Superconductivity in the tetragonal phase of La1.9Bi0.1CuO4+δ annealed under high oxygen pressure

We have investigated the relation between the crystal structure and superconductivity in La_1.9Bi_0.1CuO_4+δ , in which the phase separation observed in La₂CuO_4+δ is suppressed. A phase diagram in theT?δ plane is given for La_1.9Bi_0.1CuO_4+δ with excess oxygen. For very smallδ values, the crystal structure is orthorhombic, and an orthorhombic-tetragonal phase transition occurs markedly atδ ～ 0.03 in the measured temperature range between 13 and 293 K. Superconductivity is observed in the range of 0.04<δ<0.11. This is clear evidence thathigh-T _c superconductivity also appears in the tetragonal phase.     

Separation of di- and tripeptides with solvent extraction and an emulsion liquid membrane

The extraction equilibria of various di- and tripeptides with di-2-ethylhexylphosphoric acid (D2EHPA) were studied at low pH values. The complex extracted to organic phase consisted of one molecule of peptide and two molecules of D2EHPA dimer. The extraction constants of the peptides correlated well with the distribution coefficients of peptides between 1-octanol and water, which is a measure of hydrophobicity. The permeation rates of peptides through an emulsion liquid membrane were examined by using D2EHPA as a carrier, Span 80 as an emulsifier and kerosene as a diluent. The rates varied considerably with peptide type, depending upon the hydrophobicity.     

New balance ground relay for parallel four-circuit transmission lines

A 66-kV network generally is grounded through a neutral grounding resistor. In this network a single-phase ground-fault current is limited to as small as 100 to 400 A. There are parallel four-circuit transmission lines mounted on the same tower in the 66-kV network. In such transmission lines, the load and the fault currents could induce circulating current that flows through the lines. Since the circulating current has zero-phase-sequence and negative-phase-sequence components, it could cause unwanted operation of a balance ground relay using zero-phase-sequence current. However, it is difficult to compensate for the circulating current by the conventional vector compensation scheme. This paper presents a new balance ground relay to deal with the circulating current. In the relay from the ground-fault inception until first tripping, the difference current Δ3I_2d of negative-phase-sequence current 3I_2d of the differential current between two protected lines is used as an input current. The Δ3I_2d is the difference current of 3I_2d between, before and during faults. After the first tripping, the difference current of positive-phase-sequence load current and zero-phase-sequence current of the forementioned differential current are used as an input current. Consequently, a higher sensitivity of the ground-fault protection for these lines has been achieved. The correct operation of the new balance ground relay was confirmed when a single-phase-ground-fault occurred in the parallel four-circuit transmission lines, to which the relay is applied.     

Thermal instability of Bi-Pb-Sr-Ca-Cu-O superconductor around 650δC

Bi_0.85Pb_0.15Sr_0.8CaCu_1.4O _y superconductor was quenched to room temperature after annealing at several temperatures in air. From the initial magnetization curve measurement for the annealed samples, it was found that the volume fraction of superconducting phases of the sample annealed at 650°C greatly decreased. TEM observation revealed that a second phase often appeared in the grain-boundary region for the sample annealed at 700°C. The second phase was identified as Bi₁Pb₂Sr_2.6Ca_1.6O _y by energy dispersive spectroscopy.     

Zeolite synthesis from paper sludge ash with addition of diatomite

BACKGROUND: This study aimed to investigate the synthesis of zeolites from paper sludge ash (PSA) with added diatomite to remove both NH₄⁺ and PO₄^3? for water purification. The PSA had low Si and significant Ca contents. Four types of diatomite: white (T‐W) and brown (T‐B) from deposits of marine origin in Takanosu, and white (S‐W) and gray (S‐G) from lacustrine deposits in Shonai, were added to NaOH solution to increase the Si content and thereby synthesize zeolites with high cation exchange capacity (CEC). RESULTS: The order of the amounts of Si extracted from the diatomite to the alkali solution was S‐W > T‐W = T‐B > S‐G, which correlates with the amorphous SiO₂ content of diatomite. The original ash without addition of diatomite yielded hydroxysodalite with CEC of about 1.0 mmol g^?1. For all samples, the addition of diatomite to the solution yielded zeolite‐P with a higher CEC, but the addition of excess Si inhibited the synthesis of zeolite‐P, and the CEC of the product was low. A product with high CEC including zeolite‐P was obtained in a solution with around 500 mmol L^?1 of Si concentration, and had the ability to remove both NH₄⁺ and PO₄^3?. CONCLUSION: Diatomite has the potential for used as an additive for the synthesis of high CEC zeolite from PSA. The product with zeolite‐P exhibited relatively high CEC, capacity for NH₄⁺ uptake, and the ability to remove PO₄^3? by precipitation, which is preferable for water purification applications. Copyright © 2008 Society of Chemical Industry     

A reconfigurable VLSI-based double-lens tracking camera

Watching and tracking an object while seeing a much wider view is one of advantages of the eye system. We proposed and developed a tracking camera system that mimics the eyes by using double-lens modules. In the system, a wide view is captured through the wide-lens module, while the target in it is tracked and magnified through the telescopic lens module. Electronic circuits for tracking control are implemented onto the reconfigurable VLSI or FPGA in order to embed the parallelism in the tracking algorithm into the hardware. A successfully developed FPGA-based prototype performs high-speed tracking at the video-rate. This work was present in part at the 12th International Symposium on Artificial Life and Robotics, Oita, Japan, January 25–27, 2007     

Current collecting efficiency of micro tubular SOFCs

In this study, current collecting efficiency of the micro tubular solid oxide fuel cell (SOFC) was estimated to determine optimum size of the micro tubular SOFC. Two models for collecting current from single terminal (ST) and double terminal (DT) of anode tube were proposed and used to calculate the current collecting efficiency as functions of anode thickness, tube length and operating temperature. It was shown that design of the cell geometry and current correcting method are significantly important to achieve high performance micro tubular SOFC stacks. The efficiency loss estimated from the DT model was about 2–4-fold lower than those of obtained from the ST model. The DT model was shown to be more effective for higher operating temperature and the tube length.     

Production of Ceramic Green Bodies Using a Microwave-Reactive Organic Binder

Because the pyrolysis of organic substances can result in the emission of harmful pollutant gases, a reduction in the use of organic binders is one aim of today's ceramics industry. A novel ceramic-forming process was developed that requires considerably less organic binder than conventional techniques. The process involves immobilizing reactive molecules on the surfaces of the particles, which on subsequent irradiation with microwaves, form bridges that bind the entire particle assembly together. The chemical forces involved produce strong bonds, resulting in a significant reduction in the amount of organic binder that is required to maintain the shape of the ceramic green body. This method will help to decrease emissions of harmful gases produced from pyrolysis of the binder.     

Electrical properties of diphenyldiacetylene annealed under elevated pressure

A unique class of conjugated compounds composed of the derivative of condensed polycyclic aromatic compound with the phenyl group and diphenyldiacetylene oligomer was synthesized by annealing of diphenyldiacetylene under elevated pressure. The effect of annealing pressure on the conductivity of the compounds was studied. The total conductivity of the compound decreased with a decrease of frequency, approaching a constant value (dc conductivity: C_dc). The dc conductivity of the compound increased from below 10^?15 to 10 S cm^?1 with increasing annealing pressure. The dc conductivity of the oligomer was below 10^?15 S cm^?1 and that of the derivative increased from 10^?8 to 10 S cm^?1 with decreasing H/C (H/C:0.45–0.04). The conduction of the conjugated compound was electronic. The temperature coefficient of those dc conductivities was positive, with an approximately linear relation between In (C_dcT^0.5) and (1/T)^0.25, where T is the temperature. The ac conductivities C_ac were proportional to temperature and frequency f and had the following equation C_ac = Tf^S, S = 0.67–0.75. These results showed that the conduction mechanism can be explained by the hopping in a manifold of states at the Fermi level. © 1994 John Wiley & Sons, Inc.     

Effect of Microstructural Control on Thermoelectric Properties of Hot-Pressed Aluminum-Doped Zinc Oxide

The thermal conductivity of polycrystalline Al-doped ZnO was controlled through the fabrication of nanostructured polycrystalline materials, by hot-pressing nanosized Zn_{1– x} Al _x O ( x = 0.01, 0.02) particles, which were synthesized by a coprecipitation and spray-drying method. This process resulted in an improved thermoelectric power factor because of the nanosized Zn_0.99Al_0.01O particles of the polycrystalline products. The thermal conductivity also was decreased as a result of the formation of nanocrystalline Zn_0.99Al_0.01O.