Dealumination–aging pattern of REUSY zeolites contained in fluid cracking catalysts

The evolution of the properties of a REUSY zeolite contained in a fluid cracking catalyst was investigated under laboratory steam deactivation procedures and in age fractions of the corresponding equilibrium catalyst (Ecat). The aging pattern, defined by the evolution of the zeolite surface area (ZSA) related to the decrease of the unit cell size (UCS), was similar between lab-steamed zeolites and Ecat fractions. A sharp drop in ZSA occurred at ca. 2.430 nm UCS. A study done by FT-IR spectroscopy suggested that zeolite dealumination initially took place more extensively on the sodalite cages and double six-member rings (D6R) of the structure and that the final collapse of the zeolite framework occurred through destruction of the 12-member rings (12M). This can be explained by a crystal fracture and break down process and disassembling of the sodalite cages in the faujasite structure. NH₃ microcalorimetry showed that strong acid sites in faujasites are destroyed by steam aging, but this effect does not lead to a reduction in the cracking activity of the Ecat form. The microactivity test (MAT) showed that the specific activity declined sharply at 2.430 nm UCS. Differences in product selectivity were related to the extent of damage of the zeolite, extra-framework alumina and mesoporosity. While further aging canceled the effect attributed to extra-framework alumina differences attributed to mesoporosity increased.     

CHOP vs. ProMACE-CytaBOM in the treatment of aggressive non-Hodgkin's lymphomas: long-term results of a multicenter randomized trial.(PETHEMA: Spanish Cooperative Group for the Study of Hematological Malignancies Treatment, Spanish Society of Hematology)

From May 1985 to May 1989, 175 patients with previously untreated aggressive non-Hodgkin's lymphoma were randomized to receive CHOP or ProMACE-CytaBOM. Eligibility criteria included follicular large-cell diffuse small cleaved-cell, diffuse mixed, diffuse large-cell and immunoblastic lymphoma with an Ann Arbor stage II, III or IV. One hundred and forty-eight patients were evaluable. There were no significant differences between the 2 treatments in response rate (83.5% [57.5% CR] for CHOP vs. 88% [62% CR] for ProMACE-CytaBOM), time to treatment failure (29% vs. 31% at 5 yr), or overall survival (42% in both groups at 5 yr). Furthermore, there were no significant differences between the 2 regimens when response rates and outcome were analyzed for different prognostic subgroups. Toxicity was not significantly different between the 2 regimens, although only 1 patient died as result of treatment-related toxicity in the CHOP arm compared to 6 patient in the ProMACE-CytaBOM group (p = 0.126). In conclusion, in this study ProMACE-CytaBOM has not proved to be superior to CHOP in aggressive lymphomas. This trial gives support to the notion that CHOP still is the standard chemotherapy for aggressive lymphomas, and that new treatment approaches for these lymphomas should be compared to CHOP.     

Mapping of Trellises Associated with General Encoders onto High-Performance VLSI Architectures

A rate 1/n binary generic convolutional encoder is a shift-register circuit where the inputs are information bits and the outputs are blocks of n bits generated as linear combinations on the appropriate shift register contents. The decoding of the outputs of a convolutional encoder can be carried out by the well-known Viterbi algorithm. The communication pattern of the Viterbi Algorithm is given as a graph, called trellis, associated to the state diagram of the corresponding encoder. In this paper we present a methodology that permits the efficient mapping of the Viterbi algorithm onto a column of an arbitrary number of processors. This is done through the representation of the data flow by using mathematical operators which present an inmediate hardware projection. A single operator string has been obtained to represent a generic encoder through the study of the data flow of free-forward encoders and feed-back encoders. The formal model developed is employed for the partitioning of the computations among an arbitrary number of processors in such a way that the data are recirculated opimizing the use of the processors and the communications. As a result, we obtain a highly regular and modular architecture suitable for VLSI implementation.     

Deletions and loss of expression of p16INK4a and p21Waf1 genes are associated with aggressive variants of mantle cell lymphomas

Mantle cell lymphoma (MCL) is molecularly characterized by bcl-1 rearrangement and cyclin D1 gene overexpression. Some aggressive variants of MCL have been described with blastic or large cell morphology, higher proliferative activity, and shorter survival. The cyclin-dependent kinase inhibitors (CDKIs) p21Waf1 and p16INK4a have been suggested as candidates for tumor-suppressor genes. To determine the role of p21Waf1 and p16INK4a gene alterations in MCLs, we examined the expression, deletions, and mutations of these genes in a series of 24 MCLs, 18 typical, and 6 aggressive variants. Loss of expression and/or deletions of p21Waf1 and p16INK4a genes were detected in 4 (67%) aggressive MCLs but in none of the typical variants. Two aggressive MCLs showed a loss of p16INK4a expression. These cases showed homozygous deletions of p16INK4a gene by Southern blot analysis. An additional aggressive MCL in which expression could not be examined showed a hemizygous 9p12 deletion. Loss of p21Waf1 expression at both protein and mRNA levels was detected in an additional aggressive MCL. No p21Waf1 gene deletions or mutations were found in this case. The p21Waf1 expression in MCLs was independent of p53 mutations. The two cases with p53 mutations showed p21Waf1 and p16INK4a expression whereas the 4 aggressive MCLs with p16INK4a and p21Waf1 gene alterations had a wild-type p53. p21Waf1 and p16INK4a were expressed at mRNA and protein levels in all typical MCLs examined. No gene deletions or point mutations were found in typical variants. Two typical MCLs showed an anomalous single-stranded conformation polymorphism corresponding to the known polymorphisms at codon 148 of p16INK4a gene and codon 31 of p21Waf1 gene. These findings indicate that p21Waf1 and p16INK4a alterations are rare in typical MCLs but the loss of p21Waf1 and p16INK4a expression, and deletions of p16INK4a gene are associated with aggressive variants of MCLs, and they occur in a subset of tumors with a wild-type p53 gene.     

Analysis of low load transients for the Vandellòs-II NPP: Application to operation and control support

The Technical University of Catalonia (UPC) has been jointly working with the Asociación Nuclear Ascó-Vandellòs (ANAV) for a number of years in order to establish, qualify and use best estimate (BE) models for the reactors under the control of ANAV. ANAV is the consortium that is responsible for operation of the Ascó and Vandellòs-II reactors. The reactors are Westinghouse-design three-loop PWRs with an approximate electrical power of 1000 MW. The existing integral plant models for each plant are currently used for many different purposes among which are support of plant operation and control. Quite a number of studies have been done in order to improve both safety and plant competitiveness. Most of these dynamic analyses were carried out in relation to transients starting at nominal full power or at least, very close to full power. This paper develops a specific use of the Vandellòs-II plant model for operation and control support at low power involving new ranges of system actuation parameters. It also examines scenarios that are somewhat different from those typically analysed. The study starts showing the results of an assessment case, which is a start-up test and provides some additional qualification, and subsequently attempts to establish calculations to support both an improvement in feed water controls and to set up operating recommendations for low-load manual operation of feed water turbo-pump. Both results hopefully, will produce an outcome, which leads to an improvement in safety and reduces reactor trip probability.     

Should patients with sleep apnoea/hypopnoea syndrome be diagnosed and managed on the basis of home sleep studies?

The purpose of this study was to analyse the validity and the economic efficiency of a portable monitor of respiratory parameters (PMRP), used in a home setting for the diagnosis of sleep apnoea/hypopnoea syndrome (SAHS). Eighty nine patients with suspected SAHS were studied in two settings: in the sleep laboratory using full-polysomnography (full-PSG); and at the patient's home using a PMRP. In the home setting, 50 patients were assisted by a technician and 39 set up the equipment themselves. SAHS (apnoea/hypopnoea index (AHI) >10 events x h(-1) by means of full-PSG) was diagnosed in 75 of the 89 patients. An acceptable agreement was obtained between the AHI measured by full-PSG and PMRP, according to the Bland and Altman method of concordance (mean bias 2.56; 95% confidence interval 3.25). Sensitivity and specificity of PMRP were adequate for diagnostic purposes; however, their values rely on the prior PMRP-AHI cut-off point selected with reference to full-PSG-AHI >10. The clinical therapeutic decision taken after PMRP agreed with that taken with full-PSG in 79 patients (89%). Although 10% of the studies with an individual set-up needed repetition, both of the domiciliary modalities (with and without a technician's intervention) were, economically, about three times more efficient than full-PSG. In conclusion, we believe that patients with a suspected sleep apnoea/hypopnoea syndrome should initially be studied in a home setting with a portable monitor of respiratory parameters, since it is a reliable method with an acceptable cost-effective profile.     

Structure of nylon 7 solution grown crystals

Single crystals of nylon 7 prepared by crystallization from glycerine were studied by both X-rays and electron microscopy. Electron diffraction proved that they consist of a twinned layered-structure with hydrogen bonds running parallel to their long dimension. Polyethylene decoration of such crystals showed that they are subdivided in folding domains so that both chain folding and hydrogen bonding take place along the same crystallographical planes.     

Vinylic graft copolymers of cellulose. I. Effects of monomer concentrations and crystallinity index of cellulosic substrate on grafting vinyl acetate onto cotton

Graft copolymerization of vinyl acetate (VA) and methyl acrylate (MA) on cotton cellulose was initiated by the Ce (IV) ion, and ungrafted vinylic polymer was separated from the graft copolymer by acetone extraction. The influence of the ratio aqueous initiator solution volume/monomeric volume (V_aq/V_mon), vinyl acetate volume/methyl acrylate volume (V_VA/V_MA), and the cellulose crystallinity index (CI) on the grafting reaction were studied. To modify the crystallinity of cellulose, native cotton was treated with NaOH in the concentrations 10, 15, and 20% (mercerized). The viscosimetric average molecular weight (M_v), the polymerization degree (PD), and the crystallinity index proposed by Nelson and O'Connor (CI) were determined for native and NaOH-treated cotton. The polymeric side chains grafted were separated from the cellulose backbone by acid hydrolysis in 72% H₂SO₄. The viscosimetric average molecular weight (M_v) was determined, and the number of vinylic chains per cellulosic chain (graft frequency, GF) were calculated. The grafting percentage, %G, was higher for most amorphous cellulose and for a higher methyl acrylate percentage (%MA) in monomeric reaction mixtures (VA-MA). The V_aq/V_mon ratio that yields the highest %G was 70/30. The increase of the %G with the %MA in the VA–MA monomeric mixture seems to be due to both an increase in the length of vinylic grafted chains (as shown by its M_v) and the number of grafted chains (GF). The increase in the %G when the crystallinity index (CI) of the cellulosic substrate decreases seems to be due to an increase in the length of the vinylic grafted chains, but not to an increase in the number of grafted chains, since the M_v increases and GF decreases when the CI of cellulose decreases.     

Viscoelastic behaviour of vinylic copolymers of cellulose and their glass transition temperature by DSC

The viscoelastic response of some vinylic copolymers of cellulose prepared with vinyl acetatemethyl acrylate mixtures and with Ce(IV) ion as initiator, and native cellulose, were studied at 110 Hz in a range of temperatures from ?120–100°C. The viscoelastic spectrum of cellulose shows the β-relaxation that is not shown in its vinylic copolymers. We observed the same effect in the dielectric β-relaxation. For the vinylic copolymers of cellulose, one viscoelastic relaxation attributed to the α-relaxation of the grafted vinylic chains is observed. Some differences in the characteristics of this relaxation may be related to the composition of PVA/PMA vinylic side chains and to the ratio of cellulose in the copolymer. The plots of the Argand diagrams give us a better understanding of the viscoelastic behaviour of these materials. The results seem to indicate that the cellulose hinders the large-scale motions of the vinylic chains grafted onto it. The glass transition temperature (T_g) determined by differential scanning calorimetry (DSC) also shows the same fact: the T_g of the vinylic copolymers of cellulose are higher than both the T_g of polyvinyl acetate–polymethyl acrylate copolymers (PVA–PMA) without cellulose and the T_g of some blends of cellulose and the PVA–PMA whose composition was as similar as possible to the cellulosic copolymers. The importance of the covalent bonds between cellulose and the vinylic side chains in the structural transitions are revealed. The present results are compared with the dielectric α-relaxation that we described elsewhere. © 1993 John Wiley & Sons, Inc.     

A quantitative feedback solution to the multivariable tracking error problem

This paper introduces a novel solution for the multi‐input multi‐output (MIMO) quantitative feedback theory control design problem with tracking error specifications. Looking for a minimum controller overdesign, the technique finds new controller quantitative feedback theory bounds based on necessary and sufficient conditions for the existence of suitable associated prefilter matrix elements. It improves previous approaches to the subject and includes (i) the possibility of a free selection of the nominal plant, (ii) a less conservative application of the Schwartz inequality to decisively reduce the potential controller overdesign, (iii) a methodology to design independently the elements of the prefilter matrix, and (iv) a scope of application to both sequential and nonsequential MIMO controller design methods. The benefits of the new control design technique are illustrated by means of two examples. The first one, a standard 2 × 2 MIMO problem, is provided for comparison purposes with previous approaches. The second example, included as a major control challenge, deals with a well‐known demanding distillation column benchmark problem. Copyright © 2013 John Wiley & Sons, Ltd.