Nanolayer CrAlN/TiSiN coating designed for tribological applications

With the goal to produce a hard and tough coating intended for tribological applications, CrAlN/TiSiN nanolayer coating was prepared by alternative deposition of CrAlN and TiSiN layers. In the first part of the article, a detailed study of phase composition, microstructure, and layer structure of CrAlN/TiSiN coating is presented. In the second part, its mechanical properties, fracture and tribological behavior are compared to the nanocomposite TiSiN coating. An industrial magnetron sputtering unit was used for coating deposition. X-ray photoelectron spectroscopy, energy dispersive X-ray spectroscopy, X-ray diffraction, scanning electron microscopy, and transmission electron microscopy were used for compositional and microstructural analysis. Mechanical properties and fracture behavior were studied by instrumented indentation and focused ion beam techniques. Tribological properties were evaluated by ball-on-disk test in a linear reciprocal mode. A complex layer structure was found in the nanolayer coating. The TiSiN layers were epitaxially stabilized inside the coating which led to formation of dislocations at interfaces, to introduction of disturbances in the coating growth, and as a result, to development of fine-grained columnar microstructure. Indentation load required for the onset of fracture was twice lower for the nanolayer CrAlN/TiSiN, compared to the nanocomposite TiSiN coating. This agrees very well with their mechanical properties, with H³/E² being twice higher for the TiSiN coating. However, the nanolayer coating experienced less severe damage, which had a strong impact on tribological behavior. A magnitude of order lower wear rate and four times lower steady state friction coefficient were found for the nanolayer coating.     

基于改进 abcd 模型的黄河源区径流变化与归因

为改进模型对高寒地区融雪径流模拟不足的缺陷，将融雪模块耦合到传统 abcd 模型。利用 1980—2018 年 逐月实测的径流数据和通过 AnuSpline 方法插值的格网气象要素，驱动改进后的abcd 模型，分析三江源生态保护 措施实施前后（1980—1999 年和 2000—2018 年）黄河源区径流的动态变化，并量化关键气象因素与人类活动对 径流变化的影响程度，即相对贡献。结果表明：耦合融雪模块的 abcd-snow 模型完善了高寒地区水文过程的模拟， 提高对径流的模拟性能，在黄河源区表现出较好的适用性；整个研究时段黄河源区的实测径流呈不显著减少趋势 （?0.80?mm/a，p>0.05），但 2000 年前径流则呈现显著下降趋势（?4.12?mm/a，p<0.05），2000 年后径流则呈显著增加 趋势（3.16?mm/a，p<0.05）；?归因分析表明气候变化是源区径流变化的主导因素。2000 年前，气候变化对径流减少 的相对贡献率为 62.8%，人类活动对径流的贡献为 37.2%；2000 年后，气候变化对径流增加的贡献率达到 120.0?%， 人类活动对径流的贡献为?20.0%。其中：降水的变化是决定径流变化主导因素；其他气候因素的相对贡献较小； 以人类活动为主的生态恢复可显著降低河川径流。本研究有助于理解气候变化和下垫面变化对黄河源区水资源 变化的系统驱动机理，并为流域水资源合理配置提供科学参考依据。     

Assessment of technological attributes of autochthonous starter cultures in Turkish dry fermented sausage (sucuk)

The study aims to evaluate the technological properties of autochthonous strains (Lactobacillus sakei S15, Lactobacillus plantarum S24, L. plantarum S91, Pediococcus pentosaceus S128b and Staphylococcus carnosus G109) in Turkish dry fermented sausage (sucuk). After 24 h of fermentaPtion, all lactic acid bacteria strains reduced the pH to below 5.0, while the pH in the control group was above 5.3. The number of lactic acid bacteria strains reached 10⁸–10⁹ cfu g⁻¹ during fermentation. Staphylococcus carnosus G109 remained at the inoculation level of 10⁶ cfu g⁻¹ during ripening. Lactobacillus sakei S15 as mono-culture showed higher TBARS values compared to other strains. The control group had the lowest L* value and autochthonous strains caused no significant difference for a* value. According to principal component analysis results, most volatile compounds were positively correlated with the group containing only L. sakei S15.     

Robust method to provide exponential convergence of model parameters solving linear time-invariant plant identification problem

The scope of this research is a problem of parameters identification of a linear time-invariant plant, which (1) input signal is not frequency-rich, (2) is subjected to initial conditions and external disturbances. The memory regressor extension (MRE) scheme, in which a specially derived differential equation is used as a filter, is applied to solve the above-stated problem. Such a filter allows us to obtain a bounded regressor value, for which a condition of the initial excitation (IE) is met. Using the MRE scheme, the recursive least-squares method with the forgetting factor is used to derive an adaptation law. The following properties have been proved for the proposed approach. If the IE condition is met, then: (1) the parameter error of identification is bounded and converges to zero exponentially (if there are no external disturbances) or to a set (in the case of them) with an adjustable rate, (2) the parameters adaptation rate is a finite value. The above-mentioned properties are mathematically proved and demonstrated via simulation experiments.     

Ultra-Robust Flexible Electronics by Laser-Driven Polymer-Nanomaterials Integration

Polyethylene terephthalate (PET) is the most widely used polymer in the world. For the first time, the laser-driven integration of aluminum nanoparticles (Al NPs) into PET to realize a laser-induced graphene/Al NPs/polymer composite, which demonstrates excellent toughness and high electrical conductivity with the formation of aluminum carbide into the polymer is shown. The conductive structures show an impressive mechanical resistance against >10000 bending cycles, projectile impact, hammering, abrasion, and structural and chemical stability when in contact with different solvents (ethanol, water, and aqueous electrolytes). Devices including thermal heaters, carbon electrodes for energy storage, electrochemical and bending sensors show this technology's practical application for ultra-robust polymer electronics. This laser-based technology can be extended to integrating other nanomaterials and create hybrid graphene-based structures with excellent properties in a wide range of flexible electronics’ applications.     

Hydrogen storage performance of methyl-substituted mesoporous silica with tailored textural characteristics

Journal of Porous Materials - The present study reports a systematic analysis of morphology and hydrogen sorption capacity of mesoporous organic-inorganic silica prepared by varying the silica...     

Technology of Monitoring and Analysis of the Hydrometeorological Situation in the Arctic

Journal of Communications Technology and Electronics - A new geoinformation technology for monitoring the hydrometeorological situation in the Arctic is considered. This technology combines two...