Wettability alteration and retention of mixed polymer-grafted silica nanoparticles onto oil-wet porous medium

Enhanced oil recovery(EOR)processes are applied to recover trapped or residual oil in the reservoir rocks after primary and secondary recovery methods.Changing ...     

Accelerated convergence for a normal state layered superconductor’s transverse resistance expression,measured with strip contacts

The expression of the transverse resistance for an ohmic parallelepipedic layered conductor, measured with strip contacts, extended along its width, is a slowly convergent series. This series is reworked and transformed to the sum of an analytical part and an exponentially convergent series, which reduces considerably the number of terms needed for the numerical evaluation. In addition, an asymptotic formula is obtained, valid for Γ < 2, Γ is the effective anisotropy. This formula is used to determine the room temperature resistivity anisotropy of two small Γ layered superconductors, which are 2H–NbSe₂ and 2H–TaSe₂.     

A comparative evaluation of crumb rubber and devulcanized rubber modified binders

One of the most prominent uses of ground tire rubber (GTR) is in rubber-modified asphalt industry. Besides improving performance properties of binders, GTR induces some drawbacks like weak storage stability and inferior low temperature (LT) performance. This study sought to rectify these shortcomings through using devulcanized rubber (DVR) in place of common GTR. Binder performance grading, multiple stress creep and recovery, and storage stability tests were conducted. More resistance against traffic loads at high temperatures was observed as DVR's advantages over GTR, while its weaker LT characteristics and lower storage stability can prevent it from being a viable alternative.     

Petrographic and petrophysical characterization of some Paleozoic rocks,Um Bogma area,Southwest Sinai,Egypt

Sixty-two samples were collected from the five formations at Um Bogma area, (Southwest Sinai, Egypt). Nine samples were collected from Sarabit El Khedim Formation, ten samples were collected from Abu Hamata Formation, eighteen samples were collected from Adedia Formation, eight samples were collected from Um Bogma Formation and eighteen samples were collected from Abu Thora Formation.The Paleozoic rocks at Um Bogma area, consist mainly of sandstones, siltstones, shales, limestone and dolostones, which are unconformably overlie igneous and metamorphic rocks (granite, diorite and gneiss) of Precambrian age.The petrographic studies were applied to identify different rock units, different facies and its diagenetic history and to reveal its effect on the storage capacity properties. Different types of porosity (oversized, intergranular, fracture and vuggy porosities) have been identified based on the petrographic investigation of the studied thin sections.The Paleozoic sandstone rock samples are characterized by porosity average about 19% for Facies 1 (quartz wack) and about 18%for Facies 2 (quartz arenite) and permeability average 420?mD for Facies 1 (quartz wack) and 690?mD for Facies 2 (quartz arenite), so these rocks can be considered as good reservoir rocks. The Paleozoic carbonate rock samples (Facies 3) are characterized by poor porosity (less than 7%) and very low permeability (less than 0.5?mD), which caused by matrix and diagenetic processes and refer to bad reservoir rocks.Porosity can be linked to the two derived electrical properties (formation resistivity factor and electrical tortuosity) of the studied Paleozoic rocks at Um Bogma area. The electrical tortuosity has significant effects on both permeability and formation resistivity factor. The permeability decreases with increasing electrical tortuosity and the relation between both of them is inverse relationship with good coefficient of correlation. The permeability decreases with increasing electrical tortuosity and the relations between both of them are inverse relationships with high coefficient of correlation. The formation resistivity factor increases with increasing electrical tortuosity and the relations between both of them are positive relationships with a fair to very high coefficient of correlation.     

Classes of Discrete Decreasing and Increasing Mean-Residual-Life Distributions

Discrete failure-time distributions can be appropriate to model lifetimes. This paper represents two well-known non-parametric families of discrete distributions: decreasing and increasing mean-residual-life. It provides two parametric families of discrete distributions which are suitable for fitting decreasing and increasing mean-residual-life models to discrete life-test data.     

Evaluation of Lepidium sativum seed and guar gum to improve dough rheology and quality parameters in composite rice–wheat bread

The effects of hydrocolloids in rice–wheat flour were studied. Hydrocolloids at 0%, 0.3%, 0.6% and 1% w/w (flour basis) and guar (G), Lepidium sativum seed (L) and guar-L. sativum seed (GL) gum were tested as additives to the rice/flour in various combinations. The quality parameters for the experiment were assessed with farinography, extensography, amylography and texture profile analysis. The evaluation of dough rheology showed that water absorption, dough development time, dough stability and viscosity all increased with the addition of hydrocolloids alone or in a combination. It was demonstrated that G₁L₁ promoted the highest effect. The mixing tolerance index and gelatinization temperature decreased with an increased hydrocolloid concentration. Extensibility value for the dough that incorporated guar and L. sativum seed gum increased with increasing hydrocolloid concentration from 0.3% to 0.6% and then decreased at 1%. The water activity of all bread didn't have significant differences with increasing hydrocolloids concentration but this parameter 24 decreased during storage. Firmness decreased with increasing hydrocolloid concentration and increased with increasing storage time. The sensory evaluation by a consumer panel gave the higher score for overall acceptability to G_0.3L_0.3 and G_0.3L_0.6 samples. The results also showed that G₁L₁, G₁L_0.6 and G_0.6L₁ samples had high specific volume and porosity.     

Prediction of Egg Freshness and Albumen Quality Using Visible/Near Infrared Spectroscopy

Important changes occur in egg during storage leading to loss of quality. Prediction of these changes is critical in order to monitor egg quality and freshness. The aim of this research was to evaluate application of visible (VIS) and near infrared (NIR) spectroscopy as a rapid and non-destructive technique for egg quality assessment. Three hundred and sixty intact white-shelled eggs freshly laid by the same flock of hens fed with a standard feed were obtained. They were put under controlled conditions of temperature and humidity (T = 18 °C and RH = 55%) for 16 days of storage. Forty eggs were analyzed at day 0, 2, 4, 6, 8, 10, 12, 14, and 16. Transmission spectral data was obtained in the range from 350 to 2,500 nm. The non-destructive spectral data was compared to egg sample’s Haugh unit (HU) and albumen pH in terms of quality and to the number of storage days in terms of freshness. A partial least squares predictive model was developed and used to link the destructive assessment methods and the number of storage days with the spectral data. The correlation coefficient between the measured and predicted values of HU, albumen pH, and number of storage days were up to 0.94, R ² was up to 0.90 and the root mean square error values for the validation were 5.05, 0.06, and 1.65, respectively. These results showed that VIS/NIR transmission spectroscopy is a good tool for assessment of egg freshness and albumen pH and can be used as a non-destructive method for the prediction of HU, albumen pH, and number of storage days. In addition, the relevant information about these parameters was in the VIS and NIR ranging from 411 to 1,729 nm.     

Inclined hot-wire response equations for a flow field having a dominant tangential velocity component

Modified sets of response equations have been derived for a single inclined hot-wire probe introduced in various orientations in a flow field having a dominant tangential velocity component. By means of these equations, the components of the three dimensional mean velocity vectors, the turbulence intensity and the Reynolds stresses can be easily determined at any location in a swirling flow which is stationary with time. This method is particularly applicable to the characterization of the flow field in chemical processing equipment where this type of swirling flow is increasingly being used. It has been successfully applied to a study of the flow field in a spray-drying chamber, in the course of which good reproducibility and consistency of results were obtained.     

Co-Production of Fungal Biomass Derived Constituents and Ethanol from Citrus Wastes Free Sugars without Auxiliary Nutrients in Airlift Bioreactor

The potential of two zygomycetes fungi, Mucor indicus and Rhizopus oryzae, in assimilating citrus waste free sugars (CWFS) and producing fungal chitosan, oil, and protein as well as ethanol was investigated. Extraction of free sugars from citrus waste can reduce its environmental impact by decreasing the possibility of wild microorganisms growth and formation of bad odors, a typical problem facing the citrus industries. A total sugar concentration of 25.1 g/L was obtained by water extraction of citrus waste at room temperature, used for fungal cultivation in shake flasks and airlift bioreactor with no additional nutrients. In shake flasks cultivations, the fungi were only able to assimilate glucose, while fructose remained almost intact. In contrast, the cultivation of M. indicus and R. oryzae in the four-liter airlift bioreactor resulted in the consumption of almost all sugars and production of 250 and 280 g fungal biomass per kg of consumed sugar, respectively. These biomasses correspondingly contained 40% and 51% protein and 9.8% and 4.4% oil. Furthermore, the fungal cell walls, obtained after removing the alkali soluble fraction of the fungi, contained 0.61 and 0.69 g chitin and chitosan per g of cell wall for M. indicus and R. oryzae, respectively. Moreover, the maximum ethanol yield of 36% and 18% was obtained from M. indicus and R. oryzae, respectively. Furthermore, that M. indicus grew as clump mycelia in the airlift bioreactor, while R. oryzae formed spherical suspended pellets, is a promising feature towards industrialization of the process.     

Creeping flow relative to permeable spheres

The several possible solutions to the problem of creeping flow relative to an isolated permeable sphere are discussed and compared quantitatively. The most satisfactory solutions is that based upon Brinkman's extension of Darcy's Law. This solution is generalized, using Happel's free-surface model, to cover the practically important problem of flow relative to a swarm of permeable spheres. A physically realistic and mathematically consistent expression for the hydrodynamic resistance experienced by a typical sphere within such a system is derived. This expression is then used to predict the settling rate and the overall permeability of the swarm.