Synthesis and photovoltaic properties of mono-substituted quaterthiophenes bearing strong electron-withdrawing group

We report here on the synthesis and properties of a monosubstituted quaterthiophene derivative asymmetrically functionalized by an electron-withdrawing group using the palladium-catalyzed Stille's coupling reaction. The UV–vis absorption spectrum evidences a strong intramolecular charge transfer transition. Thus oligothiophenes act as electron donors and substituent group as acceptor. The diodes in which monosubstituted quaterthiophenes behave as organic semiconductors, exhibit a rectifying behavior. Photovoltaic measurements show moderate power conversion efficiency.     

Crack effects on gas and water permeability of concretes

The relationship between load-induced cracking and concrete permeability is studied. Ordinary concrete (OC) and high-performance concrete (HPC), including steel fiber-reinforced concrete (HPFRC), are used. Two discs, 50 mm-thick slices, cut from 110-220 mm cylindrical specimens are diametrically loaded, as for a normal splitting test. The lateral displacement, also called the crack opening displacement (COD) is monitored for each loading cycle. After unloading, gas and finally water permeability tests are both performed, using constant head permeameter, to compare the influence of the percolating fluid and the COD. Due to the wide range of measured gas flow, Klinkenberg's and Dupuit-Forcheimer's laws are applied to compute the intrinsic gas permeability. Results suggest it increases proportionally to the cube of the COD and it matches water permeability, if only the first water percolating time is considered. The roughness parameter of the cracks induced in each concrete, is compared and discussed.     

Adaptive scheduling mechanism for IPTV over WiMAX IEEE 802.16j networks

A WiMAX technology is a very promising Broadband Wireless Access technology that is able to transmit different service types. This latter can have different constraints such as traffic rate, maximum latency, and tolerated jitter. The IEEE 802.16 Medium Access Control specifies five types of QoS classes: UGS, rtPS, ertPS, nrtPS, and BE. However, the IEEE 802.16 standard does not specify the scheduling algorithm to be used. Operators have the choice among many existing scheduling techniques. Also, they can propose their own scheduling algorithms. In this paper, we propose a scheduling strategy (Adaptive Weighted Round Robin, AWRR) for various Internet Protocol Television (IPTV) services traffic over 802.16j networks. Our scheme adapts dynamically the scheduler operation to according queue load and quality of service constraints. In particular, the proposed mechanism gives more priority to high definition television and standard definition television traffic by using two schedulers. The proposed scheduling algorithm has been simulated using the QualNet network simulator. The experimental results show that our scheduler schemes AWRR have a better performance than the traditional scheduling techniques for rtPS traffic, which allows ensuring QoS requirements for IPTV application. Copyright © 2012 John Wiley & Sons, Ltd.     

A passivity‐based simple adaptive synergetic control for a class of nonlinear systems

For a class of nonlinear systems with the representation {A(x), B(x), C} and where the system parameters and dynamics are unknown, a simple adaptive synergetic controller ensuring the asymptotic convergence of the system to a desired manifold is proposed based on the technique of simple adaptive control (SAC). It is well known that the design of the synergetic control (SC) law requires a thorough knowledge of the system parameters and dynamics. Such problem obstructs the synthesis of the SC law and the designer is prompted to pass through the estimation methods, which, in turn, poses a problem of increasing the computation time of the control algorithm. To cope with this problem, a solution is proposed by modifying the original SC law to develop an SAC‐like adaptive SC law without the need of prior knowledge of the system. The stability of the proposed adaptive controller is formally proven via the Lyapunov approach. Experimental application to a quadrotor system is given to validate the theoretical results.     

Management of excess energy in a photovoltaic/grid system by production of clean hydrogen

In this article, the authors design a new clean storage device for a photovoltaic system (PV) reinforced by the electrical grid. The photovoltaic system supplies power to a DC load. When the power of the photovoltaic source is insufficient, the electrical grid compensates the energy deficit. On the other hand, if the load is satisfied and the PV source is still able of supplying energy, the energy excess is diverted to an own storage unit materialized by an electrolysis which produces gaseous hydrogen by the process of electrolysis of water. The authors show that the quantity of hydrogen produced is proportional to the photovoltaic energy excess and also to the flow of water injected into the electrolysis. In this case, it is a question of designing an electrolysis with specific characteristics, which takes into account the quantity of energy excess and the flow of water injected into it. The authors abandon the idea of controlling the water flow by means of a pumping-electrovalve system, and initiate the idea of replacing the function of the pump by the action of gravity. The work focuses on the development of an electrolysis optimization approach using the water flow control in its alliance with the PV power excess which is also maximized. For an optimized use of the global system (load and electrolysis), the authors present an architecture based on energy-converting structures (DC/DC and AC/DC). In addition, to increase the reliability and safety of the system, the authors finish by developing a power management strategy (PMS) in the designed system. This power management strategy organizes the energy flow and selects the appropriate path of this flow between the two energy sources (PV and electrical grid) and the two possible energy receivers (load and electrolysis). A complete modeling of the system is developed in the Matlab/Simulink environment. The simulation results show that the hybrid system (PV and electrical grid) is able to permanently supplying the load and potentially storing the excess of the PV energy in the form of hydrogen gas.     

Compared imbibitions of ordinary and high performance concrete with null or positive water pressure head

A method to simultaneously measure the moisture diffusion coefficient, D_θ, of unsaturated concrete, and the saturated concrete hydraulic conductivity, K_l, was developed for cylindrical specimens placed on a container filled with water that could be maintained at a given hydraulic pressure. Ordinary Portland cement Concrete (OPC) with a moderate and High Performance Concrete (HPC) with a low water to cement ratio were tested. The time dependent distribution of water content in the specimens was measured using a non-intrusive method based on gamma-ray attenuation. The measurements were conducted with varying hydraulic head (positive or null). Boltzmann's transformation was used to analyze the experimental results obtained at different hydraulic pressures and the difference between the null (or atmospheric) and positive pressure results is used to accurately determine K_l and also D_θ . This paper will present the results obtained using this original method, possible interpretations and future research.     

Scalable Multicast Provisioning in DiffServ with MPLS Labeling

The phenomenal growth of multimedia applications imposes scalable and efficient network support. The DiffServ and MPLS architectures were developed to provide QoS. The combination of both architectures presents a very attractive strategy to backbone network providers. However, integrating native IP multicasting with MPLS supports DiffServ is a quite comple issue. Major problems are: the lack of labels in MPLS networks, the core routers simplicity in DiffServ and the multicast state scalability problems, since it requires routers to keep a forwarding state for every multicast tree passing through it. In addition, the number of states grows with the number of groups. Under such circumstance, we propose an hybrid label aggregation algorithm in order to solve multicast scalability problem and provide a solution for multicast in MPLS support DiffServ. In the proposed scheme, one label is assigned per multicast groups (logical aggregation) and different multicast groups sharing the same output interface in a router are aggregated locally (physical aggregation). Also, in order to support the proposed algorithm, we propose a separate treatment and labels space (prime numbers range) for multicast traffic. The proposed solution allows consuming fewer labels, reducing the forwarding table and consequently the total packet processing delay.     

Effect of Nanopowder Addition on the Sintering of Water-Atomized Iron Powder

Metallurgical and Materials Transactions A - A promising method of improving the densification of powder metallurgical steel components is to blend nanopowder with the otherwise typically used...     

A robust auto‐adaptive approach for serial acquisition of generalized multi‐carrier spread spectrum in multipath fading mobile channels

In this paper, a new robust auto‐adaptive approach for pseudo‐noise (PN) code acquisition is proposed. It is applied to the generalized multi‐carrier direct‐sequence code‐division multiple‐access (MC DS‐CDMA) systems communicating over frequency‐selective multipath Rayleigh fading channels. This new approach is based on the constant false alarm rate (CFAR) detection algorithm, referred here as automatic selection partial sum ordered statistics (ASPSOS)‐CFAR. The proposed approach does not require any prior information about the background environment and uses maximum likelihood estimation (MLE) method to detect the interfering signals group in the ranked cells for the full reference window. Once this group is identified and censored, the remaining smaller ranked cells are combined to form an estimate of the background noise level to compute the adaptive threshold. Through simulations, the performance of the proposed detector is analyzed and compared with traditional CFAR detectors based on fixed or automatic censoring algorithms. The obtained results show that the proposed detector eliminates the drawbacks of the previously related detectors and offers a robust detection performance to enhance the acquisition process in heterogeneous background environments.     

Control of Grid Connected Photovoltaic Systems with Microinverters: New Theoretical Design and Numerical Evaluation

This paper addresses the problem of controlling grid connected photovoltaic (PV) systems that are driven with microinverters. The systems to be controlled consist of a solar panel, a boost dc–dc converter, a DC link capacitor, a single‐phase full‐bridge inverter, a filter inductor, and an isolation transformer. We seek controllers that are able to simultaneously achieve four control objectives, namely: (i) asymptotic stability of the closed loop control system; (ii) maximum power point tracking (MPPT) of the PV module; (iii) tight regulation of the DC bus voltage; and (iv) unity power factor (PF) in the grid. To achieve these objectives, a new multiloop nonlinear controller is designed using the backstepping design technique. A key feature of the control design is that it relies on an averaged nonlinear system model accounting, on the one hand, for the nonlinear dynamics of the underlying boost converter and inverter and, on the other, for the nonlinear characteristic of the PV panel. To achieve the MPPT objective, a power optimizer is designed that computes online the optimal PV panel voltage used as a reference signal by the PV voltage regulator. It is formally shown that the proposed controller meets all the objectives. This theoretical result is confirmed by numerical simulation tests.