Increased hydroxyl concentration by tungsten oxide modified h-BN promoted catalytic performance in partial oxidation of methane

Hexagonal boron nitride (h-BN) as a layered inorganic nonmetallic material has been widely used. Hydrogen peroxide (H₂O₂) modification can trigger exfoliation and afford abundant B–OH active sites at edge of h-BN, which can enhance methane activation ability. Introducing tungsten oxide (WO₃) to h-BN produces a similar effect, because doping WO₃ into h-BN resulted in electron transfer to N, inducing fracture of B–N bond, resulting in N vacancy (triboron center), exposing more B sites and promoting the generation of B–OH. Significantly, the introduction of WO₃ on the modified h-BN dramatically increased the concentration of B–OH compared with the unmodified h-BN, because H₂O₂ modification weakened B–N bond. By means of XRD, TEM, XPS,EPR, FT-IR, it is proved that the high concentration of B–OH active sites contributed to activating C–H bond, thus methane conversion and CO and H₂ selectivity were significantly improved.     

Flexural behaviour of RC slabs strengthened with prestressed CFRP strips using different anchorage systems

The Externally Bonded Reinforcement (EBR) technique using Carbon Fiber-Reinforced Polymers (CFRP) has been commonly used to strengthen concrete structures in flexure. The use of prestressed CFRP material offers several advantages well-reported in the literature. Regardless of such as benefits, several studies on different topics are missing. The present work intends to contribute to the knowledge of two commercially available systems that differ on the type of anchorage: (i) the Mechanical Anchorage (MA), and (ii) the Gradient Anchorage (GA). For that purpose, an experimental program was carried out with twelve slabs monotonically tested under displacement control up to failure by using a four-point bending test configuration. The effect of type of anchorage system (MA and GA), prestrain level (0 and 0.4%), width (50 mm and 80 mm) and thickness (1.2 mm and 1.4 mm) of the CFRP laminate, and the surface preparation (grinded and sandblasted) on the flexural response were the main studied parameters. Better performance was observed for the slabs: (i) with prestressed laminates, (ii) for the MA system, and (iii) with sandblasted surface preparation.     

Performance evaluation of noise reduction method during on-line monitoring of MV switchgear for PD measurements by non-intrusive sensors

Partial Discharge (PD) measurement is a globally accepted method for insulation diagnosis of electrical assets. The consequences of insulation breakdown are well known. The trend is to move from conventional offline testing to online monitoring for insulation life prediction, which results in the inclusion of high frequency noise in the captured signals. Therefore de-noising is of paramount importance in online monitoring to obtain useful information from the signal.In this research, a 20 kV switchgear panel has been subjected to PD faults in the laboratory and measurements have been carried out by using different non-intrusive sensors including a novel sensor, the D-dot sensor and recorded by a high frequency oscilloscope. The measured results show the effective applicability of sensors for switchgear. The Discrete Wavelet Transform (DWT) has been used to de-noise PD signals in this paper. Time domain and frequency domain comparison of original and de-noised PD signals reveals the significance of this technique for online monitoring of Medium Voltage (MV) switchgear. Finally, an adaptive online de-noising concept, based on automatic de-noising is also proposed in this paper.     

Application of Vis–NIR hyperspectral imaging in classification between fresh and frozen-thawed pork Longissimus Dorsi muscles

Fresh and frozen-thawed (F-T) pork meats were classified by Vis–NIR hyperspectral imaging. Eight optimal wavelengths (624, 673, 460, 588, 583, 448, 552 and 609 nm) were selected by successive projections algorithm (SPA). The first three principal components (PCs) obtained by principal component analysis (PCA) accounted for over 99.98% of variance. Gray-level-gradient co-occurrence matrix (GLGCM) was applied to extract 45 textural features from the PC images. The correct classification rate (CCR) was employed to evaluate the performance of the partial least squares-discriminate analysis (PLS-DA) models, by using (A) the reflected spectra at full wavelengths and (B) those at the optimal wavelengths, (C) the extracted textures based on the PC images, and (D) the fused variables combining spectra at the optimal wavelengths and textures. The results showed that the best CCR of 97.73% was achieved by applying (D), confirming the high potential of textures for fresh and F-T meat discrimination.     

预应力多跨混凝土连续板桥在老龙口水利枢纽中的应用评价

文章就预应力多跨混凝土连续板桥在老龙口水利枢纽中的实际应用,通过对河道平槽流量的推求和建桥后桥址处河道过流能力的计算分析,确认该结构形式对河道过平槽流量无大影响。     

A closed loop exponential feeding law: Invariance and global stability analysis

This article addresses the computation of invariant control laws [A. Fradkov, I. Miroshnik, V. Nikiforov, Nonlinear and Adaptive Control of Complex Systems, Kluwer, 1999] for fed-batch fermenters represented by two standard models. It will be shown how to derive partial state feedbacks that, assuming ideal conditions and perfect model, keep the specific growth rate μ constant provided the initial conditions are adequate. The invariant control law is the closed loop version of the exponential feeding already suggested in several references as shown later. The paper presents an analysis of invariance and a study of global stability within the framework of partial stability. That is, stability with respect to some of the state variables. This enables us to treat the case with Haldane-like or non-monotonous kinetics.     

有粘结预应力在252m地下室顶板中的应用

在总长度 2 5 2m的超长不设缝地下室顶板中 ,采用了预应力、设置后浇带等综合抗裂技术 ,并对有粘结预应力平板的设计理论、施工工艺、锚固体系及超长结构预应力损失控制和抗裂控制作了深入研究。     

Hydrogen production in solid electrolyte membrane reactors (SEMRs)

In the present work, the prospects and trends of solid electrolyte membrane reactors (SEMRs) towards hydrogen production, are discussed. Initially, an overview of the principles, the properties and the techniques related to the usage of the SEMRs, are presented. In the following, a literature survey covering earlier and recent developments of the various methods (e.g. reforming or partial oxidation or dehydrogenation of hydrocarbons, steam electrolysis) employed in the SEMRs for the production of hydrogen, is performed. Finally, the current status of this research field is analyzed and future research topics are proposed.     

南京老虎山黄土-古土壤剖面不同粒级组分的磁化率及其古气候意义

利用沉降离心法将老虎山黄土-古土壤的酸不溶相分离成<2μm、2～45μm和>45μm三个粒级组分,并分别测定了这些组分和全岩的磁化率。结果表明,无论是全岩,还是三个不同粒级组分,它们的磁化率都可以单独作为长江中下游地区古气候演变的参考指标。其中,<2μm粒级的质量磁化率明显大于全岩和2～45μm、>45μm两粒级,而且其分辨率也明显高于2～45μm和>45μm这两个粒级组分。本实验结果还显示,虽然<2μum的质量磁化率最大,但对全岩质量磁化率的贡献率与2～45μm粒级相当,>45μm粒级的贡献率较低。     

Catalytic behavior of YBa2Cu3O7-x in the partial oxidation of methanol to formaldehyde

The partial oxidation of methanol to formaldehyde was studied over YBa₂Cu₃O_7-x catalyst in a flow reactor. The structural change of YBa₂Cu₃O_7-x before and after the reaction was measured by means of XRD and iodometric titration method. The catalytic characteristics of YBa₂Cu₃O_7-x for the partial oxidation of methanol to formaldehyde was due to copper ions. It was found that Cu⁺² was responsible for the higher selectivity for formaldehyde.