Increasing Volumetric CO2 Uptake of Hypercrosslinked Polymers through Composite Formation

To overcome the drawbacks of solid microporous materials for CO₂ capture, this proof‐of‐concept study demonstrates a low‐cost and rapid method for producing composites consisting of hypercrosslinked polymers (HCP) with a polyethyleneimine (PEI) binder. The resulting materials capture CO₂ through physical and chemical absorption simultaneously. Compared with HCP, the composites exhibit higher CO₂ uptake, higher volumetric density, and improved tolerance to water which is attributed to the PEI binder.     

L’optimisation des réseaux cellulaires assistée par ordinateur: le logiciel RNO (Radio Network Optimisation)

Quality of service has become today a major concern for operators of mobile communication networks. The massive development of networks and strong competition between operators has lead to the necessary and daily follow-up of network quality of service, a key factor for its subscriber’s fidelity. This article aims at presenting the optimization methodology and proposes its illustration with a case of RNO (Radio Network Optimisation) software usage, one of the Alcatel optimization toolchain component. After a short presentation of cellular network, the optimization basic principles are described. RNO software and its main functionnalities are then detailed before a last part dedicated to a real case of optimization done with RNO software.     

Project to develop school education services in Delhi, India

There are many ways in which quantitative decision models can be applied in project management. The introduction of a project evaluation review technique network model to the development of a school education service in the city of Delhi, India, is described. The reasons for choosing this method, its advantages and limitations are discussed. Examples of the information obtained from the model are presented and explained.     

Semi-solid rapid compression testing of spray-formed hypereutectic Al-Si alloys

The rheology of Al-30Si-5Cu and Al-30Si-5Cu-2Mg spray-formed alloys has been characterized after holding at various times and temperatures, using semisolid rapid compression to obtain load-displacement curves. Microstructures were examined after partial remelting and compression in an attempt to understand the flow behavior. The initial resistance to flow generally increased with holding time at temperature. This increase was attributed to the increased strength of a three-dimensional (3-D) solid silicon network present in these alloys in the semisolid state, with the initial resistance to flow smaller in the magnesium-containing alloys. With increased temperature, the initial resistance decreased due to increased liquid content and grain spheroidization. The viscosity vs shear rate response was studied using the approach of Laxmanan and Flemings. The materials shear thinned rapidly during the test conditions, in which the shear rate rapidly increased from approximately 2.5 to 92 s⁻¹. The results were fitted to a power-law model, and the viscosities showed a drop of approximately two to four orders of magnitude when extrapolated to a shear rate of 1000 s⁻¹ (a typical value in actual component manufacture). The rapid compression test, which is close to conditions present in component manufacture, was shown to have more in common with a shear rate jump experiment, rather than steady-state viscometry.