Rates for intramolecular excimer formation of poly(α-methylstyrene) measured by using picosecond pulse radiolysis

Summary The rate constants for intramolecular excimer formation, k_DM, of poly(α-methylstyrene) with different molecular weight were determined by using picosecond pulse radiolysis. Values of k_DM for poly(α-methylstyrene) are a little smaller than those for polystyrene with nearly same molecular weight. It appears to be mainly due to steric hindrance by methyl substituent of main chain.     

Murine coronavirus-induced subacute fatal peritonitis in C57BL/6 mice deficient in gamma interferon

Gamma interferon-deficient (IFN-gamma-/-) mice with a C57BL/6 background were infected intraperitoneally with mouse hepatitis virus strain JHM (JHMV). In contrast to IFN-gamma-+/- and IFN-gamma+/+ mice, JHMV persisted in IFN-gamma-/- mice and induced death during the subacute phase of the infection. Unexpectedly, infected IFN-gamma-/- mice showed severe peritonitis accompanying the accumulation of a viscous fluid in the abdominal and thoracic cavities in the subacute phase. Destructive changes of hepatocytes were not observed. Administration of recombinant IFN-gamma protracted the survival time of IFN-gamma-/- mice after JHMV infection. These results demonstrate that IFN-gamma plays a critical role in viral clearance in JHMV infection. They also show that a resultant persistent JHMV infection induces another form of disease in IFN-gamma-/- mice, which bears a resemblance to feline infectious peritonitis in cats.     

Preparation and characterization of porous and electrically conducting carbon-clay composites

Porous and electrically conducting carbon-clay composites were prepared by firing mixtures of carbon powder (0 to 20 wt%) and clay minerals. They showed porosity of 50 to 65% and had high mechanical strength (compressive strength = 130 to 400 kg cm^–2) as well as high resistance against thermal oxidation in air. Their electrical conductivity, , increased with increasing carbon content levelling off at about 20 wt% of carbon content to give a value of about 2 S cm^–1. Formation of carbon chains is considered to be responsible for the electrical conduction in the composite, and a model to correlate the electrical conductivity with the carbon content has been proposed by modifying a model previously proposed by Scarisbrick.     

Numerical computation for clustering of carbon particles with various sizes under both natural and magnetizing convections

The behavior of carbon particles from 0.01 to diameters in natural convection flow field of air was numerically studied including the effect of the magnetic field and the Brownian motion. One thousand carbon particles were released randomly in a vertical cylindrical enclosure whose height is equal to its radius. The enclosure was heated from below and cooled from above to produce the bulk flow of the natural convection of air in the atmospheric condition. A coil with electric current was set coaxially at the enclosure bottom to produce a magnetic field. Sample computations are carried out for the enclosure of 3 cm high and maximum magnetic field is 2.8 T or less. The results show that the natural convection of air is enhanced by the magnetic field. With the increase in the magnetic strength, more particles go along the fluid streak lines. With the increase in the particle size, more particles get together at the vortex center and cluster.     

WATER MIST FLOW IN A SUPERCONDUCTING MAGNET INCLINED AT VARIOUS ANGLES

Water mist (diamagnetic) flow in a superconducting magnet of 10 T at various angles is studied experimentally and numerically. Water mist is produced by ultrasonic atomizers and fed into a cylindrical Plexiglas pipe (inner diameter, 90 mm) placed in a bore space of an inclined superconducting magnet. The water mist is found to stop at some locations in the magnet at inclined angles ψ ≤ π/6. At ψ ≥ π/4, the amount of mist flowing out of the other opening of the pipe increases with an increase in inclined angle. In the computation of this phenomenon, water mist is simulated with 1000 water droplets of 3 μm diameter. Brownian motion is considered and the Langevin equation is solved. The numerical results show that at ψ ≤ π/6, most of the water droplets accumulate above the magnetic coil. However, at ψ ≥ π/4, with an increase in inclined angle, the number of water droplets passing through the magnetic coil increases.     

Fabrication of fluorine-terminated diamond-like carbon thin film using a hyperthermal atomic fluorine beam

Surface modification of diamond-like carbon (DLC) film was performed using a hyperthermal atomic fluorine beam on the purpose of production of hydrophobic surface by maintaining the high hardness of DLC film. By the irradiation of atomic fluorine beam of a 1.0 × 10²⁰ atoms/cm², the contact angle of a water drop against the DLC surface increased from 73° to 111°. The formation of CF₃, CF₂ and CF bonding on the modified DLC surface was confirmed from the measurements of X-ray photoelectron spectra and near-edge X-ray absorption fine structure spectra. Irradiation of hyperthermal atomic fluorine beam was concluded to produce insulator fluorine-terminated DLC film, which has high F content on the surface, by the taking of the use of neutral atomic beam as a fluorine source.     

Comparison of CTOD standards: BS 7448-Part 1 and revised ASTM E1290

Crack tip opening displacement (CTOD) has been calculated using the plastic hinge model with an assumed rotational center since the British Standards Institution (BS) standardized BS5762 in 1979. The American Society for Testing and Materials (ASTM) accepted the plastic hinge model and standardized E1290 in 1989. However, ASTM revised E1290 in 2002, and has proposed a conversion from J to CTOD. CTOD-based fracture toughness evaluation has been widely used for the defect assessment of many welded structural components, and two different CTOD calculations could lead to confusion for Fitness-for-Service. In this study, the effects of CTOD testing methodologies on CTOD values were investigated according to round robin tests conducted by the Japan Welding Engineering Society (WES), and the concept of CTOD as a fracture parameter is discussed.     

Interactions between nano-spacing flying head sliders and ultra-thin liquid lubricant films with non-uniform distribution in hard disk drives

This paper describes the effect of ultra-thin liquid lubricant films on air bearing dynamics and flyability of less than 10 nm spacing flying head sliders in hard disk drives. In particular, the effect of non-uniform lubricant film distributions on head/disk interface dynamics are studied. The disks with lubricant on one half of disk surface thicker than the other half were used in this study. The dynamics of sliders is monitored using acoustic emission (AE) and the interactions between the slider and disk are investigated experimentally. The disks were also examined with a scanning micro-ellipsometer before and after each test. Complicated slider responses were observed and clarified. In addition, it was found that the periodic lubricant film thickness modulations or non-uniformity caused by the slider-disk contact interactions could be observed. It is suggested that this lubricant film thickness non-uniformity will be one of the technical issues in order to achieve ultra-low head/disk contact interface of less than 10 nm.     

Impaired tumorigenicity of IL-4-producing murine neuroblastoma cells in immunodeficient nude mice

OBJECTIVE: Our purpose was to evaluate the clinical utility of serum uric acid measurements in the hypertensive diseases of pregnancy. STUDY DESIGN: We performed a nested case-control study to assess the clinical utility of serum uric acid measurements in women with hypertensive diseases of pregnancy. We identified 344 women who had serum uric acid measurements at term and categorized them into five diagnostic groups according to definitions of hypertensive diseases in pregnancy published by the National Working Group on Hypertension in Pregnancy: transient hypertension of pregnancy (n = 69), preeclampsia (n = 130), chronic hypertension (n = 23), chronic hypertension with superimposed preeclampsia (n = 29), and normal (n = 93). We compared the mean uric acid concentration for each group with use of a one-way analysis of variance and Scheffe's post hoc test and calculated the sensitivities and specificities in diagnosing preeclampsia as well as the likelihood ratios for serum uric acid values of 5.5, 6.0, and 6.5 mg/dl. We also examined the correlation between serum uric acid levels and several clinical outcome measures in women with hypertensive diseases of pregnancy. RESULTS: The mean serum uric acid values for women with preeclampsia (6.2 +/- 1.4 mg/dl) and transient hypertension (5.6 +/- 1.7 mg/dl) were significantly higher than those of controls (4.3 +/- 0.8 mg/dl, p < 0.05). The difference in mean serum uric acid values between women with chronic hypertension (4.9 +/- 1.0 mg/dl) and superimposed preeclampsia (5.8 +/- 1.4 mg/dl) were not statistically significant. The likelihood ratio of having preeclampsia with a serum uric acid value of 5.5 mg/dl was 1.41 in gestational hypertension of pregnancy and 2.5 in chronic hypertension. With use of a receiver-operator characteristic curve, we were unable to identify a serum uric acid value that could be used to differentiate various hypertensive diseases of pregnancy. There was a weak correlation between serum uric acid values and several clinical outcome measures of preeclampsia (r = 0.06 to 0.26). CONCLUSION: Although mean serum uric acid values are elevated in women with preeclampsia, the clinical utility of serum uric acid values in differentiating various hypertensive diseases of pregnancy appears to be limited. In the setting of chronic hypertension, however, a serum uric acid level of > or = 5.5 mg/dl could identify women with an increased likelihood of having superimposed preeclampsia.