Subnanometer-scale chemistry and structure of α-iron/molybdenum nitride heterophase interfaces

The local chemistry and structure of α-iron/molybdenum nitride heterophase interfaces is studied on a subnanometer scale by atom-probe field-ion microscopy (APFIM), three-dimensional atom-probe microscopy (3DAPM) and both conventional transmission electron microscopy (CTEM) and highresolution electron microscopy (HREM). Molybdenum nitride precipitates are generated by annealing Fe-2 at. pct Mo-X, where X=0.4 at. pct Sb or 0.5 at. pct Sn, at 550 °C or 600 °C, in an ammonia/hydrogen mixture. Internal nitridation at 550 °C produces thin, coherent platelet-shaped molybdenum nitride precipitates. Nitridation at 600 °C generates a much coarser structure with semicoherent thick plate-shaped and spheroidal precipitates in addition to the thin-platelet structure. The APFIM and 3DAPM analyses of the heterophase interfaces show substantial segregation of the solute species Sn and Sb only at the coarse precipitates, with Gibbsian interfacial excesses of up to 7±3 nm⁻², whereas the broad faces of the thin platelets have no detectable segregation. The TEM and HREM analyses show that the coarse precipitates are semicoherent, whereas the thin platelets are either coherent or have much fewer misfit dislocations than geometrically necessary. This demonstrates that Sn and Sb segregation is related to the presence of misfit dislocations at the interfaces of the coarse precipitates. This article is based on a presentation made at the symposium entitled “The Mechanisms of the Massive Transformation,” a part of the Fall 2000 TMS Meeting held October 16–19, 2000, in St. Louis, Missouri, under the auspices of the ASM Phase Transformations Committee.     

Sorption of Acid Green 25 on chitosan: Influence of experimental parameters on uptake kinetics and sorption isotherms

Acid Green 25, which is a diazoic dye bearing two sulfonic groups, is efficiently sorbed on chitosan. The protonation of chitosan may explain the electrostatic attraction of this anionic dye and that its optimum pH is close to 3. Preliminary protonation of amine groups (obtained by contact with a sulfuric acid solution) reduced the variation of solution pH following sorbent addition but significantly reduced sorption performance: the maximum sorption capacity of raw chitosan, 525 mg dye/g (0.84 mmol dye/g), was halved by acidic preconditioning. The acidic conditioning also reduced the kinetic rate—the time necessary to reach equilibrium increased up to threefold depending on the experimental conditions. The size of sorbent particles influenced sorption kinetics and equilibrium because of resistance to intraparticle diffusion, but the sorption appeared to occur not only at the surface of the sorbent but also in the intraparticle network of the polymer. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 1073–1080, 2003     

Cardiovascular responses to occupational stress in male medical students: A paradigm for ambulatory monitoring studies.

Examined hemodynamic responses to systematic variations in occupational stress using ambulatory blood pressure monitors. Heart rate, systolic blood pressure, diastolic blood pressure, rate–pressure product, and mood states were measured before, during, and after low-stress (lecture) and high-stress (examination) work in 44 healthy White male medical students. The lecture day was characterized by stable patterns of cardiovascular activity across all 3 periods. Hemodynamic activity and reports of activation and distress were greater on the examination day than on the lecture day. Cardiovascular activity during the pre-examination period was as high as that seen during the examination period itself, indicating an anticipatory stress effect. Pressor activity decreased after the examination, although some residual chronotropic activity was seen. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Neuropsychological function in adults with attention-deficit hyperactivity disorder

Pacemaker therapy in patients with atrial fibrillation means the best current pacemaker therapy for patients with bradycardias with the aim to avoid the onset of atrial fibrillation and to establish DDD pacing despite of a history of atrial tachyarrhythmias. The newer application of pacing is the suppression of atrial arrhythmias in patients with medical refractory atrial tachyarrhythmias. Patients with slow ventricular rates and permanent atrial fibrillation should receive a VVI-pacemaker, if the bradycardias causes syncope, dizziness or a decrease of their exercise tolerance. In case of chronotropic incompetence the pacemaker should provide rate responsive pacing. Patients with sick sinus syndrome should receive an atrial (AAI) or dual-chamber (DDD) pacemaker, because patients with these in contrast to VVI-pacemakers develop less often atrial fibrillation and subsequent complications such as atrial thromboembolism. A dual-chamber or VDD-pacemaker--the latter connected to a VDD-single-lead--is indicated in patients with advanced AV-block. Atrial fibrillation occurs in 3 to 6% of the patients with no history of arrythmia and is, if pacemakers have no automatic mode switch, an often reason to program the devices to the VVI-pacing mode. Nowadays, most DDD(R)-pacemakers provide an automatic mode switch: During an atrial tachycardia the pacemaker switches to a VVI/VVIR mode and restores the initial DDD(R)-pacing mode with termination of the arrhythmia. In respect to the newer applications, one approach to prevent atrial tachyarrhythmias is permanent atrial pacing. As lower pacing rates of 80 to 90 ppm are usually needed and many patients hardly tolerate these pacing rates, new algorithms are under clinical investigation. Another approach is the simultaneous depolarization of the right and left atrium. Biatrial pacing is performed with one lead in the high right atrium and another lead in the coronary sinus. Another solution is bifocal atrial pacing with leads placed in the high right atrium and in the coronary sinus ostium. One effect of the new pacing techniques is to shorten interatrial conduction times. Therefore, biatrial pacing has become a therapy to prevent atrial arrhythmias deriving from delayed interatrial conduction times. As atrial reentry circuits seem to be important in atrial fibrillation, multisite atrial pacing is also performed in patients with medical refractory paroxysmal atrial fibrillation. Preliminary results suggest a more effective prevention of atrial fibrillation; nevertheless, these techniques should be still restricted to patients enrolled in clinical studies.     

A scanning tunneling microscopy tip with a stable atomic structure

A single stable adatom on a {110}-type plane of a tungsten tip is created via field-evaporation in a field-ion microscope (FIM) operating at room temperature. This single adatom has sufficient surface mobility at room temperature and migrates, in one-dimension, along a <111>-type direction toward an edge of a {110}-type plane, due to the existence of an electric field gradient. The plane edge has a higher local electric field than its center, since it has a higher local geometric curvature. This result implies that the stable position of a single adatom during a scan of a scanning tunneling microscope (STM) tip on a surface is at the edge and not at the center of a {110}-type plane at room temperature. Therefore, the electron wave function of a tip is not symmetric and this fact should be taken into account in a careful analysis of STM images. Also a tip with a dislocation emerging at a {110}-type plane is suggested as an improved STM tip configuration, as the step at the surface, created by the intersection of the dislocation with it, is a perpetual source of single adatoms.     

Strength Recovery in a High-Strength Steel During Multiple Weld Thermal Simulations

BlastAlloy 160 (BA160) is a low-carbon martensitic steel strengthened by copper and M₂C precipitates. Heat-affected zone (HAZ) microstructure evaluation of BA160 exhibited softening in samples subjected to the coarse-grained HAZ thermal simulations of this steel. This softening is partially attributed to dissolution of copper precipitates and metal carbides. After subjecting these coarse-grained HAZs to a second weld thermal cycle below the A _c1 temperature (at which austenite begins to form on heating), recovery of strength was observed. Atom-probe tomography and microhardness analyses correlated this strength recovery to re-precipitation of copper precipitates and metal carbides. A continuum model is proposed to rationalize strengthening and softening in the HAZ regions of BlastAlloy 160.     

Identity and spirituality: A psychosocial exploration of the sense of spiritual self.

The authors examined the structure and content of adults' sense of spiritual identity by analyzing semistructured interviews with 13 spiritually devout men and 15 devout women, ages 22 to 72. Individuals' responses to the Role-Related Identity Interview (G. T. Sorell, M. J. Montgomery, & N. A. Busch-Rossnagel, 1997b) were content analyzed and rated on the role-related spiritual identity dimensions of role salience and flexibility. Individuals were categorized as spiritually foreclosed, achieved, or in moratorium, on the basis of their motivational, affective, self-evaluative, and behavioral investments in spiritually defined roles and their reflectiveness about and behavioral changes in role-related spiritual identity. Similarities and differences within and between spiritual identity status groups were observed, suggesting a variety of ways that spiritual identity provides a sense of continuity as well as a domain for adult developmental change. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Professionals in mutual help groups: Impact on social climate and members' behavior.

This study assessed the impact of professional involvement in mutual help groups for the mentally ill. Social climate data and behavioral data on members in groups led either by a mental health professional (n?=?36) or an indigenous group member (n?=?70) were compared. The results of the study indicated a more formal, psychologically directed approach in the professionally led groups. Although professional involvement in mutual help groups does not necessarily produce different member outcomes, it does seem to affect both the perceptions and the behavior of members. Professionals should be cautious when they get involved in mutual help groups to avoid professionalizing them. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Preparation of3H-phosphatidylmyoinositol withKloeckera brevis

The growth ofKloeckera brevis in the presence of uniformly tritiated myoinositol is described. The major radioactive lipid isolated from the cells is³H-phosphatidylmyoinositol, labeled exclusively in the myoinositol moiety. Chromatographic methods for purifying³H-phosphatidylmyoinositol, free from other labeled lipids, are described, and the use of this labeled lipid as a precursor in studying enzymatic synthesis of complex inositol lipids is demonstrated.     

Subnanometer three-dimensional atom-probe investigation of segregation at MgO/Cu ceramic/metal heterophase interfaces.

Three-dimensional atom-probe (3DAP) microscopy has been applied to the study of segregation at ceramic/metal (C/M) interfaces. In this article, results on the MgO/Cu(X) (where X = Ag or Sb) systems are summarized. Nanometer-size MgO precipitates with atomically clean and atomically sharp interfaces were prepared in these systems by internal oxidation. Segregation of the ternary component (Ag or Sb) at the MgO/Cu heterophase interface was enhanced by extended low-temperature anneals. Magnesia precipitates in the 3DAP reconstructions were delineated as isoconcentration surfaces, and segregation of each ternary component at the C/M interfaces was analyzed with the proximity histogram method developed at Northwestern University. This method allows the direct extraction of the Gibbsian interfacial excess of solute at the C/M interfaces from the experimental data. A value of (3.2+/-2.0) x 10(17)m(-2) at 500 degrees C is obtained for the segregation of Ag at a MgO/Cu(Ag) interface, while a value of (2.9+/-0.9) x 10(18) m(-2) at 500 degrees C is obtained for the segregation of Sb at a MgO/Cu(Sb) interface. The larger Gibbsian excess for Sb segregation at this ceramic/metal heterophase interface is most likely due to the so-called pdeltaV effect.