A CMOS multichannel 10-Gb/s transceiver

We describe a CMOS multichannel transceiver that transmits and receives 10 Gb/s per channel over balanced copper media. The transceiver consists of two identical 10-Gb/s modules. Each module operates off a single 1.2-V supply and has a single 5-GHz phase-locked loop to supply a reference clock to two transmitter (Tx) channels and two receiver (Rx) channels. To track the input-signal phase, the Rx channel has a clock recovery unit (CRU), which uses a phase-interpolator-based timing generator and digital loop filter. The CRU can adjust the recovered clock phase with a resolution of 1.56 ps. Two sets of two-channel transceiver units were fabricated in 0.11-/spl mu/m CMOS on a single test chip. The transceiver unit size was 1.6 mm /spl times/ 2.6 mm. The Rx sensitivity was 120-mVp-p differential with a 70-ps phase margin for a common-mode voltage ranging from 0.6 to 1.0 V. The evaluated jitter tolerance curve met the OC-192 specification.     

Breakdown characteristics of oil and paper insulation for a very fast transient voltage

This paper describes the dielectric breakdown characteristics of oil and oil‐impregnated paper for very fast transient (VFT) voltages. Blumlein circuits generate VFT voltages of 60 and 300 ns in a pulse width that simulates disconnecting switching surges in gas‐insulated switch gears. We measured the breakdown voltages of needle‐to‐plane, plane‐to‐plane oil gaps and several pieces of paper between plane electrodes for VFT and lightning impulse voltages. The measured data were formulated in V‐t characteristics and Weibull probability distributions. The inclination n of V‐t characteristics of insulating paper is 150, which is less than n = 13.7 of the plane‐to‐plane oil gap in the VFT time range. The shape parameters of Weibull distribution obtained in this study show that the scattering of breakdown voltages of paper is much less than that of oil. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(4): 16–24, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10043     

Fast Full-Band Device Simulator for Wurtzite and Zincblende GaN MESFET Using a Cellular Monte Carlo Method

A fast full-band device simulator for wurtzite and zincblende GaN using a Cellular Monte Carlo (CMC) approach is reported for wurtzite and zincblende GaN. The full-phonon dispersion relationship including anisotropic polar-optical phonon scattering is taken into account for the wurtzite GaN calculation. In the bulk simulation, the CMC model is about 30–100 times faster than the conventional Ensemble Monte Carlo model at high electric field region. This CMC model is applied to the simulator of MESFET devices, and the calculation speed is significantly improved.     

KGa-priderite and related compound for the selective reduction of nitrogen monoxide with propylene

The catalytic activity of KGa-priderite, K_1.6Ga_1.6Ti_6.4O₁₆, and its related compound KGa₈Ga₉Ti₁₅O₅₆ was investigated for the selective reduction of nitrogen monoxide (NO) with propylene (C₃H₆) in the presence of high oxygen concentrations. The KGa-priderite showed significant activity during this reaction, but the related compound showed only a little activity. These compounds are quite different from the conventional catalysts for NO_x selective reduction and are characterized by the fact that their properties are free from the effects of solid acidity and support metals. This difference was attributable to the NO desorption rate at the surface of these compounds. It has become clear that the KGa-priderite catalyst remarkably adsorbed NO, and it is suggested that the amount of NO adsorbed and the amount of catalytic activity are able to be increased by the design of priderite structure.     

Physical and functional association of cortactin with Syk in human leukemic cell line K562

Human leukemic cell line K562 is induced to differentiate into the megakaryocytic lineage by stimulation with 12-O-tetradecanoylphorbol-13-acetate (TPA). We demonstrate here that TPA stimulation increases tyrosine phosphorylation of an 80-kDa protein at an early stage of megakaryocytic differentiation and that this 80-kDa protein is identical with cortactin. Since tyrosine kinase Syk was activated by TPA stimulation, we examined the possibility that cortactin is a potential substrate of Syk in K562 cells. TPA-induced tyrosine phosphorylation of cortactin was decreased profoundly by overexpression of dominant-negative Syk. Furthermore, cortactin was associated with Syk even before TPA stimulation. Since cortactin was previously referred as an 80/85-kilodalton pp60src substrate, we examined the association between Src and cortactin, whereas its association could not be detected. These data suggest that Syk phosphorylates cortactin in K562 cells upon TPA treatment.     

A broadband power meter calibration system in the frequency rangefrom 10 MHz to 40 GHz using a coaxial calorimeter

A broadband power meter calibration system based on a newly constructed coaxial calorimeter has been developed in the frequency region 10 MHz-40 GHz. The RF power is measured as the difference of DC power supplied to the calorimeter built-in heater in the RF load, when RF is turned off and on, holding an isothermal control between the RF load and a temperature reference. To minimize the error due to the adiabatic coaxial waveguide, we devised a new method utilizing its output port as a test port. The evaluations showed a calibration uncertainty of (0.28-2.2)% expressed by one standard deviation at the 1 mW level in the full band     

Effect of functional group of ferrocene redox substance on the transport properties of newly designed ion exchange membrane prepared from polymer gel

A different newly designed cationic exchange polymer membrane and anionic exchange polymer membrane were introduced, and also the transport properties of these polymeric membranes were investigated in this study. The transport properties of these polymer membranes in contact with ferrocene redox derivatives were estimated by using electrochemical techniques such as cyclicvoltammetry, chronopotentiometry, and chronoamperometry techniques, respectively. The used ferrocene redox substances, which have different functional groups, were (Ferrocenylmethyl) trimethylamonium iodide, FcMA, Ferrocenedimethanol, FcDM, and Ferrocene carboxylic acid, FcCA. It indicated that the performance of a membrane depended on the content of polymer gel, anionic exchange polymer site (20 wt % and 50 wt %) or cationic polymer exchange site (20 wt % and 50 wt %), and the efficiency of the functional groups of cationic and anionic exchange polymer site as well. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

Virtual Fiber Configuration for Dynamic Lightpath Establishment in Large-scaled Optical Networks

Recently, progress has been made in the Generalized Multi-Protocol Label Switching (GMPLS) and Automatic Switched Optical Networks (ASON) standardizations. These technologies realize construction of large-scaled optical networks, interconnections among single-domain Wavelength Division Multiplexing (WDM) networks, and direct communication over multi-domain WDM networks. Meanwhile, it is known that the topology of the Internet exhibits the power-law attribute. Since the topology of the Internet, which is constructed by interconnecting ASs, exhibits the power-law, there is a possibility that large-scale WDM networks, which are constructed by interconnecting WDM networks, will also exhibit the power-law attribute. One of the structural properties of a topology that adheres to the power-law is that most nodes have just a few links, although some have a tremendous number of them. Another property is that the average distance between nodes is smaller than in a mesh-like network. A natural question is how such a structural property performs in WDM networks. In this paper, we first investigate the property of the power-law attribute of physical topologies for WDM networks. We compare the performance of WDM networks with mesh-like and power-law topologies, and show that links connected to high-degree nodes are bottlenecks in power-law topologies. To relax this, we introduce a concept of virtual fiber, which consists of two or more fibers, and propose its configuration method to utilize wavelength resources more effectively. We compare performances of power-law networks with and without our method by computer simulations. The results show that our method reduces the blocking probabilities by more than one order of magnitude.