Scientific co-operation in Europe and the citation of multinationally authored papers

Under the sponsorship of the U.S. National Science Foundation, CHI Research, Inc. developed the bibliometric indicators for the U.S. National Science Board'sScience Indicators Reports starting withScience Indicators 1972. In the work reported here, for the Commission of the European Communities, CHI has extended the Science Indicators techniques and database to a study of publication, coauthorship and citation within 28 scientific fields related to various European Community programs.Perhaps the most important finding of the research was that internationally coauthored papers — papers authored by scientists affiliated with institutions in more than one EC country — were cited two times as highly as papers authored by scientists working at a single institution within a single country. These EC-EC internationally coauthored papers were cited as highly as EC-Non EC and Non-EC papers. This indicates that the internationally linked European science is of as high impact as any other science in the world.A second key finding was that, after compensating for national scientific size, the degree of international coauthorship did not appear to be particularly dependent upon size. However, linguistic and cultural factors were found to be very strong. The patterns of coauthorship amongst the European countries are far from homogeneous, and are quite heavily affected by linguistic, historical, and cultural factors.Finally, it was found that international coauthorship is increasing steadily, both within and outside of the Community, with some evidence that international cooperation is increasing more rapidly in scientific fields that have been targeted by the Commission.This work has been sponsored by the MONITOR programme of the Commission of the European Communities.     

Fetal Neurobehavioral Development: A Tale of Two Cities.

Longitudinal neurobehavioral development was examined in 237 fetuses of low-risk pregnancies from 2 distinct populations-Baltimore, Maryland, and Lima. Peru-at 20. 24. 28. 32, 36. and 38 weeks gestation. Data were based on digitized Doppler-based fetal heart rate (FHR) and fetal movement (FM). In both groups. FHR declined while variability, episodic accelerations, and FM-FHR coupling increased, with discontinuities evident between 28 and 32 weeks gestation. Fetuses in Lima had higher FHR and lower variability, accelerations, and FM-FHR coupling. Declines in trajectories were typically observed 1 month sooner in Lima, which magnified these disparities. Motor activity differences were less consistent. No sex differences in fetal neurobehaviors were detected. It is concluded that population factors can influence the developmental niche of the fetus. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Partial or total silylation of dextran with hexamethyldisilazane

The silylation reaction of dextran with 1,1,1,3,3,3-hexamethyldisilazane (HMDS) in DMSO was studied as the first step of the synthesis of new amphiphilic polyester-grafted dextrans. According to the experimental conditions, i.e. dextran molar weight, medium temperature and reaction time, HMDS/OH ratio, addition of a catalyst and co-solvent, partially or totally silylated dextrans were recovered. The highest silylation yields were obtained with the lowest molecular weight dextrans. The increase in temperature medium and/or reaction time, the presence of catalyst or co-solvent favored the protection yield. Whatever the dextran used, complete silylation of the polysaccharide chain could be achieved by adequate selection of the experimental conditions. The thermal properties of resulting silylated polysaccharides were investigated by temperature modulated DSC. It was observed that T_g values of partially silylated dextran were maintained between 120 and 140 °C, independently of the dextran molecular weight. Interestingly, DMSO proved to behave as an efficient plasticizer of (partially) silylated dextrans. The partially silylated dextrans were efficiently used as multifunctional macroinitiators for the controlled ring-opening polymerization (ROP) of lactone. The ROP was then promoted from the remaining hydroxyl groups in the presence of tin or aluminium activator. After polymerization and ultimate deprotection of the silylated dextran backbone, amphiphilic polyester-grafted dextrans were readily recovered.     

Electrostatic force microscopy of self-assembled peptide structures

In this report electrostatic force microscopy (EFM) is used to study different peptide self-assembled structures such as tubes and particles. It is shown that not only geometrical information can be obtained using EFM, but also information about the composition of different structures. In particular we use EFM to investigate the structures of diphenylalanine peptide tubes, particles, and CSGAITIG peptide particles placed on pre-fabricated SiO(2) surfaces with a backgate. We show that the cavity in the peptide tubes could be due to the presence of water residues. Additionally we show that self-assembled amyloid peptides form spherical solid structures containing the same self-assembled peptide in its interior. In both cases transmission electron microscopy is used to verify these structures. Further, the limitations of the EFM technique are discussed, especially when the observed structures become small compared with the radius of the AFM tip used. Finally, an agreement between the detected signal and the structure of the hollow peptide tubes is demonstrated.     

Algorithms and complexity analysis for some flow problems

Several network-flow problems with additional constraints are considered. They are all special cases of the linear-programming problem and are shown to be -complete. It is shown that the existence of a strongly polynomial-time algorithm for any of these problems implies the existence of such an algorithm for the general linear-programming problem. On the positive side, strongly polynomial algorithms for some parametric flow problems are given, when the number of parameters is fixed. These algorithms are applicable to constrained flow problems when the number of additional constraints is fixed.Work on the paper was done while at Stanford University and IBM Almaden Research Center. This research was partially supported by NSF PYI Grant CCR-8858097.     

Generalized modal satisfiability

It is well known that modal satisfiability is PSPACE-complete (Ladner (1977) [21]). However, the complexity may decrease if we restrict the set of propositional operators used. Note that there exist an infinite number of propositional operators, since a propositional operator is simply a Boolean function. We completely classify the complexity of modal satisfiability for every finite set of propositional operators, i.e., in contrast to previous work, we classify an infinite number of problems. We show that, depending on the set of propositional operators, modal satisfiability is PSPACE-complete, coNP-complete, or in P. We obtain this trichotomy not only for modal formulas, but also for their more succinct representation using modal circuits. We consider both the uni-modal and the multi-modal cases, and study the dual problem of validity as well.     

Food vacuole proteome of the malarial parasite Plasmodium falciparum

The Plasmodium falciparum food vacuole (FV) is a lysosome-like organelle where erythrocyte hemoglobin digestion occurs. It is a favorite target in the development of antimalarials. We have used a tandem mass spectrometry approach to investigate the proteome of an FV-enriched fraction and identified 116 proteins. The electron microscopy analysis and the Western blot data showed that the major component of the fraction was the FV and, as expected, the majority of previously known FV markers were recovered. Of particular interest, several proteins involved in vesicle-mediated trafficking were identified, which are likely to play a key role in FV biogenesis and/or FV protein trafficking. Recovery of parasite surface proteins lends support to the cytostomal pathway of hemoglobin ingestion as a FV trafficking route. We have identified 32 proteins described as hypothetical in the databases. This insight into FV protein content provides new clues towards understanding the biological function of this organelle in P. falciparum.     

3D numerical simulation of the behaviour of a spherical particle suspended in a Newtonian fluid and submitted to a simple shear

The 3D flow around a rigid spherical particle suspended in a Newtonian fluid and submitted to simple shear is numerically studied using Rem3D^® finite element code. The sphere motion is imposed by a sticking contact between the sphere and the fluid. The effect of the particle size as compared with the finite dimension of the shear cell was investigated. The direct calculations show that 3D modelling is necessary to correctly predict the sphere behaviour. The proximity of the particle and the cell walls strongly affects the flow velocities, the sphere motion (increase of the rotation period of the sphere) and the stress field (change of orientation angle and increase of maximal local stresses).     

Oil Spill Dispersant Effectiveness Protocol. I: Impact of Operational Variables

The current U.S. Environmental Protection Agency protocol for testing the effectiveness of dispersants, the swirling flask test, has been found to give widely varying results in the hands of different testing laboratories. The sources of the ambiguities in the test were determined by considering several options in a rigorous systematic fashion. Options considered were variability among three operators and the variability and limitations of three analytical instruments in establishing a calibration curve for oil/dispersant mixtures. Other options included flask type, impact of operational variables (rotational speed, mixing time, settling time, and oil:dispersant ratio), development of a revised procedure for dispersant effectiveness, reproducibility and repeatability of the revised procedure, and development of selection criteria for screening of dispersants. A redesign of the test flask, which is characterized by having baffles with a stopcock at the bottom for sample collection, was deemed necessary to accomplish reproducibility within operator and between operators. The results indicated that the baffled flask provided a total coefficient of variation (variations within operator and between operators) less than 11% compared to above 100% in some cases for the swirling flask.