Effect of suspension characteristics on the performance of thermal barrier coatings deposited by suspension plasma spray

This paper investigates the influence of suspension characteristics on microstructure and performance of suspensions plasma sprayed (SPS) thermal barrier coatings (TBCs). Five suspensions were produced using various suspension characteristics, namely, type of solvent and solid load content, and the resultant suspensions were utilized to deposit five different TBCs under identical processing conditions. The produced TBCs were evaluated for their performance i.e. thermal conductivity, thermal cyclic fatigue (TCF) and thermal shock (TS) lifetime. This experimental study revealed that the differences in the microstructure of SPS TBCs produced using varied suspensions resulted in a wide-ranging overall TBC performance. All TBCs exhibited thermal conductivity lower than 1 W/(m. K) except water-ethanol mixed suspension produced TBC. The TS lifetime was also affected to a large extent where 10 wt % solid loaded ethanol and 25 wt % solid loaded water suspensions produced TBCs exhibited the highest and the lowest lifetime, respectively. On the contrary, TCF lifetime was not as significantly affected as thermal conductivity and TS lifetime, and all ethanol suspensions showed marginally better TCF lifetime than water and ethanol-water mixed suspensions deposited TBCs.     

Neo Arithmetic and Ranking Techniques for Trapezoidal Generalized Interval Valued Fuzzy Numbers: Their Applications in Decision Making for Medical Investigation

Neural Processing Letters - The uncertainty caused mainly by the deficiency of precision and data, artificial/human-made errors, information accessed from expert opinions or very miniature size of...     

Efficiency and effectiveness enhancement of an intercooler of two‐stage air compressor by low‐cost Al2O3/water nanofluids

The present study was aimed to utilize low‐cost alumina (Al₂O₃) nanoparticles for improving the heat transfer behavior in an intercooler of two‐stage air compressor. Experimental investigation was carried out with three different volume concentrations of 0.5%, 0.75%, and 1.0% Al₂O₃/water nanofluids to assess the performance of the intercooler, that is, counterflow heat exchanger at different loads. Thermal properties such as thermal conductivity and overall heat transfer coefficient of nanofluid increased substantially with increasing concentration of Al₂O₃ nanoparticles. Specific heat capacity of nanofluids were lower than base water. The intercooler performance parameters such as effectiveness and efficiency improved appreciably with the employment of nanofluid. The efficiency increased by about 6.1% with maximum concentration of nanofluid, that is, 1% at 3‐bar compressor load. It is concluded from the study that high concentration of Al₂O₃ nanoparticles dispersion in water would offer better heat transfer performance of the intercooler.     

Solubility parameter estimation and phase inversion modeling of bentonite-doped polymeric membrane systems

Effects of bentonite concentration on morphology and permeation characteristics of bentonite-doped polysulfone membranes were investigated. Solubility sphere for bentonite was constructed to estimate its solubility parameter. Thermodynamic modeling of phase inversion of this system was carried out using Flory–Huggins theory. The trade-off between thermodynamic and kinetic parameters was used to predict the membrane morphology for bentonite concentration varying from 0 to 5 wt %. The porosity of bentonite-doped membranes decreased up to 3 wt % that increased thereafter. Morphological analysis showed dense cross section with finger-like macrovoids at 3 wt % beyond which it changed to honeycomb structure with large circular voids. Permeability of 3 wt % membrane was the lowest (5.6 × 10⁻¹² m/Pa s) with 95% bovine serum albumin rejection. Contact angle of the membranes decreased from 83 to 66° with bentonite addition making the membrane more hydrophilic. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2020 , 137, 48450.     

Robust object tracking with crow search optimized multi-cue particle filter

Pattern Analysis and Applications - Particle filter is used extensively for estimation of target nonlinear and non-Gaussian state. However, its performance suffers due to its inherent problem of...     

Spectroscopic and Simulation Analysis of Facile PEDOT:PSS Layer Deposition-Silicon for Perovskite Solar Cell

In this research work, we have characterized and simulated a well-known hole transport material (HTM) for perovskite solar cell (PSC) and conductive polyme