The Function of Sialidase Revealed by Sialidase Activity Imaging Probe

Sialidase cleaves sialic acid residues from glycans such as glycoproteins and glycolipids. In the brain, desorption of the sialic acid by sialidase is essential for synaptic plasticity, learning and memory and synaptic transmission. BTP3-Neu5Ac has been developed for sensitive imaging of sialidase enzyme activity in mammalian tissues. Sialidase activity in the rat hippocampus detected with BTP3-Neu5Ac increases rapidly by neuronal depolarization. It is presumed that an increased sialidase activity in conjunction with neural excitation is involved in the formation of the neural circuit for memory. Since sialidase inhibits the exocytosis of the excitatory neurotransmitter glutamate, the increased sialidase activity by neural excitation might play a role in the negative feedback mechanism against the glutamate release. Mammalian tissues other than the brain have also been stained with BTP3-Neu5Ac. On the basis of information on the sialidase activity imaging in the pancreas, it was found that sialidase inhibitor can be used as an anti-diabetic drug that can avoid hypoglycemia, a serious side effect of insulin secretagogues. In this review, we discuss the role of sialidase in the brain as well as in the pancreas and skin, as revealed by using a sialidase activity imaging probe. We also present the detection of influenza virus with BTP3-Neu5Ac and modification of BTP3-Neu5Ac.     

Anti‐Sway Crane Control Considering Wind Disturbance and Container Mass

A method for estimating the sway angle using an observer has already been proposed. The state observer estimates the sway angle accurately and must use the detected sway angle value. However, the estimated sway angle has an error owing to rope length error, friction force, and wind. Moreover, the container mass cannot be determined, and therefore the observer parameter is not suitable. We already proposed robust antisway control for overcoming rope length error without adding a new sensor. Further, we designed a friction disturbance observer to cancel out the influence of the friction force. In this paper, we first propose a container mass estimation method when a crane system performs rolling up control. The observer parameter can be selected using the estimated mass value. Second, in crane parallel shift control, we propose a robust antisway control even when there is a wind disturbance. We design a wind disturbance observer and propose a wind disturbance estimator to separate the friction observer output from the wind disturbance observer output. We confirm through experiments that the proposed method can reduce vibration.     

A new write/erase method to improve the read disturbcharacteristics based on the decay phenomena of stress leakage currentfor flash memories

This paper describes a new write/erase method for flash memory to improve the read disturb characteristics by means of drastically reducing the stress leakage current in the tunnel oxide. This new write/erase operation method is based on the newly discovered three decay characteristics of the stress leakage current. The features of the proposed write/erase method are as follows: 1) the polarity of the additional pulse after applying write/erase pulse is the same as that of the control gate voltage in the read operation; 2) the voltage of the additional pulse is higher than that of a control gate in a read operation, and lower than that of a control gate in a write operation; and 3) an additional pulse is applied to the control gate just after a completion of the write/erase operation. With the proposed write/erase method, the degradation of the read disturb life time after 10⁶ write/erase cycles can be drastically reduced by 50% in comparison with the conventional bipolarity write/erase method used for NAND type flash memory. Furthermore, the degradation can he drastically reduced by 90% in comparison with the conventional unipolarity write/erase method fur NOR-, AND-, and DINOR-type flash memory. This proposed write/erase operation method has superior potential for applications to 256 Mb flash memories and beyond     

The heat transfer and pressure drop characteristics of finned tube banks in forced convection (effects of fin height on pressure drop characteristics)

In recent years the requirement for the reduction of energy consumption has been increasing to solve the problems of global warming and the shortage of petroleum resources. For example, in the power generation field, as thermal power generation occupied 60% of the power generation demand, considerable improvement of the thermal efficiency is required. This paper describes the pressure drop characteristics of finned tube banks used for heat exchangers in thermal power generation that were clarified by testing serrated finned tube banks with different fin heights for improved heat transfer and conventional spiral finned tube banks with different fin heights, and an equation to predict pressure drop which is necessary for the heat exchanger design is proposed. © 2006 Wiley Periodicals, Inc. Heat Trans Asian Res, 35(3): 179–193, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.20112     

Heavy arsenic doping of silicon grown by atmospheric pressure selective epitaxial chemical vapor deposition

Selective epitaxial Si with a high arsenic concentration of 2.2×10¹⁹ atoms/cm³ was deposited at a high growth rate of 3.3 nm/min under atmospheric pressure. It was confirmed that this method had excellent selectivity and produced films having good crystalline quality, abrupt dopant profiles at the interfaces, and smooth surfaces. The growth mechanism is discussed in terms of the relationship between the effects of arsenic surface segregation and etching by hydrogen chloride.     

An abnormally shortened fatigue life of steels caused by anelasticity

Some abnormal fatigue life shortenings dependent upon load frequency for several steels are discussed. A possible relation between anelasticity caused by interstitial atoms and the abnormal fatigue life drop is presented. Normally, interstitial atoms are in a position which minimizes the energy around a dislocation, the Snoek ordering sites. We consider the Snoek effect as a typical example of anelasticity, and the possibility on atoms moving from attractive sites to repulsive ones when repeated stresses are applied and discuss a theory to explain the reduction of the fatigue life using Snoek ordered atoms moving out by fatigue stress at the frequency of Snoek effect. Bending fatigue tests were conducted to obtain the relationship between fatigue life and load frequency at two different temperatures (298 K and 333 K) for an iron nitrided steel. A sharp fatigue life drop was observed at a load frequency corresponding to the resonant frequency of the Snoek effect for nitrogen atoms. The frequency was about 3 Hz and 298 K and shifted to a higher frequency — about 6 Hz — at 333 K. Results reveal that the possible explanation to those abnormal phenomena may be anelasticity.Work partially conducted at Laboratorio E and Departamento de Ciencias de Materiales, Universidad Simón Bolívar, Venezuela.     

Ion exchange of intercalation compounds from WOP2O7 and intercalation ofn-alkylamines

Ion exchange of Na _x WOP₂O₇ ·nH₂O (x 1.4) prepared from WOP₂O₇ was attempted, using alkaline and alkaline earth ions. The degree of exchange was observed to be >50% at 90° C except for Mg²⁺. The basal spacing of ion-exchanged materials for the hydrated phase were dependent on the number of water molecules in the interlayer spaces, while those for the dehydrated phase increased with the size of ions in the interlayer spaces. The network of water molecules linked by the hydrogen bond in the interlayer spaces seems to determine the basal spacing. By the ion-exchange reaction,n-alkylammonium ions were intercalated into the interlayer spaces of Na _x WOP₂O₇ ·nH₂O (x 1.4) and Sn _x H _y WOP₂O₇ ·nH₂O (2x +y 0.5). In spite of the difference in the charge density of the host layer, a similar arrangement of alkyl chains in the interlayer spaces resulted, and neutral amines were considered to be intercalated as well as ammonium ions. Direct reaction ofn-alkylamine with WOP₂O₇ produced an intercalation compound without reduction of tungsten. The arrangement of the amines in the interlayer spaces is similar to that supposed to the ion-exchanged derivatives when heated at 140° Cin vacuo.     

Stromal CCL5 Promotes Breast Cancer Progression by Interacting with CCR3 in Tumor Cells

Chemokines secreted from stromal cells have important roles for interactions with carcinoma cells and regulating tumor progression. C-C motif chemokine ligand (CCL) 5 is expressed in various types of stromal cells and associated with tumor progression, interacting with C-C chemokine receptor (CCR) 1, 3 and 5 expressed in tumor cells. However, the expression on CCL5 and its receptors have so far not been well-examined in human breast carcinoma tissues. We therefore immunolocalized CCL5, as well as CCR1, 3 and 5, in 111 human breast carcinoma tissues and correlated them with clinicopathological characteristics. Stromal CCL5 immunoreactivity was significantly correlated with the aggressive phenotype of breast carcinomas. Importantly, this tendency was observed especially in the CCR3-positive group. Furthermore, the risk of recurrence was significantly higher in the patients with breast carcinomas positive for CCL5 and CCR3 but negative for CCR1 and CCR5, as compared with other patients. In summary, the CCL5-CCR3 axis might contribute to a worse prognosis in breast cancer patients, and these findings will contribute to a better understanding of the significance of the CCL5/CCRs axis in breast carcinoma microenvironment.