Physical Properties Important to Electrostatic and Non electrostatic Powder Transfer Efficiency in a Tumble Drum

ABSTRACT: Popcorn was oiled and coated in a tumble drum nonelectrostatically and electrostatically with sugar, cornstarch, salt, cellulose, maltodextrin, all-purpose flour, whole-wheat flour, or soy flour. Particle size, density, flowability, and chargeability were correlated to transfer efficiency using regression analysis. Of the various methods to measure chargeability, charge-to-mass and adhesion improvement were the most significant. For nonelectrostatic coating, small, dense, free-flowing powders were most efficient. Small, free-flowing highly charging powders were most efficient for electrostatic coating. Percent improvement was the highest for the least efficient powders. The greatest benefit with electrostatic coating was for low density, highly charging powders with no effect of size.     

MetateM: An introduction

In this paper a methodology for the use of temporal logic as an executable imperative language is introduced. The approach, which provides a concrete framework, calledMetateM, for executing temporal formulae, is motivated and illustrated through examples. In addition, this introduction provides references to further, more detailed, work relating to theMetateM approach to executable logics.     

CTL* Model Checking on a Shared-Memory Architecture

In this paper we present a parallel algorithm for CTL* model checking on a virtual shared-memory high-performance parallel machine architecture. The algorithm is automata-driven and follows a games approach where one player wins if the automaton is empty while the other player wins if the automaton is nonempty. We show how this game can be played in parallel using a dynamic load balancing technique to divide the work across the processors. The practicality and effective speedup of the algorithm is illustrated by performance graphs.     

Corrosion of CVD Silicon Carbide in 500°C Supercritical Water

A high-purity CVD β-SiC showed a relatively low corrosion rate in deoxygenated supercritical water at 500°C. The corrosion rate was lower than that previously reported for CVD SiC in 360°C water and much lower than that reported for sintered and reaction-bonded SiC. The present study confirmed that CVD SiC was preferentially attacked at the grain boundaries. Analytical examinations did not reveal the presence of a measurable oxide scale. As a result, it is believed that corrosion of the high-purity SiC occurred via hydrolysis to hydrated silica species at the surface that were rapidly dissolved into the supercritical water.     

Sources and temporal dynamics of arsenic in a New Jersey watershed, USA

We examined potential sources and the temporal dynamics of arsenic (As) in the slightly alkaline waters of the Wallkill River, northwestern New Jersey, where violations of water-quality standards have occurred. The study design included synoptic sampling of stream water and bed sediments in tributaries and the mainstem, hyporheic-zone/ground water on the mainstem, and seasonal and diurnal sampling of water at selected mainstem sites. The river valley is bordered by gneiss and granite highlands and shale lowlands and underlain by glacial deposits over faulted dolomites and the Franklin Marble. Ore bodies in the Marble, which have been mined for rare Zn ore minerals, also contain As minerals. Tributaries, which drain predominantly forested and agricultural land, contributed relatively little As to the river. The highest concentrations of As (up to 34 mug/L) emanated from the outlet of man-made Lake Mohawk at the river's headwaters; these inputs varied substantially with season--high during warm months, low during cold months, apparently because of biological activity in the lake. Dissolved As concentrations were lower (3.3 microg/L) in river water than those in ground water discharging into the riverbed (22 microg/L) near the now-closed Franklin Mine. High total As concentrations (100-190 mg/kg) on the <0.63 microm fraction of bed sediments near the mine apparently result from sorption of the As in the ground-water discharge as well as from the As minerals in the streambed. As concentrations in river water were diluted during high stream flow in fall, winter and spring, and concentrated during low flow in summer. In unfiltered samples from a wetlands site, diurnal cycles in trace-element concentrations occurred; As concentrations appeared to peak during late afternoon as pH increased, but Fe, Mn, and Zn concentrations peaked shortly after midnight. The temporal variability of As and its presence at elevated concentrations in ground water and sediments as well as streamwater demonstrate the importance of (1) sampling a variety of media and (2) determining the time scales of As variability to fully characterize its passage through a river system.     

An Aerosol Wind Tunnel for Evaluation of Massive-Flow Air Samplers and Calibration of Snow White Sampler

Massive-flow air samplers are being deployed around the world to collect aerosol samples for analysis of radioactivity as a result of nuclear tests and nuclear accidents. An aerosol wind tunnel capable of an 1100 m³ min^?1 flow rate was built at Lovelace Respiratory Research Institute (LRRI) to test the sampling efficiency of these samplers. This aerosol wind tunnel uses a stationary air blender to enhance mixing, and therefore it achieves the required uniform distribution of wind speed and aerosol concentration in the test section. The test section of the wind tunnel has a cross section that is 4.3 m × 3.7 m. The aerosol wind tunnel was tested for performance in terms of distribution of wind speed, turbulent intensity, SF₆ tracer gas concentration, and aerosol concentration. Test criteria consistent with U.S. Environmental Protection Agency (EPA) and American National Standards Institute (ANSI) standards were adopted as the guidelines for the aerosol wind tunnel. Additional criteria for aerosol wind tunnel were also recommended. Initial test of the aerosol wind tunnel showed that the wind tunnel could be operated in a wind speed range of 2 to 24 km h^?1. Within this range, the distribution of wind speed SF⁶ trace gas concentration and aerosol concentration in two-thirds of the central area of the test section showed coefficient of variances (COVs) of less than 10% for the range of wind speeds. This met the stringent guidelines for aerosol wind tunnel performance set by EPA and ANSI standards.

The LRRI wind tunnel was used to evaluate the collection efficiency of the sampling head of massive-volume air samplers, including the Snow White sampler. The sampler was tested in this aerosol wind tunnel for particles between 2 and 20 μm. The sampling flow rates were 500 and 700 m³ h^?1 for the tested wind speeds of 2.2 and 6.6 m S^?1, respectively. The results showed that sampling efficiency was influenced by both sampling flow rate and wind speed. The sampling efficiency decreased with an increase in particle size of between 2 and 20 μm. The sampling efficiency also decreased as the wind speed was increased from 2.2 to 6.6 m S^?1.     

The Effect of Antibrowning Agents on Inhibition of Potato Browning,Volatile Organic Compound Profile,and Microbial Inhibition

Abstract: Burbank and Norkotah potato slices were dipped into 3% sodium acid sulfate (SAS), citric acid (CA), sodium erythorbate (SE), malic acid (MA), sodium acid pyrophosphate (SAPP), or a combination of SAS‐CA‐SE. Browning by polyphenol oxidase (PPO) obtained from potato extract with 0.04 to 0.016 g/mL of antibrowning solutions at pH 2.0 to 6.9 were measured by UV‐Vis spectroscopy. The color of slices dipped in antibrowning solutions at pHs 2 to 7 and stored at 4 °C for 15 d was measured every 5 d by colorimeter. Headspace analysis of volatiles in raw and cooked potato samples was performed by selected ion flow tube mass spectrometer (SIFT‐MS) and soft independent modelling by class analogy (SIMCA) analysis of the calculated odor activity values (OAV) determined interclass distances. Microbial growth was measured at 15 d. At unadjusted pHs (1.1 to 7.1), the PPO browning of the control and samples with SAPP was not significantly different, SAS, CA, and MA produced some inhibition and SE and SAS‐CA‐SE prevented browning. At pH 5 to 7, only SE and SAS‐CA‐SE were effective browning inhibitors. Based on the color of potato slices, SE was the most effective at pH 2 to 7, but SAS was most effective at unadjusted pH. Cooking increased volatile levels in the treated potatoes and decreased differences between volatile profiles. Differences between cooked samples may not be noticeable by the consumer because volatiles with high discriminating powers have low OAVs. SAS, CA, and SAS‐CA‐SE treatments inhibited microbial growth but SAPP, control, and SE did not, most likely due to pH. Practical Application: Antibrowning agents inhibit polyphenol oxidase, increasing shelf life and consumer acceptability of processed raw potato products by preserving the color. Their effectiveness was shown to be mainly due to a pH effect, except SE, which was not pH dependent. MA, CA, and SAS‐CA‐SE are better acidulants for inhibition of color change as well as growth of spoilage bacteria, yeast, and mold than SAPP, the industry standard.