container mass estimation method when a crane system performs rolling up control. The observer parameter can be selected using the estimated mass value. Second, in crane parallel shift control, we propose a robust antisway control even when there is a wind disturbance. We design a wind disturbance observer and propose a wind disturbance estimator to separate the friction observer output from the wind disturbance observer output. We confirm through experiments that the proposed method can reduce vibration.     

Analysis of Cerebrospinal Fluid Extracellular Vesicles by Proximity Extension Assay: A Comparative Study of Four Isolation Kits

There is a lack of reliable biomarkers for disorders of the central nervous system (CNS), and diagnostics still heavily rely on symptoms that are both subjective and difficult to quantify. The cerebrospinal fluid (CSF) is a promising source of biomarkers due to its close connection to the CNS. Extracellular vesicles are actively secreted by cells, and proteomic analysis of CSF extracellular vesicles (EVs) and their molecular composition likely reflects changes in the CNS to a higher extent compared with total CSF, especially in the case of neuroinflammation, which could increase blood–brain barrier permeability and cause an influx of plasma proteins into the CSF. We used proximity extension assay for proteomic analysis due to its high sensitivity. We believe that this methodology could be useful for de novo biomarker discovery for several CNS diseases. We compared four commercially available kits for EV isolation: MagCapture and ExoIntact (based on magnetic beads), EVSecond L70 (size-exclusion chromatography), and exoEasy (membrane affinity). The isolated EVs were characterized by nanoparticle tracking analysis, ELISA (CD63, CD81 and albumin), and proximity extension assay (PEA) using two different panels, each consisting of 92 markers. The exoEasy samples did not pass the built-in quality controls and were excluded from downstream analysis. The number of detectable proteins in the ExoIntact samples was considerably higher (~150% for the cardiovascular III panel and ~320% for the cell regulation panel) compared with other groups. ExoIntact also showed the highest intersample correlation with an average Pearson’s correlation coefficient of 0.991 compared with 0.985 and 0.927 for MagCapture and EVSecond, respectively. The median coefficient of variation was 5%, 8%, and 22% for ExoIntact, MagCapture, and EVSecond, respectively. Comparing total CSF and ExoIntact samples revealed 70 differentially expressed proteins in the cardiovascular III panel and 17 in the cell regulation panel. To our knowledge, this is the first time that CSF EVs were analyzed by PEA. In conclusion, analysis of CSF EVs by PEA is feasible, and different isolation kits give distinct results, with ExoIntact showing the highest number of identified proteins with the lowest variability.     

Strengthening of Preloaded RC Beams Using Hybrid Carbon Sheets

Reinforced concrete (RC) beams subject to service loads of 40 or 60% of steel yielding were strengthened using hybrid continuous carbon fiber sheets. The hybrid systems were made of high-strength and high-modulus carbon sheets, and compared with systems using only high-strength carbon. It was found that the use of high-modulus carbon sheets in hybrid systems could increase the yielding load, the flexural stiffness, the postyielding ductility, and reduce the crack opening in concrete. The slope changes on load-deflection curves at steel yielding are not noticeable in hybrid systems. The tensile strains developed in hybrid sheets after the fracture of high-modulus carbon are higher in magnitude and distributed in a larger area, leading to an ultimate carbon fracture with concrete crushing. These unique features are attributed to the high stiffness and low ultimate tensile strain of the high-modulus carbon fibers which stiffen the structures, avoid or delay the fiber-reinforced polymer debonding, and facilitate the deformability during their subsequent breakdown.     

Radiation detector made of a high-quality polycrystalline diamond

Radiation detector was made of a high-quality CVD polycrystalline diamond composed of frost column like structure diamond grains, and induced charge distribution spectra and drift velocities were measured by using alpha particles. As a result, the CVD polycrystalline achieved maximum induced charge of 83% of HP/HT type IIa diamond. Moreover, the CVD crystal had lower charge loss on electrons compared with the HP/HT type IIa diamond. Drift velocities of electrons and holes were v_e = 7.7 × 10⁴ and v_h = 7.3 × 10⁴cm/s at an electric field of 20 kV/cm, respectively. In addition, response function measurement for 14 MeV neutrons was carried out.     

Human peripheral eosinophils express functional interferon-gamma receptors (IFN-gammaR)

In order to determine whether or not IFN-gammaR is associated with regulatory mechanisms on human eosinophil function, we examined the expression of functional IFN-gammaR on human peripheral eosinophils. In this study, peripheral blood eosinophils were obtained from seven normal controls and 12 patients (bronchial asthma, n = 9, and hypereosinophilic syndrome (HES), n = 3), and the purity of eosinophils was 97.11 +/- 2.31%, n = 19. We first showed that anti-IFN-gammaR alpha-chain MoAb reacted with all tested eosinophils of both normal controls and patients by flow cytometry analysis. We also showed expression of mRNA for the alpha-chain of IFN-gammaR in all purified eosinophils of six individuals. Further, to characterize IFN-gammaR on eosinophils, we did binding experiments with 125I-IFN-gamma on purified peripheral eosinophils. The linear Scatchard plot indicated a single type of high-affinity binding sites (dissociation constant (Kd) = 3.89-4.95 x 10(-10) M, numbers of binding sites = 183-233/cell, n = 3). To determine whether IFN-gammaR on eosinophils is functional, we examined surface eosinophilic cationic protein (ECP) and CD69 induction after IFN-gammaR ligation with recombinant human IFN-gamma (rhIFN-gamma) on eosinophils by flow cytometry. rhIFN-gamma stimulation significantly induced both ECP and CD69 expression on the 2-18 h-cultured eosinophils in a dose-dependent manner. Further, the effects of rhIFN-gamma stimulation were significantly blocked by both a neutralizing anti-IFN-gamma MoAb and a blocking anti-IFN-gammaR MoAb. These results suggest that human peripheral eosinophils express functional IFN-gammaR.     

Boron removal by titanium addition in solidification refining of silicon with Si-Al melt

In order to effectively remove B from Si for its use in solar cells, a process involving B removal by solidification refining of Si using a Si-Al melt with Ti addition was investigated. For clarifying the effect of Ti addition on B removal from the Si-Al melt, TiB₂ solubilities in Si-64.6 at. pct Al melt at 1173 K and Si-60.0 at. pct Al melt at 1273 K were determined by measuring the equilibrium concentrations of B and Ti in the presence of TiB₂ precipitates. The small solubilities of TiB₂ in the Si-Al melt indicate the effective removal of B from the Si-Al melt by Ti addition. Further, solidification experiments of Si-Al alloys containing B by Ti addition were performed, and the effect of Ti addition on the solidification refining of Si with the Si-Al melt was successfully confirmed.     

Effects of surrounding brightness on visual search for safety colors

The present article reports the investigation of the effects of surrounding brightness on a visual search for three safety colors: red, orange, and yellow. Images of visual stimuli consisting of an array of colored circles placed on a large visual field (a visual angle of 40°) were displayed on an 80‐in. screen with a DLP projector. Experiment I examined the search efficiency under three levels of background luminance that were equivalent to the three target luminances. The results showed that the search efficiency for the orange target decreased as the number of distractors increased, under each of the background luminance levels, whereas the efficiency scarcely decreased for the red and yellow targets. Although a reduction in background luminance increased the search efficiency for the orange target, it is suggested that the effect of background luminance is smaller than the effect of the target color in search efficiency. Experiment II examined the search efficiency under three conditions of low levels of incident illuminance, which were matched with a linear regression to the luminance of color chips of safety colors measured twilight conditions. The results showed that the search efficiency for the orange target decreased as the number of distractors increased under each of the different illuminance conditions, whereas the efficiency scarcely decreased for red and yellow targets. Furthermore, as illuminance decreased, the search time for the orange target was more greatly impacted than for red or yellow. These results imply that the recognition of orange tends to be influenced by the surrounding brightness. © 2005 Wiley Periodicals, Inc. Col Res Appl, 30, 400–409, 2005; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/col.20152     

InGaAs-InGaAsP buried heterostructure lasers operating at 2.0 μm

Buried heterostructure lasers with highly strained InGaAs-InGaAsP active regions, emitting at 2 μm have been fabricated and tested. The lasers exhibited threshold current densities of 500 A/cm² for 1-mm-long cavities, an internal loss of 11 cm^-1, and characteristic temperatures as high as 50°C. The gain characteristics were also investigated and a linewidth enhancement factor of 8 was determined