Possible Energy Network with polygeneration system and CCS for China

On basis of adopting polygeneration systems for power and alternative fuels,capturing CO2 with near zero energy penalties,and storing CO2 on sites,a new kind of Energy Network can integrate energy utilization,CO2 capture,transportation and storage synthetically.Techno-economic analysis of this solution focusing on Inner Mongolia and the Yangtze River Delta districts had been carried with comparison to the chain method for energy utilization and CO2 sequestration.This solution can save 21.5% of energy,and re...     

Analysis of junction temperatures in high-power GaN-based LEDs

We presented the analysis of the incomplete conduction in bonding medium in high power GaN-based light-emitting diode (LED) packages. A numerical study was carried out with parametric model to understand the junction temperature variation due to bonding medium defects. Transient thermal measurement was performed to evaluate LED’s junction temperature. Thermal resistance from chip to lead frame was 20 K/W in our sample LED. It was suggested that only 60% of the surface area of the bonding medium was involved...     

Preparation of micro-patterned surfaces of Si-N-O films and their influence on adhesion behavior of endothelial cells

Microgrooves were prepared on Si(100) surface by photolithography and wet etching.Subsequently,Si-N-O films were deposited on the microgrooves by unbalanced magnetron sputtering(UBMS) and micro-patterned surfaces of Si-N-O films were obtained.The size of the micropatterns was measured by surface profilometer.The chemical composition of Si-N-O films were characterized by X-ray photoelectron spectrometry(XPS) and the wettability of the micropatterned surfaces was evaluated by contact angle measurement.The beh...     

A novel shaft-less double suction mini pump

A novel double suction shaft-less mini pump was developed for heat control of small energy systems in this study.The mini pump impeller with an exit diameter of 40 mm was combined with the motor rotor supported by the hybrid dynamic bearing.The specific speed of the pump was 125 min-1 m3 min-1 m.The hydraulic performance of the pump was investigated experimen-tally under four rotational speeds.From the test results,it was recognized that the pump could provide a flow discharge of 5 L/min and head of 1.5 m,w...     

Fuel combustion test in constant volume combustion chamber with built-in adaptor

Combustion tests of pre-mixture of methane and air in constant volume combustion chamber(CVCC) have been carried out by means of flame propagation photo and gas pressure measurement,the effects of CVCC body temperature,intake pressure of pre-mixture of methane and air,equivalence ratio and location of the built-in adaptor have been investigated.The whole combustion chamber can be divided into two parts,i.e.the upper combustion chamber and the lower combustion chamber,by the built-in adaptor with through hol...     

Dynamic equivalent method of interconnected power systems with consideration of motor loads

The existing equivalent methods usually only deal with static load models and neglect the dynamic characteristics of loads such as induction motors.This paper presents a dynamic equivalent method which considers motor dynamics.At first,the clustering criterion of motor loads is given.The motors with similar dynamic characteristics are classified into one group.Then,reduction of motors in the same group is carried out.Finally,parameters of the equivalent motor are calculated and the equivalent system is thus...     

Computation of concentrations of characteristic atoms of alloys in BCC structure

In this paper,taking Nb-Mo alloy system as an example,the equations of concentration of characteristic atoms of alloys in BCC structure were obtained on the basis of the idea of systematic science of alloys and the number of coordination atoms.The concentrations of characteristic atoms in B2-NbMo type ordered alloys were calculated as functions of ordering degree(s) and composition xMo.When s=smax,the concentrations of characteristic atoms of stoichiometric B2-NbMo intermetallic compound are equal to that o...     

FEM analyses for influences of stress corrosion and pressure solution on THM coupling in dual-porosity rock mass

With the models of stress corrosion and pressure solution, by Yasuhara et al., two computation conditions were designed for a hypothetical nuclear waste repository in an unsaturated dual-porosity rock mass: (i) the fracture apertures are changed with the stress corrosion and pressure solution (the porosity of rock matrix is also a function of stress); (ii) the fracture apertures and the porosity of rock matrix are constants. Then the corresponding two-dimensional FEM analyses for the coupled thermohydro-mec...     

Investigation on film cooling characteristics from a row of converging slot-holes on flat plate

Experimental and numerical researches were conducted to investigate the cooling performance of a single row of consoles (converging slot-hole) on a large-scale flat-plate model. The results show that the coolant flow from a row of consoles shows good lateral uniformity of adiabatic effectiveness, with regions of slightly enhanced cooling occurring between the consoles. For the console cooling geometry, the interaction between coolant jet from inclined console and the mainstream flow results in reasonable vo...     

Progress and recent trend in MILD combustion

Moderate or intense low oxygen dilution(MILD)combustion plays a significant role in the mitigation of combustion-generated pollutants and greenhouse gases whilst meeting thermal efficiency needs.However,due to the lack of the fundamental knowledge on this combustion,there is a misconception that MILD combustion should be established by high preheating of the air,which has limited its application.Our research and development on this combustion has been performed for several years. We have found that the requ...