Optical properties of gadolinia-doped cubic yttria stabilized zirconia single crystals

Cubic zirconia single crystals stabilized with yttria and doped with Gd₂O₃ (0.10–5.00 mol%) were prepared by the optical floating zone method, and characterized by a combination of X-ray diffraction (XRD), and Raman, electron paramagnetic resonance (EPR), ultraviolet–visible (UV–Vis), photoluminescence excitation (PLE) and photoluminescence (PL) spectroscopic techniques. XRD and Raman spectroscopy showed that the crystal samples were all in the cubic phase, whereas the ceramic sample consisted of a mixture of monoclinic and cubic phases. The absorption spectrum showed four peaks at 245, 273, 308, and 314 nm in the ultraviolet region, and the optical band gap differed between samples with ≤3.00 mol% and those with >3.00 mol% Gd₂O₃. The emission spectrum showed a weak peak at 308 nm and a strong peak at 314 nm, which are attributed to the ⁶P_5/2 → ⁸S_7/2 and ⁶P_7/2 → ⁸S_7/2 transitions of Gd³⁺, respectively. The intensities of the peaks in the excitation and emission spectra increased with Gd³⁺ concentration, reached a maximum at 2.00 mol%, then decreased with higher concentrations. This quenching is considered to be the result of the electric dipole-dipole interactions, and this interpretation is supported by the Gd³⁺ EPR spectra, which showed progressive broadening with increasing Gd³⁺ concentration throughout the concentration range investigated.     

Effect of Bimodal Grain Size Distribution on the Strain Hardening Behavior of a Medium-Entropy Alloy

The evolution of strain hardening behavior of the Fe_(50)(CoCrMnNi)_(50) medium-entropy alloy as a function of the fraction of recrystallized microstructure and the grain size was studied using the Hollomon and Ludwigson equations.The specimens under study were partially recrystallized,fully recrystallized with ultrafine-grained microstructure,and fully recrystallized with coarse grains.The yield strength decreases steadily as the fraction of recry stallized micro structure and grain size increases due to the recovery process and the Hall-Petch effect.Interestingly,the bimodal grain distribution was found to have a significant impact on strain hardening during plastic deformation.For instance,the highest ultimate tensile strength was exhibited by a 0.97 μm specimen,which was observed to contain a bimodal grain distribution.Furthermore,using the Ludwigson equation,the effect of the bimodal grain distribution was established from the behavior of K_2 and n1 curves.These curves tend to show very high values in the specimens with a bimodal grain distribution compared to those that show a homogenous grain distribution.Additionally,the bimodal grain distribution contributes to the extensive L(u|")ders strain observed in the 0.97 μm specimen,which induces a significant deviation of the Hollomon equation at lower strains.     

Influence of bunch maturation and chemical precursors on acrylamide formation in starchy banana chips

The present study investigated the effect of ripening stages and chemical precursors on acrylamide formation in deep-fried chips of five plantains and one cooking banana. The highest level of acrylamide was found in the cooking banana, followed by False Horn plantain and French plantain, respectively. French plantain hybrids exhibited a significantly lower (P < 0.05) level of acrylamide when compared to French plantain. The ripening stage demonstrated a positive Pearson correlation (P < 0.05, r = 0.57) with acrylamide formation. As ripening progressed, the levels of glucose and fructose significantly increased (P < 0.05) and showed a positive correlation with acrylamide formation (r = 0.85 and 0.96, respectively). The level of the amino acid asparagine during ripening was not correlated with acrylamide formation. In contrast, the level of histidine, arginine, iso-leucine and cystine during ripening was positively correlated (P < 0.05, r > 0.60) with acrylamide formation in fried chips. The higher level of TP was significantly related (P < 0.05) to the lower level of acrylamide (r = −0.62). The reduced levels of carotenoid isomers, except lutein, during fruit ripening were positively correlated (P < 0.05) with acrylamide formation, especially trans-BC (r = 0.72) and 9-cis-BC(r = 0.64).     

Fragmentation and film growth in supersonic nanoaggregate aerosol deposition

Aerosol deposition with gas phase-synthesized chain-like nanoaggregates can yield dense coatings from the impaction of particles on a substrate; however, dense coating formation is not well understood. Here, we study coating consolidation at the single nanoaggregate level. Flame spray pyrolysis-made tin oxide nanoaggregates are mobility (size) filtered, accelerated through a de Laval nozzle, and impacted on alumina substrates. TEM images obtained from low velocity collection and supersonic deposition are compared via quantitative image analysis, which reveals that upon supersonic impact nanoaggregates fragment into smaller aggregates. This suggests that fragmentation is a key step in producing coatings denser than the depositing nanoaggregates themselves. We supplement experiments with detailed particle trajectory calculations, which show that the impact energies per atom during nanoaggregate deposition are below 0.2 eV/molecule. These results suggest that fragmentation can only occur at locations where nanoaggregates bonded by van der Waals and capillary interactions.     

Wind tunnel-based testing of a photoelectrochemical oxidative filter-based air purification unit in coronavirus and influenza aerosol removal and inactivation

Recirculating air purification technologies are employed as potential means of reducing exposure to aerosol particles and airborne viruses. Toward improved testing of recirculating air purification units, we developed and applied a medium-scale single-pass wind tunnel test to examine the size-dependent collection of particles and the collection and inactivation of viable bovine coronavirus (BCoV, a betacoronavirus), porcine respiratory coronavirus (PRCV, an alphacoronavirus), and influenza A virus (IAV), by a commercial air purification unit. The tested unit, the Molekule Air Mini, incorporates a MERV 16 filter as well as a photoelectrochemical oxidating layer. It was found to have a collection efficiency above 95.8% for all tested particle diameters and flow rates, with collection efficiencies above 99% for supermicrometer particles with the minimum collection efficiency for particles smaller than 100 nm. For all three tested viruses, the physical tracer-based log reduction was near 2.0 (99% removal). Conversely, the viable virus log reductions were found to be near 4.0 for IAV, 3.0 for BCoV, and 2.5 for PRCV, suggesting additional inactivation in a virus family- and genus-specific manner. In total, this work describes a suite of test methods which can be used to rigorously evaluate the efficacy of recirculating air purification technologies.     

Kinetic and mechanistic investigations of progesterone reaction with ozone

The removal of progesterone by ozone in aqueous solution was studied in this work. The absolute rate constant was evaluated and first by-products were identified. The reaction was studied in the 2.0-8.0 pH range and was found to be a second-order reaction, first-order relative to each compound concentration. The rate constant, determined by kinetic experiments in presence of an OH radical scavenger (tert-butanol), was independent of pH. The value was evaluated to be equal to 480+/-30 M(-1)s(-1) by two kinetic methods. Mass spectrometry analyses were performed to investigate primary degradation products generated by the reaction of ozone with progesterone. Two by-products were evidenced. According to these results, a degradation pathway of progesterone reacting with ozone was proposed.     

Simulation of air flow in the IEA Annex 20 test room—validation of a simplified model for the nozzle diffuser in isothermal test cases

The modeling of air supply devices has been identified from the International Energy Agency (IEA) Annex 20 project as one of the most important problems in applying computational fluid dynamics (CFD) to predict air flow pattern and air distribution in buildings, and the complicated HESCO nozzle diffuser used in the IEA Annex 20 test room has been proved to be particularly difficult to model. In a previous study, a simplified model for this diffuser was developed and validated against experimental data. It has been shown that this model can yield good prediction for the wall jet flow issued from the diffuser, but whether this model is capable of correctly predicting the global flow pattern in the whole test room was not known. In this paper, the benchmark data of the IEA Annex 20 Test Cases B2 and B3 were used to evaluate the performance of the model for the prediction of the global air flow pattern in the test room. It was demonstrated that this model can predict the air flow pattern in the whole test room for both the Test Cases B2 and B3 with reasonable accuracy. The significance of a velocity correction when comparing the numerical prediction with experimental data obtained using omni-directional anemometers was also discussed.     

Use of green roofs to solve storm water issues at the basin scale – Study in the Hauts-de-Seine County (France)

At the building scale, green roof has demonstrated a positive impact on urban runoff (decrease in the peak discharge and runoff volume). This work aims to study if similar impacts can be observed at a basin scale. It is particularly focused on the possibility to solve some operational issues caused by storm water.

For this purpose, a methodology has been proposed. It combines: a method to estimate the maximum roof area that can be covered by green roof, called green roofing potential, and an urban rainfall-runoff model able to simulate the hydrological behaviour of green roof.

This methodology was applied to two urban catchments, one affected by flooding and the other one by combined sewage overflow. The results show that green roof can reduce the frequency and the magnitude of such problems depending on the covered roof surface. Combined with other infrastructures, they represent an interesting solution for urban water management.     

Effects of chloride and sulfate on the rate of oxidation of ferrous ion by H2O2

The rates of oxidation of Fe(II) by H(2)O(2) in the presence of sodium perchlorate, sodium nitrate, sodium chloride and sodium sulfate salts (0-1M) have been compared in the study. Experiments were carried out in a batch reactor, in the dark, at pH <3, 25+/-0.5 degrees C and at controlled ionic strength (< or =1M). The experimental results showed that the rates of oxidation of Fe(II) in the presence of chloride, nitrate and perchlorate were identical. In the presence of sulfate, the rate of oxidation of Fe(II) was faster and depended on the pH and the concentration of sulfate. The pseudo second-order rate constants for the reaction of H(2)O(2) with Fe(2+), FeCl(+) and FeSO(4) were determined as 55+/-1, 55+/-1 and 78+/-3 M(-1) s(-1), respectively.