Investigation of fluidized bed behaviour using electrical capacitance tomography

The temporal and cross-sectional distributions of particles in a 127 mm diameter fluidized bed have been obtained using a new generation, high-speed electrical capacitance tomography. Two planes of eight electrodes were used and mounted at 160 and 660 mm from the gas distributor which was a 3 mm thick porous plastic plate (maximum pore size of 50-70 μ m). 3 mm diameter, nearly-spherical polyethylene granules made up the bed. Experiments at sampling frequencies of 200-2000 cross-sections per second and gas superficial velocities from just below the minimum fluidization to 83% above minimum fluidization velocities were used. The time series of the cross-sectional average void fractions have been examined both directly and in amplitude and frequency space. The last two used probability density functions and power spectral densities. The information gathered shows that the fluidized bed was operating in the slugging mode, which is not surprising given the size of the particles. It has been found that an increase in the excess gas velocity above the minimum fluidization velocity resulted in an increase in the mean void fraction, an increase in the length and velocity of the slug bubbles as well as the bed height, and a slight decrease in the slug frequency. The results are presented in a level of detail suitable for comparison with later numerical simulation.     

Degradation rate quantification of solid oxide fuel cell performance with and without Al2TiO5 addition

Degradation rates of electrical current during constant voltage operation of SOFCs with anodes made using NiO precursor powders from two different manufacturers with and without the addition of aluminum titanate (ALT) added by either mechanical mixing or anode infiltration have been quantified using a novel MATLAB algorithm. Because the algorithm has been used to quantify degradation rates for many different SOFC tests, it is thought that the method can be applied to most measured SOFC data to quantify the instantaneous cell degradation rate as a function of time for the entire SOFC performance measurement. Degradation rates determined at different times have been plotted against varying concentrations of ALT addition, facilitating the estimation of optimum ALT concentration for SOFC anodes made with NiO from a specific manufacturer. The algorithm used to determine degradation rates is available upon request to the corresponding author.     

The Single-Fiber Collision Rate and Filtration Efficiency for Nanoparticles I: The First-Passage Time Calculation Approach

We describe an approach to filtration-efficiency calculations as an alternative to the traditional depth filtration theory. The new approach involves linking the single-fiber efficiency to the collision rate coefficient/kernel between nanoparticles and fibers, and correspondingly inferring the collision kernel via dimensionless mean first-passage time (MFPT) calculations. This method has the advantage of easily incorporating the influences of particle diffusion, inertia, and particle size; therefore, all filtration mechanisms can be considered simultaneously. Through non-dimensionalization of the equation of motion for a particle in MFPT calculations (the Langevin equation), it is shown that both the single-fiber efficiency E_f and dimensionless particle-fiber collision kernel, H, are functions of the ratio of particle radius to filter-fiber radius, R, the solid volume fraction in the filter, V_f, the ratio of particle persistence distance to the particle-filter collision distance, Kn_D (the diffusive Knudsen number), and the ratio of the particle translational kinetic energy to the thermal energy χ_f. Using a Kuwabara flow-cell model to define the geometry and flow field, MFPT calculations are used to determine H and E_f for nanoparticles in atmospheric pressure systems, i.e., when particle inertia is negligible but when diffusion and interception act in tandem to collect particles. From MFPT results, regression equations for both H and E_f are developed. A comparison is made between MFPT results and commonly invoked depth-filtration single-fiber efficiency relationships, experimentally measured values, and H equations derived from Sherwood number correlations based upon measurements of heat transfer from a fluid flowing perpendicular to an array of cylinders. Good agreement is found with both measurements and previously developed equations over a wide range of parameter space.

Copyright 2014 American Association for Aerosol Research     

Water and solute mass balance of five small, relatively undisturbed watersheds in the U.S

Geochemical mass balances were computed for water years 1992-1997 (October 1991 through September 1997) for the five watersheds of the U.S. Geological Survey Water, Energy, and Biogeochemical Budgets (WEBB) Program to determine the primary regional controls on yields of the major dissolved inorganic solutes. The sites, which vary markedly with respect to climate, geology, physiography, and ecology, are: Allequash Creek, Wisconsin (low-relief, humid continental forest); Andrews Creek, Colorado (cold alpine, taiga/tundra, and subalpine boreal forest); Río Icacos, Puerto Rico (lower montane, wet tropical forest); Panola Mountain, Georgia (humid subtropical piedmont forest); and Sleepers River, Vermont (humid northern hardwood forest). Streamwater output fluxes were determined by constructing empirical multivariate concentration models including discharge and seasonal components. Input fluxes were computed from weekly wet-only or bulk precipitation sampling. Despite uncertainties in input fluxes arising from poorly defined elevation gradients, lack of dry-deposition and occult-deposition measurements, and uncertain sea-salt contributions, the following was concluded: (1) for solutes derived primarily from rock weathering (Ca, Mg, Na, K, and H(4)SiO(4)), net fluxes (outputs in streamflow minus inputs in deposition) varied by two orders of magnitude, which is attributed to a large gradient in rock weathering rates controlled by climate and geologic parent material; (2) the net flux of atmospherically derived solutes (NH(4), NO(3), SO(4), and Cl) was similar among sites, with SO(4) being the most variable and NH(4) and NO(3) generally retained (except for NO(3) at Andrews); and (3) relations among monthly solute fluxes and differences among solute concentration model parameters yielded additional insights into comparative biogeochemical processes at the sites.     

The health effects of improvements to housing: A longitudinal study

Although housing conditions were an integral part of the emergence of the Public Health movement, there has been relatively little research on the relationship between housing and health compared to that on social inequalities in general. This is surprising in view of the fact that one of the major links between social inequalities and health is adverse housing conditions. Findings from previous investigations in several countries of the presence of damp and mould in housing and symptoms in the occupants have indicated that the associations may well be causal. However, there have been no studies which have assessed the health of the residents before and after the elimination of dampness/mould. This paper describes a longitudinal study designed to evaluate the effects of an improved heating system on the symptoms of children living on a peripheral housing estate. The results suggested that the elimination of dampness/mould prevented a further deterioration in health rather than bringing about an improvement. The presence of other factors known to influence health status, such as financial difficulties and other housing problems, may have offset any benefits arising from the new heating system. The methodological issues that arose in conducting the study in an area of severe social disadvantage are described. It is suggested that the complexity of the interactions between bad housing and low income, should not detract attention from the need for intersectoral co‐operation to address the issue.     

Radon and 'King Solomon's Miners': Faynan Orefield, Jordanian Desert

Concentrations of 222Rn were measured in ancient copper mines which exploited the Faynan Orefield in the South-Western Jordanian Desert. The concentrations of radon gas detected indicate that the ancient metal workers would have been exposed to a significant health risk and indicate that any future attempt to exploit the copper ores must deal with the hazard identified. Seasonal variations in radon concentrations are noted and these are linked to the ventilation of the mines. These modern data are used to explore the differential exposure to radon and the health of ancient mining communities.     

Localization of trehalose in partially hydrated DOPC bilayers: insights into cryoprotective mechanisms

Trehalose, a natural disaccharide with bioprotective properties, is widely recognized for its ability to preserve biological membranes during freezing and dehydration events. Despite debate over the molecular mechanisms by which this is achieved, and that different mechanisms imply quite different distributions of trehalose molecules with respect to the bilayer, there are no direct experimental data describing the location of trehalose within lipid bilayer membrane systems during dehydration. Here, we use neutron membrane diffraction to conclusively show that the trehalose distribution in a dioleoylphosphatidylcholine (DOPC) system follows a Gaussian profile centred in the water layer between bilayers. The absence of any preference for localizing near the lipid headgroups of the bilayers indicates that the bioprotective effects of trehalose at physiologically relevant concentrations are the result of non-specific mechanisms that do not rely on direct interactions with the lipid headgroups.     

An investigation of colour appearance for unrelated colours under photopic and mesopic vision

Data were obtained for the colour appearance of unrelated colours under photopic and mesopic conditions. The effects of changes in luminance level and stimulus size were investigated. The method used was magnitude scaling of brightness, colourfulness, and hue. Two stimulus sizes (10° and 0.5°) and four starting luminance levels (60, 5, 1, and 0.1, cd/m²) were used. The results at 0.1 cd/m² had large variations, so data were obtained for two additional stimulus sizes (1° and 2°) at this luminance level. Ten observers judged 50 unrelated colours. A total of 17,820 estimations were made. The observations were carried out in a completely darkened room, after 20 min adaptation; each test colour was presented on its own. Brightness and colourfulness were found to decrease with decreases of both luminance level and stimulus size. The CAM97u model predicted brightness more accurately than CIECAM02 but gave worse performance in predicting colorfulness. For hue, CAM97u and CIECAM02 both gave satisfactory predictions. Using the brightness correlate from CAM97u, a new colour‐appearance model based on CIECAM02 was developed specifically for unrelated colours under photopic and mesopic conditions, with parameters to allow for the effects of luminance level and stimulus size. © 2011 Wiley Periodicals, Inc. Col Res Appl, 2011;     

Feasibility of a Dune Infiltration System to Protect North Carolina Beaches from Fecal Bacteria Contaminated Storm Water

Storm water ocean outfalls discharging into recreational waters pose a human health threat because of increased potential exposure to bacteria and other pathogens. The dune infiltration system (DIS) was designed and implemented at two ocean outfall sites in response to concerns by the North Carolina Department of Transportation and the town of Kure Beach, North Carolina The systems were designed to divert storm water runoff from 1.9?ha (4.7 acre) and 3.2?ha (8.0 acre) watersheds into the beach dunes. Following construction, data were collected from 25 storms during March through October 2006. The systems captured a combined total of nearly 1,800??m3 (63,500??ft3), or 95% of the influent storm water runoff—a significant reduction of runoff volume and peak flow discharging directly onto the beach (p<0.0001). Fecal coliform and enterococci concentrations were measured in the inflowing storm water runoff and groundwater downslope of the systems. Both groundwater bacteria concentrations near the systems were significantly lower than the bacteria concentrations in the inflowing storm water (p<0.001). Furthermore, groundwater fecal coliform concentrations after implementing the DISs were statistically similar to preconstruction levels (p<0.05). The initial results are promising, and the system should be considered for more widespread use. However, further comprehensive research is recommended to more thoroughly understand the viability of the DIS as a storm water best management practice and the fate and transport of the bacteria within the dunes.