How to Valorize Peanut Shells by a Simple Thermal-Catalytic Method

Topics in Catalysis - In this work, a simple thermal-catalytic system was used to valorize peanut shells (Arachis hypogaea), the residual biomass from the peanut industry. To accomplish this...     

Photoelectrochemistry of poly(3-methylthiophene), I: Surface morphology and thickness effect

Photocyclovoltammetric experiments with films of poly(3-methylthiophene) under polychromatic light irradiation show a p-type semiconductor behavior in the reduced state, with a flat band potential of 0.18 V. The photocurrent depends on film thickness and surface morphology. Films with different thickness were characterized by scanning electron microscopy, indicating a globular morphology with globule sizes changing according to the charge density used during polymer deposition. The highest photocurrent is observed for the lowest globule diameter. These films were also irradiated with monochromatic light from the electrolyte side and from the substrate side. A higher photocurrent and a photocurrent spectrum matching the absorption spectrum of the reduced form of the polymer is observed on irradiation from the electrolyte side of a 0.7 μm thick film. In contrast, for irradiation from the electrode side, the photocurrent is lower and the spectrum shows a peak at lower energy. These results were interpreted in terms of a delocalized space charge zone, different kinetics for charge transfer and mass transport across the solvent swollen polymer film and different depth of penetration of the light as a function of wavelength.     

Processing of Yttria-Alumina Coated Silicon Nitride Slips by Slip Casting

Si₃N₄powders coated with 6 wt% Y₂O₃and 4 wt% Al₂O₃were prepared by coprecipitation. The resulting powders were dispersed in water at different pH values and with addition of various amounts of ammonium polyacrylate (NH₄PA) to produce 32 vol% slips. The influence of the amount of NH₄PA solution added and pH on the rheological properties of 32 vol% coated Si₃N₄slips were studied. In addition, the sintered density of cast samples was determined and related to the degree of slip dispersion. The adsorption of the NH₄PA on the coated particle surface was rather high and the surface became saturated near 0.86 mg/m²at pH 9.2. High NH₄PA concentrations (1.7–3 wt%) were necessary to obtain well dispersed 32 vol% coated Si₃N₄slips at pH 9.2. The best stabilization was obtained with the addition of 2.3 wt% NH₄PA; in this condition, the viscosity reached a minimum value of 35 mPa.s at 100 s^–1. The slip viscosity increased with increasing pH from 9.2 to 10.2. Slips with low viscosities gave a more dense packing of cast samples and consequently higher sintered density values.     

Aqueous tape casting of yttria stabilized zirconia

Tape casting process was used to produce yttria stabilized zirconia (YSZ) substrates in an aqueous system with poly(vinylalcohol) (PVA) and glycerine as binder and plasticizer, respectively. Various compositions of YSZ slips with different amounts of PVA and glycerine and consequently different solid/liquid ratios were prepared. The influence of the slip composition on the rheological properties of the slips was studied. In addition, the effect of the slip composition on the properties of the green and sintered tapes was investigated. PVA and glycerine did not affect the dispersion properties of the YSZ powder. Glycerine additions enhanced the flexibility of the green tapes but also produced a decrease in the tensile strength. The increase in the PVA content increased the tensile strength but resulted in a markedly decrease in the green density of the tapes. A correlation between the green and sintered density was found. The anisotropic sintering shrinkage parallel and perpendicular to the casting direction increased with increasing the PVA content. The slip compositions with 5 wt% PVA produced green tapes with satisfactory tensile strength. They had the highest sintered density, the lower sintering shrinkage and the lesser shrinkage anisotropy.     

Stereoselective Synthesis and Antiallodynic Activity of 3-Hydroxylated Paroxetines

The design, stereoselective synthesis and in vivo antiallodynic activity of four novel paroxetine analogs, named 3-hydroxy paroxetines (3HPXs), is reported herein. Among the novel synthesized compounds, three showed an antiallodynic effect, while (R,R)-3HPX was found to be 2.5 times more bioactive than (-)-paroxetine itself in neuropathic rats. Consequently, the current investigation not only discloses a novel promising analgesic drug, but also reveals that functionalization at the C3 position of paroxetine could be as effective as the common functionalization at either C4 or within the sesamol group.     

A new short-path distillation system applied to the reduction of cholesterol in butter and lard

A molecular distillation plant, built particularly to increase the separation efficiency and to obtain safer working conditions, was tested to remove cholesterol from anhydrous butter and lard. A preliminary experiment was carried out with butter to evaluate the fractionation obtained at temperatures between 190 and 250°C and residual pressures between 10⁻³ and 10⁻⁴ torr. A second experiment was carried out at 185°C and at the maximum operational vacuum, evaluating the fractionation achieved within a time scale between 30 and 180 min. Cholesterol was almost completely removed during the second hour with minimal loss of low-molecular weight triglycerides. An experiment was carried out with lard at 250°C and maximum achievable operational vacuum (10⁻⁴ Torr), lasting approximately 6 h, and cholesterol was removed almost completely during the second hour without significant modifications in the triglyceride composition. This situation remained constant throughout the duration of the test.     

Rancidity development during the chilled storage of farmed Coho salmon (Oncorhynchus kisutch)

Coho salmon (Oncorhynchus kisutch) is a fatty fish species whose farming production has greatly increased in recent years. Lipid damage produced during Coho salmon chilled storage was studied for up to 24 d. Lipid hydrolysis (free fatty acids, FFA) and oxidation (conjugated dienes; peroxide value, PV; thiobarbituric acid index, TBA‐i; fluorescent compounds formation, FR; browning development) were determined and compared to lipid composition (polyene index, PI; astaxanthin, AX) changes and sensory assessment (rancid odour development) results. Most lipid damage indices developed slowly during storage; thus, values obtained for FFA, PV, TBA‐i and FR were in all cases under 1.5 g/100 g, 4.0 meq oxygen/kg lipid, 0.40 mg malondialdehyde/kg muscle and 0.40, respectively. Odour assessment showed a significant (p <0.05) rancidity development at day 10, when compared to starting fish material; then, non‐acceptable values were obtained at days 19 and 24. The PI analysis showed not many differences during the storage time, with the lowest mean value at day 19. AX analysis indicated a relatively high content in the white muscle, which was maintained till the end of the experiment. A low oxidation development is concluded for Coho salmon lipids when compared to other fatty fish species under the same chilling conditions. AX was found to contribute to the oxidation stability of Coho salmon lipids, due to its free radical scavenger properties.     

Geochemical implications of trace elements and sulfur in the saturate, aromatic and resin fractions of crude oil from the Mara and Mara Oeste fields, Venezuela

Ten trace elements (Cr, Zn, Fe, Mn, Cu, Co, Ni, Mo, V and Sr) and sulfur were determined in the saturate, aromatic and resin fractions of 15 crude oils from Mara (DM) and Mara Oeste (DMO) fields of the Maracaibo Basin, Venezuela. The oils studied are classified as unaltered or altered by biodegradation. In the altered oil, the depletion of n-alkanes, the absence of isoprenoids and the presence of steranes and hopanes unaltered by biodegradation are indicative of moderate biodegradation. The elements Zn, Fe, Mn, Cu, Ni, and Sr were detected in the saturated hydrocarbon fraction; Cr and V were detected in the aromatic fraction in addition to the above elements; whereas the elements detected for the resin fraction were Cr, Zn, Fe, Cu, Ni, Mo, V, and Sr. Co was not detected in any fractions of the oils analyzed. Sulfur was found in all fractions of the oils studied. It was proposed that Fe, Zn, Sr, and Mn could have entered the oil during migration or Fe, Zn and Mn as pollutants during oil extraction. Cr and Cu may be of biological origin and Mo could be incorporated into the reservoir through bacteria. Only S, V, and Ni in the resin fractions can be used as indicators of the origin and correlation of Mara and Mara Oeste oils. Based on the results obtained in this work, it can be established that the V/(V+Ni) ratio in the resin fraction can be used as a correlation parameter, for these oils.     

Synthesis and Characterization of Al-MCM-41 and Al-MCM-48 Mesoporous Materials

A novel route in the synthesis of Al-MCM-41 and Al-MCM-48, using tetraethoxysilane (TEOS) and sodium aluminate (NaAlO₂) as Si and Al source has been obtained. The effect of surfactant nature and the synthesis conditions such as surfactant/Si ratio and hydrothermal treatment time on the formed mesostructure regularity has been studied. Different methods of template removal have also been evaluated. The samples were characterized by X-ray diffraction, nitrogen physisorption, FT-IR, and solid-state MAS NMR spectroscopy.     

Toward emotional interactive videogames for children with autism spectrum disorder

Universal Access in the Information Society - Technology and videogames have been proven as motivating tools for working attention and complex communication skills, especially in children with...