An active low-pass filter using two capacitive double-layer uniformly distributed RC lines

In this paper we propose an active circuit consisting of two capacitive double-layer uniformly distributed RC lines and an operational amplifier, and present conditions under which the circuit works as the low-pass filter. Furthermore, we present a method for designing the low-pass filter and give a design example where simulation results are included.     

Fabrication of Nonadditive Mica Ceramics by Hot Isostatic Processing

Powder compacts of synthetic mica (fluorphlogopite) encapsulated in a boro–silicate glass tube were isostatically hot–pressed in a Roy–Tuttle–type pressure vessel. Synthetic mica was sintered to a density of 2.60 g/cm³ (91.2% of theoretical density) without additives under 98 MPa of water at 800°C for 45 min.     

Selective production of lactic acid in continuous anaerobic acidogenesis by extremely low pH operation

The selective production of lactic acid by anaerobic acidogenesis with low pH control was examined using a chemostat culture. By decreasing culture pH to 3.5 in a chemostat culture containing mixed microbial populations for anaerobic acidogenesis, heterolactic fermentation became dominant, resulting in the selective production of lactic acid and ethanol. This phenomenon was reversible between the acidic and neutral conditions, and was not affected by the dilution rate. The extremely low pH operation was effective for selective lactic acid production in anaerobic acidogenesis.     

Weighted Homo-Lumo Energy Separations for the Polyene References of Fullerenes with Up to 100 Carbon Atoms

The T value represents the HOMO-LUMO energy separation of a ε-electronic system weighted with the number of conjugated atoms. We found that this value is kept almost constant for the polyene references defined graph-theoretically for isolated-pentagon isomers of fullerenes with up to 100 carbon atoms. on this numerical basis, the T value can safely be considered as a realistic index of kinetic stability or chemical inertness for all fullerenes without abutting pentagons.     

Properties of Bi-doped PbTe layers grown by liquid phase epitaxy under controlled Te vapor pressure

Effects of Bi doping in PbTe liquid-phase epitaxial layers grown by the temperature difference method under controlled vapor pressure (TDM-CVP) are investigated. For Bi concentrations in the solution, x_Bi, lower than 0.2 at.%, an excess deep-donor level (activation energy E_d≈0.03–0.04 eV) appears, and Hall mobility is low. In contrast, for x_Bi>0.2 at.%, Hall mobility becomes very high, while carrier concentration is in the range of 10¹⁷ cm⁻³. Inductive coupled plasma (ICP) emission analysis shows that, for x_Bi=1 at.%, Bi concentration in the epitaxial layer is as high as N_Bi=2.3–2.7 × 10¹⁹ cm⁻³. These results indicate that Bi behaves not only as a donor but also as an acceptor, and the nearest neighbor or very near donor-acceptor (D-A) pairs are formed, so that strong self-compensation of Bi takes place. Carrier concentration for highly Bi-doped layers shows a minimum at a Te vapor pressure of 2.2 × 10⁻⁵ torr for growth temperature 470°C, which is coincident with that of the undoped PbTe.     

a-SiC:H/SiO2 Laminated Polarization Splitter for the Wavelength Region Longer Than 1.3 μm Prepared by Plasma-Enhanced Chemical Vapor Deposition

A laminated polarization splitter for the wavelength region longer than 1.3 μm is fabricated for the first time. It is composed of a-SiC:H/SiO₂ alternative multilayers prepared by plasma-enhanced chemical vapor deposition. Splitting behavior is also verified experimentally. It has low absorption loss even for the wavelength region around λ = 1.3 μm because the band-gap energy of a-Sic is larger than that of a-Si. The measured splitting angle is 13.8°, which is 2.4 times larger than the 5.7° splitting angle of rutile. The absorption loss of the multilayer is reduced to 1 × 10^-3 dB/μm at λ = 1.3 μm. The magnitude of the residual stress is 9.45 × 10⁸ dyn/cm², which is about one-third of that prepared by the rf bias sputtering equipment which is used for another project of our group. The deposition rate of SiO₂, is increased to 135 nm/min, which is 27 times larger than that prepared by the sputtering equipment.     

Effect of Mixing Time on the Lubricating Properties of Magnesium Stearate and the Final Characteristics of the Compressed Tablets

The effect of mixing time on hardness, disintegration time and ejection force in tablettlng of magnesium stearate and lactose granules was studied. The hardness of the tablets decreased with an increase in mixing time of the blends, as previously reported. A semilogarithmic plot of the hardness versus mixing time gave a straight line having a turning point. At the early phase of mixing the hardness was decreasing with a large first-order rate and then continued to decrease with another small first-order rate. The change in disintegration time or ejection force versus mixing time was basically the same as that in the hardness. This type of plot was applicable to the mixing magnesium stearate with not only granular but also powdered materials.     

The influence of catalyst-supporting methods on electrochemical activity and the resultant stability of air electrodes activated with iron phthalocyanine

To improve the performance of air electrodes, the dependence of iron phthalocyanine (FePc) catalytic effects on preparation methods was examined. The methods used were mixture (Electrode 1), impregnation (Electrode 2) and direct synthesis (Electrode 3). Electrodes 2 and 3 showed higher potentials during cathodic polarization up to 10 mA cm^–2 than Electrode 1. The rate of chemical destruction of H₂O₂ decreased in the order Electrode 3 > Electrode 2 > Electrode 1. Electrode 3 showed the smallest potential drop for a discharge at 10 mA cm^–2, 0.09 V after 50 h. However, the potential of Electrode 2 decreased with discharge, becoming 0.09 V lower than that of Electrode 3 after a 50 h discharge at 10mA cm^–2. Once the potential drop occurred, the potential was not recovered by resting or by drying the electrode. The potential drop may be caused by deactivation of FePc. One possible reason for such deactivation is the presence of H₂SO₄, which remained on the electrode after impregnation of the FePc-H₂SO₄ solution.     

Adaptive optics instrumentation in submillimeter/terahertz spectroscopy with a flexible polyvinylidene fluoride cladding hollow waveguide

A simple instrument has been developed to carry out temperature dependent submillimeter/terahertz-wave spectroscopy using a polyvinylidene fluoride flexible hollow waveguide and an eggplant-shape launching lens.     

Preparation of Pb(Zr,Ti)03 Through the Use of Cupferron

An organic chelation reagent, cupferron, was used to coprecipitate Ti⁴⁺ andZr⁴⁺. After the materials were fired, they were mixed with PbO powder and fired again at high temperatures to obtain Pb(Zr,Ti)0₃ (PZT). It was confirmed that this method is useful for the preparation of homogeneous PZT having no compositional fluctuations. No coexistence range of the tetragonal and rhombohedral phases was observed in the PZT compositions near the morphotropic phase boundary.