低密度微泡沫压井液的研究与应用

吐哈油田部分区块地层压力系数小于0.9,常规水基压井液对储层伤害大,若使用油基压井液成本高,环境污染严重。通过实验优选出了一种低密度水基微泡沫压井液。该压井液具有密度低、泡沫强度高、稳定性好、携砂能力强等优点。现场应用表明,低密度微泡沫压井液稳定时间大于48 h,密度在0.70~0.99 g/cm3之间可调,抗油污染能力强,抗油大于8%,抗温在100℃以上,岩心污染后渗透率恢复值大于80%;并且施工方便,成本低,具有储层保护能力,使用微泡沫压井液的井表皮系数在0.20~2.34之间。     

合成吡啶类化合物用催化剂的再生行为研究

对合成吡啶类化合物用的失活催化剂上的结焦物进行了元素分析 ,并着重对失活催化剂的再生行为进行了研究。得到了不同失活程度催化剂的再生曲线及相同失活程度、不同再生条件下的再生曲线。经回归求得了一简单的再生反应动力学经验方程式 ,其中反应级数为碳含量的 1.16 5级 ,活化能为 4 2 .5 72kJ/mol,计算值与实验值的平均相对误差为 6 .5 %。     

氩等离子体辐照反相乳液接枝改性涤纶织物的研究

首次提出了在等离子体辐照后再用反相乳液接枝改性涤纶织物的新方法,探讨了接枝颗粒特征以及织物各项物理力学性能.接枝织物的结构及性能的测试结果表明:接枝物的尺寸远小于纤维的直径,在提高织物吸湿性的同时,对织物透气性能和强力等无明显影响;实验也证实了乳液中未接枝单体可以再次聚合.     

金堆地区浅基础设计的实践

通过对金堆地区建筑物稳定性变化的分析，提出了金堆地区浅基础设计的见解，阐明了在进行浅基础设计时，应在综合分析地质、地形、地貌、建筑物特性等因素的基础上，进行择优选择，对该地区的浅基础设计有一定的指导意义。     

Stored energy analysis of Zn—5Al eutectic alloy in superplastic deformation

The stored energy and the energy release during SPD(superplastic deformation)of a Zn-5Al alloy were studied.The alloy after rolling process gains more stored energy,and the as-rolled speciment can obtain maximum elongation and minimum flow stress without hot loding treatment before SPD.Experimental results show that stroed energy release process is along with SPD process and is also an impetus to SPD.The as -rolled Zn-5Al alloy has 48J/mol stored energy which was measured with DSC(differential scanning calorimeter)and conforms well to the calcuated value.The as-rolled Zn-5Al alloy after SPD with an elongation of 2500% releases 112J/mol stored energy,Analysis shows that the strain rate is in direct ratio to the rate of stred energy release.     

ANALYSIS AND PROCESSING OF LMF－COSTAS STEPPED FREQUENCY RADAR SIGNAL

Linear Modulated Frequency (LMF) Costas Stepped Frequency Radar (SFR) signal is introduced. Its ambiguity function is derived and analyzed in detail and its feasibility is validated in theory. The scheme of the proposed signal processing is also presented. The results of theoretic analysis and simulation show that, by using the proposed signal and increasing the bandwidth of the total stepped frequency, the ambiguity sidelobe is well suppressed and the range-velocity coupling in the stepped frequency radar is also greatly weakened.     

Fuzzy estimation of feed-cutting force from current measurement-a case study on intelligent tool wear condition monitoring

It is very important to use a reliable and inexpensive sensor to obtain useful information about manufacturing processing, such as cutting force for monitoring automated machining. In this paper, the feed-cutting force is estimated using inexpensive current sensors installed on the ac servomotor of a computerized numerical control (CNC) turning center, with the results applied to the intelligent tool wear monitoring system. The mathematical model is used to disclose the implicit dependency of feed-cutting force on feed-motor current and feed speed. Afterwards, a neuro-fuzzy network is used to identify the cutting force with current measurement only. This hybrid math-fuzzy approach will reduce the modeling uncertainty and measurement cost. Finally, the estimated cutting force is applied in the tool-wear monitoring process. Successful experiments demonstrate robustness and effectiveness of the suggested method in the wide range of tool-wear monitoring applications.     

驻极体声传感器及其储电材料的现状

综述了驻极体声传感器及其储电材料近年来的迅猛发展。传统的FEP(tetrafluoroethylene—hexa—fluoropropylene copolymer)极体电容式声传感器及以铁电聚合物PVDF(poly vinylidene fluoride)家族为芯片的声传感器和超声抉能器仍焕发着青春活力。Si基微型驻极体声传感器的理论和实验研究已经日趋成熟，而用空间电荷型多孔聚合物驻极体压电薄膜为芯片可望研制出新一代声电和电声传感器、压力传感器和驱动器。     

会计信息失真现象的博弈分析

在对现实进行合理假定的基础上建立了会计信息失真现象的有限完美信息动态博弈模型，并利用后退归纳法找到了五个满足不同条件的纳什均衡解。通过对均衡条件的分析，找出了导致会计信息失真的治理结构原因和法律制度因素，并提出了建设性的解决措施。     

有源滤波器的设计

首先阐明有源滤波器的基本概念和传递函数,然后着重介绍具有低灵敏度的GIC型双运放电路和在较高频率时应用的开关电容滤波器,最后举例说明它们的应用.