Fatigue of Kaowool reinforced aluminum: Effect of shot particle wall thickness

The fatigue performance of Kaowool fiber reinforced 339 aluminum composites at 300°C is limited by spherical thin walled hollow Kaowool shot particles. These act as crack initiation sites particularly when located at the surface. This problem does not occur for thick walled particles or particles filled with the aluminum matrix. The effect of wall thickness (t) is evaluated from finite element analysis of both 2D and 3D models, with and without plasticity. Both models predict that hollow thin walled particles act as defects, while thick walled particles act as reinforcements, this transition being defined by a critical wall thickness (t _c). The 3D model is preferred in that it predicts more accurate and smaller values of t _c. Specifically, the 3D elastic/plastic model predicts that the largest stress concentration occurs for a fractional surface particle and that in this condition t _c = 0.18a, where a is the particle radius. This value agrees with our experimental observation that particles with t > 0.2a do not initiate failures.     

A methodology for assessing gamebird use of short rotation coppice

Gamebirds provide a considerable incentive to plant and manage new woodlands. The supplementary income thus generated can improve their overall value. Other studies suggest that Short Rotation Coppice (SRC) crops may provide an attractive habitat for some gamebird species and could increase the value of the crop. To investigate this, the use by pheasants and partridge of different types of SRC at one site was assessed.

A method using sand quadrats to record gamebird footprints and hence relative use was developed. Pheasant footprints were recorded more frequently in the quadrats alongside the willow coppice, whereas partridge footprints occurred more frequently alongside the poplar coppice. Footprint analysis offers a reliable method of investigating how gamebirds use different types of SRC within small areas. The results are considered in terms of the placement of short rotation coppice plantations in the landscape to improve their ecological design.     

High dynamic range temperature point sensor using greenfluorescence intensity ratio in erbium-doped silica fiber

We propose a sensor based on the temperature dependant behavior of the two lines of green emission of the erbium ion. The ratio of the intensities of these two lines presents a very low dependance on pump wavelength and pump power fluctuations. The sensitivity of the ratio is 0.013/°C between room temperature and 600°C. In addition, the measurement is self-calibrated     

Wave-front curvature as a cause of slow conduction and block in isolated cardiac muscle

We have investigated the role of wave-front curvature on propagation by following the wave front that was diffracted through a narrow isthmus created in a two-dimensional ionic model (Luo-Rudy) of ventricular muscle and in a thin (0.5-mm) sheet of sheep ventricular epicardial muscle. The electrical activity in the experimental preparations was imaged by using a high-resolution video camera that monitored the changes in fluorescence of the potentiometric dye di-4-ANEPPS on the surface of the tissue. Isthmuses were created both parallel and perpendicular to the fiber orientation. In both numerical and biological experiments, when a planar wave front reached the isthmus, it was diffracted to an elliptical wave front whose pronounced curvature was very similar to that of a wave front initiated by point stimulation. In addition, the velocity of propagation was reduced in relation to that of the original planar wave. Furthermore, as shown by the numerical results, wave-front curvature changed as a function of the distance from the isthmus. Such changes in local curvature were accompanied by corresponding changes in velocity of propagation. In the model, the critical isthmus width was 200 microns for longitudinal propagation and 600 microns for transverse propagation of a single planar wave initiated proximal to the isthmus. In the experiments, propagation depended on the width of the isthmus for a fixed stimulation frequency. Propagation through an isthmus of fixed width was rate dependent both along and across fibers. Thus, the critical isthmus width for propagation was estimated in both directions for different frequencies of stimulation. In the longitudinal direction, for cycle lengths between 200 and 500 milliseconds, the critical width was < 1 mm; for 150 milliseconds, it was estimated to be between 1.3 and 2 mm; and for the maximum frequency of stimulation (117 +/- 15 milliseconds), it was > 2.5 mm. In the transverse direction, critical width was between 1.78 and 2.32 mm for a basic cycle length of 200 milliseconds. It increased to values between 2.46 and 3.53 mm for a basic cycle length of 150 milliseconds. The overall results demonstrate that the curvature of the wave front plays an important role in propagation in two-dimensional cardiac muscle and that changes in curvature may cause slow conduction or block.     

Estimation subject to block censoring

A series system comprises n components arranged in decreasing order of likelihood of failure. The components are grouped into modules and, on system failure, the modules are replaced in sequence until the system is repaired. Thus, it is not known which component has failed, only which module contains the failed component. It is shown how, for a certain class of life-length distributions, prior information on the relative propensities of the components to fail can be incorporated to estimate the parameters of the life-length distributions of the components. The case where each component life-length is exponentially distributed is studied in detail     

Laparoscopic vs. open wedge biopsy of the liver

The number of people smoking free-base cocaine, or "crack," has increased dramatically in recent years. Concomitantly, the literature describing complications of such use has grown as well. Adverse pulmonary effects are being increasingly noted, such as respiratory symptoms, pulmonary hemorrhage, pulmonary edema, asthma, and pulmonary barotrauma. These and other pulmonary effects are reviewed.     

Mode matching for a passive resonant ring laser gyroscope

An analytical method of matching the mode of an input laser to the lowest-order mode of a passive resonant ring laser gyro is described, as are the steps in determining the location and focal length of cylindrical mode matching lenses. Results were obtained with no mode matching, with a compromise spherical lens, with horizontal mode matching only, and with the proper cylindrical mode matching lenses. Compared with no mode matching, the latter case shows that the amplitude of the lowest-order mode is increased approximately 2.5 times. In addition, the number and intensity of higher-order modes are reduced to near zero, and the relative intensity of the lowest-order mode to the higher-order mode increased from approximately 5 to approximately 60 times greater.     

Experimental Study on the Aging of Sands

Aging effects in sand, such as increases in cone penetration resistance with time after deposition and/or densification, are known to occur in the field, but the causes of these effects are not fully understood. A laboratory testing program was designed to study mechanisms responsible for aging effects under controlled conditions. The testing program included measurements of the small strain shear modulus, electrical conductivity, pore fluid chemistry, and minicone penetration resistance after different periods of aging. Two different sands were tested, and aging effects were evaluated for different combinations of relative density, temperature, and pore fluid composition. Increases in the small strain shear modulus were observed throughout most of the tests, and chemical analyses suggest that precipitation of carbonate and silica occurred in two tests. Despite these changes, there was no corresponding increase in the minicone penetration resistance with time in any of the tests. It is unlikely that precipitation of carbonate or silica is responsible for aging effects in sands; other possible mechanisms include arching due to dissipation of blast gases and redistribution of stresses through the soil skeleton. An additional possibility is that the boundary conditions imposed by the laboratory tests obscure changes in penetration resistance that would be measured had the volume of sand tested been much larger. The implications of these findings in terms of other published field and laboratory studies are discussed.