Unperturbed dimension of poly(4-acetoxystyrene) measured in good and theta solvents

In order to obtain the additional data concerning the unperturbed dimension of poly-4-substituted styrene, light scattering measurements are performed on the twenty-two fractions with molecular weight of (0.91–352)·10⁴ of poly(4-acetoxystyrene) in dioxan at 25°C, from which the molecular weight obtained was found easily to be evaluated with the gel permeation chromatography using THF. Phase separation experiments for this polymer indicate that the theta state is attained in isopropyl acetate at 19.7°C and butyl acetate at 26.8°C. By making viscosity measurements at that state, the value of K_Θ is directly evaluated as 5.4·10^?4 dl g^?1. The limiting viscosity number is also obtained in good solvents, THF and dioxan, at 25°C and constants of the Mark-Houwink-Sakurada equation in each solvent are determined. Further, approximately the same K_Θ as above is obtained from these data with the Stockmayer-Fixman plot. The calculated value of steric factor, 2.37, on this polymer may be plausible, compared with those of polyvinylaromatic derivatives.     

Simulation of Strength Distribution in Ground Ceramics by Incorporating Residual Stress Effect

Strength of ground ceramics may be affected by residual stress as well as surface flaws induced by grinding. Strength prediction for ground ceramics is convenient for mechanical design of ceramic components. In this article, a numerical procedure based on fracture mechanics was proposed to estimate strength distribution of ground ceramics by considering grinding-induced residual stress. Bending strength and residual stress of ground ceramics were measured for three grinding-conditions. By comparison of simulated results with experimental ones, it was revealed that strength characteristics in experiments were well simulated by using the proposed procedure.     

Radiation detector made of a high-quality polycrystalline diamond

Radiation detector was made of a high-quality CVD polycrystalline diamond composed of frost column like structure diamond grains, and induced charge distribution spectra and drift velocities were measured by using alpha particles. As a result, the CVD polycrystalline achieved maximum induced charge of 83% of HP/HT type IIa diamond. Moreover, the CVD crystal had lower charge loss on electrons compared with the HP/HT type IIa diamond. Drift velocities of electrons and holes were v_e = 7.7 × 10⁴ and v_h = 7.3 × 10⁴cm/s at an electric field of 20 kV/cm, respectively. In addition, response function measurement for 14 MeV neutrons was carried out.     

Effectiveness of spatial representation in the formation of network communities: experimental study on community organizer

In this paper, we present and discuss Community Organizer, a system designed to support network communities. The main characteristic of Community Organizer is the use of spatial representations for the relationships among community members including the communications exchanged among these members. These spatial representations reflect the degree of closeness of interests and concerns among the members, and are intended to provide users with clues on how to form network communities. In order to investigate the effectiveness of the proposed spatial representations, we conducted experiments with two different versions of the software. One version offered meaningful spatial representations while the other version did not. The subjects who used the former software version felt a greater sense of ‘community’, enjoyed using the software more, and actively used it longer than the subjects using the latter software version (control condition). These results indicated that the proposed spatial representations are effective in supporting network community formation.     

New balance ground relay for parallel four-circuit transmission lines

A 66-kV network generally is grounded through a neutral grounding resistor. In this network a single-phase ground-fault current is limited to as small as 100 to 400 A. There are parallel four-circuit transmission lines mounted on the same tower in the 66-kV network. In such transmission lines, the load and the fault currents could induce circulating current that flows through the lines. Since the circulating current has zero-phase-sequence and negative-phase-sequence components, it could cause unwanted operation of a balance ground relay using zero-phase-sequence current. However, it is difficult to compensate for the circulating current by the conventional vector compensation scheme. This paper presents a new balance ground relay to deal with the circulating current. In the relay from the ground-fault inception until first tripping, the difference current Δ3I_2d of negative-phase-sequence current 3I_2d of the differential current between two protected lines is used as an input current. The Δ3I_2d is the difference current of 3I_2d between, before and during faults. After the first tripping, the difference current of positive-phase-sequence load current and zero-phase-sequence current of the forementioned differential current are used as an input current. Consequently, a higher sensitivity of the ground-fault protection for these lines has been achieved. The correct operation of the new balance ground relay was confirmed when a single-phase-ground-fault occurred in the parallel four-circuit transmission lines, to which the relay is applied.     

A floating-gate analog memory device for neural networks

A floating-gate MOSFET device that can be used as a precision analog memory for neural network LSIs is described. This device has two floating gates. One is a charge-injection gate with a Fowler-Nordheim tunnel junction, and the other is a charge-storage gate that operates as a MOSFET floating gate. The gates are connected by high resistance, and the charge-injection gate is small so that its capacitance is much less than that of the charge-storage gate. By applying control pulses to the charge-injection gate, it is possible to charge and discharge the MOSFET floating gate in order to modify the MOSFET current with high resolution over 10 b. The charge injection can be carried out without disturbing the MOSFET output current with high voltage control pulses. This device is useful for on-chip learning in analog neural network LSIs     

Evaluation of hydrological processes in a mountainous small basin using a quinone biomarker.

An applicability of quinone biomarker to the analysis of hillslope runoff was investigated. At first, quinone profiles of three streams as well as a hillslope runoff in a forested headwater catchment were compared. The quinone composition of hillslope runoff differed from others. Moreover, there were remarkable differences in quinone profile of hillslope runoff under different rainfall conditions. Then, the behavior of quinone biomarker during the increase and decrease of hillslope runoff after a rainfall event was examined. The fractional changes in Q-9 (H2), Q-10 (H2), Q-11, MK-6 and MK-10 suggested the effect of interflow.     

Improvement of emission efficiency in polymer light-emitting devices based on phosphorescent polymers

We report improvement of emission efficiency in polymer light-emitting devices (PLEDs) employing phosphorescent polymers. A hole-blocking layer was inserted between the emissive layer and the cathode to enhance recombination efficiency for the injected holes and electrons. Aluminum(III)bis(2-methyl-8-quinolinato)4-phenylphenolato (BAlq) was used for the hole-blocking layer. The resultant PLEDs exhibited significant improvement of emission efficiency. The respective external quantum efficiencies for red, green and blue PLEDs were 6.6, 11 and 6.9%. These values are very high compared with those based on conventional fluorescent polymers.     

Transient analysis of an advanced static var compensator using quad-series voltage-source PAM inverters

This paper deals with an advanced static Var compensator (ASVC) using quad-series voltage-source PAM inverters. The ASVC consists of four three-phase voltage-source inverters with a common dc capacitor and four three-phase transformers, each primary winding of which is connected in series with each other. Each inverter outputs a square-wave voltage, while the synthesized output voltage of the ASVC has a 24-step wave shape. This results not only in a great reduction of harmonic currents and dc voltage ripples but also in fewer switching and snubbing losses. In this paper, transient analysis is performed with the focus on the response of reactive power and the resonance between the dc capacitor and ac reactors. Experimental results obtained from a small-rated laboratory model of 10 kVA are also shown to verify analytical results based on the p-q transformation. The analytical results help in the design of system parameters such as the capacity of the dc capacitor and feedback gains.